Analyzing all kinds of the calculating methods for critical load of the structure stability by using the energy method.
分析了基于能量法的结构稳定临界荷载计算的各种方法。
The paper introduces a method for calculating the heating load of initial station or heating station of hot oil pipeline, and gives proof to it.
为此，介绍了一种热油管道首站或加热站加热负荷的计算方法，以合理确定管道首站和中间站的热负荷。
This paper has investigated air hydrostatic bearings with high load carrying capacity and given experimental and calculating results. Traditional method is modified in design and calculation.
本文对具有高承载能力的空气静压轴颈轴承进行了研究，给出了实验和计算结果。在设计计算上，对传统的计算方法做了修正。
This paper introduces a simlpe calculating method, of evaluating any section internal force of circular bent rod effected by even load.
本文介绍了一种求圆弧形曲杆在均布荷载作用下任意截面内力的简化计算方法—等效直杆法。
The paper puts forward a kind of calculating method for displacement, internal force and interaction of high-rise frame-shear wall structure under lateral load by using continuity method.
提出一种采用连续化方法对高层框架—剪力墙结构在侧向荷载作用下的位移、内力及相互作用的计算方法。
The state variables analysing method and interrelation analysing method are combined effectively in calculating the sustained steady state dynamic performance of REPMSM under periodical load.
本文将在周期性负载下稀土永磁同步电动机持续稳态的动态特性的状态变量法与相关技术这两种现代分析方法有机地结合在一起。
The unit load method is a simple, easy and practical calculating method which differs from the complicated traditional ones.
单位载荷法是一种简单、直观、实用的钩针变形计算法，它有别于复杂的传统计算法。
Using an empirical cumulative plastic strain formula, a method for calculating the traffic load induced deformation was proposed.
针对交通荷载作用下软土地基的变形问题，采用累积应变的经验公式计算其累积沉降。
The model and calculating method for determining the out-plane load of paper honeycomb were established based on the ring crush strength of paper.
通过对纸蜂窝结构特性和压缩破坏机理的分析，建立以原纸环压强度为控制的纸蜂窝结构面外载荷理论模型和临界载荷计算方法。
The explicit method for calculating surges in throttled surge tank and simple tank following load rejection has been derived by use of Thaler Series Expansion from the basic formulation of surge tank.
本文从调压室的基本微分方程出发，采用泰勒级数展开式推导了阻抗式和简单式调压室甩荷时水位波动的显式计算方法。
Based on the rolling feature and practice of reversible cold mill, a new calculating method to determine the load distribution is put forward by means of nonlinear equations.
根据可逆冷轧机的生产特点，采用一种通过直接求解非线性方程组来确定负荷分配的方法。
The equation for calculating the lateral buckling critical load by using the energy method is deduced, and an approximate solution is given.
推导了用能量法计算侧向屈曲临界载荷的计算式，并给出了近似解。
Determining principle and calculating method of the load of greenhouse roof are particularly expounded in the light of the structure of greenhouse and the characteristics of the load.
本文结合温室结构和荷载的特点，具体论述了屋盖荷载的确定原则与计算方法。
A method is proposed for calculating the bed suspended load ratio of transport rate both uniform and non uniform sand in coast sediment movement as well as for calculating that of channel deposition.
提出了海岸泥沙运动中均匀沙和非均匀沙输沙率推悬比和航道淤积推悬比的计算方法。
This paper introduces the method using program for calculating the measure and payment in the international load project Shen-Ben highway.
本文介绍编程计算国际贷款项目中的计量与支付的方法。
In this article, the calculating power load was acquired by using the demanding coefficient method.
本文利用需用系数法计算了一个硬质合金车间的计算负荷。
In this paper, a new method of calculating the heat load of display cases was put forward based on the heat balance analysis of the air in it.
以陈列柜为研究对象，在对其柜内空气进行热平衡分析的基础上，提出了利用风幕进出口的焓差确定陈列柜热负荷的方法。
A practical method is put forward for calculating the ultimate load of the eccentrically compressed RC members heated.
本文的最后部分提出了一种高温下钢筋混凝土压弯构件极限承载力的实用计算模型。
At present, the existing method for calculating coefficients of transverse distribution of load is only appropriate for single span Bridges, and cannot calculate multi-girder Bridges.
针对传统的钢筋混凝土刚架拱桥采用拱索体系加固的要点和措施，提出了计算拱索体系荷载横向分布的弹性支承连续梁法。
This method is used for calculating the fatigue reliability of a structural system, and the relation between load and reliability is described by R-L curve.
应用该方法计算了结构系统的疲劳可靠性，用r - L曲线给出载荷与可靠性的关系。
This paper provides a method to determine the length of vertical U-tube exchanger based on BIN method calculating building load.
本文在利用温度频率法分析建筑冷热负荷的基础上给出了确定垂直U型埋管地下换热器长度的方法。
An approximate formula for calculating the ultimate load on a foundation was derived by using the generalized limit equilibrium method.
应用广义极限平衡法获得了地基极限荷载的近似计算公式。
In this paper, the calculating formula for biaxial load reinforced concrete column with rectangular section and the design method in engineering practice are analyzed.
本文分析了矩形钢筋混凝土柱在双向受压作用下的计算公式以及工程设计中常用的方法。
A detail discussion and a method about the heat load calculating for anti-icing on aircraft windshield are presented. The results of this calculation method agree well with the available foreign data.
对风挡防冰热载荷的计算方法及计算结果进行了较为详细的讨论，提出了一种风挡防冰热载荷的计算方法。
Considering the effects of space behavior and load distribution on the bent, a practical method for calculating the effective length of the bent columns is proposed.
考虑厂房空间作用和排架荷载分布的影响，对排架柱的计算长度提出了实用计算方法。
With the help of plastic hinge theory and collapse theory, the formulas for calculating strength failure load and the method for computing collapse load were established respectively.
分别利用塑性铰理论和压溃理讨论了强度计算问题，提出了强度承载能力计算公式和压溃荷载计算方法。
We study the calculating method and program the calculating software to simulate the exciter flow current on the no-load switching-in of transformer.
对涌流瞬态过程进行了分析，研究计算办法并编制了计算软件，可以对变压器空载合闸时的励磁涌流进行计算模拟。
For quickly and accurately calculating no-load voltage waveform of harmonic excitation synchronous generators and common synchronous generators, a new method, named as tooth flux method, is proposed.
为了快速准确计算谐波励磁同步发电机和普通同步发电机的空载谐波电压，提出一种齿磁通法计算谐波电压。
For quickly and accurately calculating no-load voltage waveform of harmonic excitation synchronous generators and common synchronous generators, a new method, named as tooth flux method, is proposed.
为了快速准确计算谐波励磁同步发电机和普通同步发电机的空载谐波电压，提出一种齿磁通法计算谐波电压。
应用推荐