The main effect affected by material feature is lateral displacement, then the loading height and slant Angle.
横向位移受物料形态影响最大，其次是装料高度和斜面倾角。
This paper expounds the selection of the catalyst of the. synthetic reaction of dimethyl sulfide and the calculation of the loading height of the catalyst in the reactor.
阐述了二甲基硫醚合成反应所用催化剂的选择和反应器中催化剂装填高度的计算。
Objective. To understand how height patterns (loss and gain) at AD and PD affects the PF contact loading during moderate and severe grades of cervical disc degeneration (DD).
目的：理解在中、重度分级的颈椎间盘退变(DD)过程中，AD和PD高度变化(丢失和增加)如何影响PF连接负荷。
The materials of tube for loading particles and the load height have less effect on the apparent mass burning rate.
装填药粒用的壳体材料和药粒装填高度对传火速度的影响不显著。
In canonical variables the height and long jump were the maximum loading variables.
典型变量中，身高和立定跳远的载荷最大。
All the factors, such as height, COD loading, hydraulic loading and the frequency of leachate dosing, to a certain extent, affected the purification ability.
煤灰和土壤高度、有机负荷、水力负荷及配水次数等因素均对净化能力有一定的影响。
The affection of parameter variation of down lead wires and top loading wires on effective height, radiation pattern, input reactance, radiation resistor and static capacitance is discussed.
同时研究了引线及顶线的各项参数变化对天线的有效高度、增益、输入电抗、辐射电阻及静电容的影响。
The limited height of the loaded railway freight cars' gravity center is an important standard in the loading and fastening rules of railway freight.
重车重心限制高度是铁路货运装载加固规则中的一项重要标准。
This paper discusses coal cutting drum, coal loading, maximum coal cutting height, low coal seam conveyor and how the low coal seams restrict the use of coal shearers.
分析介绍了滚筒装煤、最大采煤高度、薄煤层输送机、薄煤层对采煤机的要求等问题。
Position, loading and pivot of material in addition to base plane size of material and space height.
材料位置、材料荷载大小及支点、材料基础平面尺寸、空间高度；
Their relationships between instability of stacked layer and its span, height, and loading are studied respectively.
并研究了三种失稳与砌体梁的跨距、高度及其承受载荷的关系。
This paper deduces the new maximum height formula of loading on soft clay ground by the method of plasticity limit analysis.
对软土地基堆载极限高度进行了塑性极限分析，得出了计算公式。
The major reason of resistant to loading of Shennong 606. is the stronger stem under the condition that the difference of all varieties plant height were not obvious.
在株高相差不大的情况下，茎秆粗壮是沈农606抗倒伏的主要原因。
This paper points out that the kinetic energy factor-hydrops height method can be applied to diagnose the accurate situation of the bottom hole liquid loading.
文中提出应用动能因子-积液高度法来诊断气井井底积液情况。
The calculated strength could show the affection caused by transverse shear effect and the affection had only relation to the loading value and no to the ratio of span-height.
预测的强度能够反映出横向剪切效应的影响，其影响只与载荷大小有关，而与跨高比无关；
Study on the buckling mode and ultimate(bearing) capacity is made under different conditions such as height-span-ration, loading and boundary condition.
分别讨论了在不同矢跨比、不同荷载作用、不同边界条件下组合肋壳的极限承载力和失稳形态。
Both the RC beams with cracks filled under loading and general RC beams have some maximal crack heigh about 0.7 ~ 0.8 times the test beam height.
持荷封闭裂缝梁与普通钢筋混凝土梁一样，都存在着止裂高度，即裂缝高度基本都稳定在梁高的0.7倍0.8倍。
CTR 980 Fully auto quad sites test Reel handler 1. Dimension: width*depth*height: 1100*1100*1920(mm) 2. Material loading: tube auto loading 3. Test site: 4 in parallel finger or PTB(socket) 4.
CTR980全自动四测位测编一体机1。尺寸：宽×深×高： 1100×1100×1920毫米2。添料方式：料管自动进料3。测试位：4个并联金手指或测试座 4。视觉检查：字体、方向；
CTR 980 Fully auto quad sites test Reel handler 1. Dimension: width*depth*height: 1100*1100*1920(mm) 2. Material loading: tube auto loading 3. Test site: 4 in parallel finger or PTB(socket) 4.
CTR980全自动四测位测编一体机1。尺寸：宽×深×高： 1100×1100×1920毫米2。添料方式：料管自动进料3。测试位：4个并联金手指或测试座 4。视觉检查：字体、方向；
应用推荐