Operating system limits can reduce the maximum possible log size.
操作系统限制可能会减少日志的最大可能大小。
You can estimate transaction log size based on database operations.
您可以估计基于数据库操作的事务日志的大小。
To avoid this situation, consider increasing the log size to 20-30 MB and retaining a number of old logs.
为了避免这种情况，考虑将日志大小增加到20 - 30MB并保留大量旧日志。
The collector gives the options to increase the log size and number of history log files, as shown in Figure 15.
收集器会给与增加日志大小和历史日志文件数量的选项，如图15所示。
Each node contains an engine throttling component which monitors the node health, log sizes, log write duration, CPU usage, and database size limits.
每个节点都包含有引擎流量调节组件，它会监控节点的健康状况、日志大小、日志写入时间、CPU使用量以及数据库大小限制。
The size of these log files is determined by the LOGFILSIZ database configuration parameter.
而这些日志文件的大小是由数据库配置参数LOGFILSIZ决定的。
The size (number of pages) of each primary log has a direct bearing on database performance.
每个主日志的大小(页数量)对数据库性能有直接影响。
Increase the size of the log buffer area if there is considerable read activity on a dedicated log disk, or there is high disk utilization.
如果在某个专用的日志磁盘上存在大量的读活动，或者具有较高的磁盘利用率，就增加日志缓冲区域的大小。
When the size of the buffer is set to 0, synchronous log writing occurs, and the audit buffer is not used.
如果将缓冲区大小设置为 0，那么将发生同步写日志操作，而不使用审计缓冲区。
The LOGFILSIZ database configuration parameter specifies the size of secondary log files.
数据库配置参数LOGFILSIZ 则指定了次日志文件的大小。
Increase the log buffer size to 256 pages or larger.
将日志缓冲区大小增加到256个页面或更大。
The size of each log file extent is specified on queue manager creation and cannot be changed subsequently so it is important to get this right when first defining the queue manager.
每个日志文件扩展的大小在队列管理器创建时指定，以后不能更改，因此务必在首次定义队列管理器时就正确设置此参数。
The default size of the log buffer (LOGBUFSZ) below is normally too small for database systems with many update workloads.
对于具有许多更新工作负载的数据库系统而言，下面日志缓冲区的默认大小(LOGBUFSZ)通常都太小。
It contains also the names and paths, file size and block size of log files.
它还包含日志文件的名称和路径、文件大小和块大小。
Note that the size reflected for each log file is mostly pre-allocated space except for some log header control characters.
请注意，反映每个日志文件的大小主要是预先分配的空间，一些日志头控制字符除外。
Increasing the size of the log reduces the number of requests required to allocate and initialize new logs.
增加日志大小会减少为分配和初始化新日志所需的请求数量。
The compressed data is kept both on disk and memory and DB2 also compresses user data stored in log files, thereby reducing log file size.
被压缩的数据同时存放在磁盘上和内存中，DB2还压缩存储在日志文件中的用户数据，以便减少日志文件大小。
But the small buffer size makes it unsuitable for larger quantities of log information, and the logged information isn't stored to disk so it's hard to analyze over a period of time.
但是缓冲区尺寸小造成它不适合更大数量的日志信息，而且记录的信息不能保存到磁盘也使得难以分析一段时间内的性能。
The most important of these values are the maximum size for writing to a log extent and the location of the log.
这些值中最重要的值是写到日志扩展块的最大的大小和日志的位置。
When the database is initialized, the system allocates a certain number of primary log files of a specified size in the active log directory.
当初始化数据库时，系统会在活动日志目录中分配一定数量、指定大小的主日志文件。
As you select the number of logs to configure, you must consider the size you make each log and whether your application can handle a log-full condition.
当选择要配置的日志数量时，必须考虑您生成的每个日志的大小，以及您的应用程序是否能处理“日志满”情况。
Due to the large amount of data in the audit log table, a single INSERT statement will usually fail because the data per transaction exceeds the log file size of the database system.
因为审核日志表格里有大量的数据，单独的insert语句通常会失败，这是因为每个事务的数据超过了数据库系统里的日志文件的容量。
The database configuration parameter that defines the size of the log buffer is called LOGBUFSZ.
定义日志缓冲区大小的数据库配置参数为LOGBUFSZ。
These log files grow in size over time, so you should not leave this setting enabled for long periods or you could consume all available drive space.
这些日志文件随着时间会不断增大，所以不应该长时间启用该设置，否则会消耗掉所有可用的设备空间。
A small database log file size can run out of log space and cause the redistribution to fail.
如果数据库日志文件比较小，则会很快用完日志空间，并导致重分发失败。
This created an XML document 3.18 times the size of the underlying line-oriented log.
这创建了是基本面向行日志的 3.18倍大小的XML文档。
There are numerous log and audit files that keep growing in size and there is a need to manage them so that they don't grow to eat up the critical space on the servers.
服务器有许多不断增长的日志和审计文件，需要管理它们，防止它们耗尽服务器上的重要空间。
An auto-generated install log shows the name, date, and size of all installed files as well as any change made to the Notes.ini file during installation.
自动生成的安装日志显示了所有安装文件的名称、日期和大小，也显示了在安装期间对Notes . ini文件所做的任何更改。
These rules enable you to finely tune what can and cannot be logged with the mechanism — which, on a high-volume, hard-working server can translate to log files of a manageable size.
这些规则使您可以很好地调整使用该机制记录的内容 ——在一台高容量而且工作繁重的服务器上使用 syslog 机制可以转换为可改变大小的日志文件。
If you wish to change the size of the log buffer for the queue manager you will need to change the value in the queue manager qm.ini file.
如果您希望更改队列管理器的日志缓冲区大小，将需要在队列管理器qm . ini文件中更改此值。
应用推荐