Design a variety of radial clearance and the contact Angle, to meet different application requirements of load and deflection.
设计有多种径向游隙和接触角，满足不同的应用负荷和偏斜要求。
Dynamic measurement includes dynamic balance, power efficiency and servo load. The servo load is highly influenced by static lead lag Angle.
动态测量包括动态平衡，功效和舵机载荷。舵机载荷对静前沿滞角度后很敏感。
The motor is characterized by reliability, small step-angle, high holding torque, strong ability of driving high rotor inertia load and super structural manufacturability.
其突出的优点是步距角小、驱动惯性负载能力强、自定位力矩大、可靠性高、结构工艺性好。
Because the clamp effect of DC voltage source, AC side output the rectangular wave voltage waveform, and it has nothing to do with the load impedance Angle.
由于直流电压源的钳位作用，交流侧输出电压波形为矩形波，并且与负载阻抗角无关。
A control scheme that trolley and pulley blocks can arrive at the preset positions as soon as possible and swinging Angle caused by wire rope and load inertias can be removed is obtained.
控制模型的目标是建立使小车和滑轮组尽快到达预定位置，并消除钢丝绳和负载由惯性所致摆角的控制方案。
In the condition of gust, in order to restrain additional load and improve the comfort of passenger, the state of Angle of attack is acquired.
在阵风条件下，为了抑制飞机的附加载荷并改善乘坐品质，需要得到飞机的迎角状态。
In this paper a new method for Direct Torque control (DTC) based on load Angle control is developed.
介绍了一种基于负载角控制的直接转矩控制(DTC)新方法。
The profiles are calculated in such a way that, under normal load conditions, life-reducing edge stresses do not occur at a tilting angle of up to 4' between inner ring and outer ring (Table 5.2).
通过这种方式计算的轮廓，在正常的载荷情况下，内外圈之间的偏斜角度超过4＇时不会发生缩减寿命的边缘应力（表5.2）。
The results show that at the same fuel delivery advance angle, engine speed and load, the line peak pressure and rate of pressure increment and decrement of DME are lower than that of diesel fuel.
试验结果表明：在供油提前角、转速和负荷相同的情况下，燃用二甲醚时油管泵端和嘴端压力的上升和下降速度、压力峰值都比燃用柴油时低；
The results showed that the crack initiation Angle and the peak load increased as the distance of the preexisting crack from the midpoint of the beam increased.
结果表明，随着预制裂纹偏离梁中线距离的增加，裂纹的起裂角和峰值荷载都增大。
Influences on the speed and direction of the rotation by the phase Angle of the supply voltage, initial Angle of rotor position, PM line flux and the load torque are discussed.
同时讨论了电源合闸角、转子初始相角、磁链和负载转矩对电机转速和旋转方向的影响。
The results show that opening point, opening angle, maximal tangential stress and critical load vary with aspect ratio and inclined angle. The most dangerous inclined angle is obtained accordingly.
结果表明，开裂点、开裂角、最大切向拉应力和临界载荷随椭圆的纵横轴比和倾角的不同而变化，由此可得到最危险的倾角。
The bearing contact Angle and the roller half taper Angle are two important parameters of a large taper conical roller bearing, they influence the load and life of the bearing.
轴承接触角和滚子半圆锥角是影响轴承载荷和使用寿命的两个重要参数。
The study shows that the stress in tooth middle is larger than that in tooth root with big spiral Angle and light load.
研究表明，大螺旋角或小载荷时，齿腰应力大于齿根应力。
The favorable and unfavorable initial power angle range and the maximum load torque of pulling into step with different initial angle is determined.
确定出牵入同步时较好和较差初始功角的范围，和在不同初始功角下能够牵入同步的最大负载值。
The Angle deflection, buckling stress of insulator, horizontal load and vertical load were recorded. The mechanical failing load test was performed on buckling insulator.
监测了角度偏移、受压复合绝缘子的应力及水平荷载和垂直荷载，并在多次试验后对受压绝缘子进行了机械破坏负荷试验。
The drive motor USES triangular wave drives for Angle control and the load absorption motor USES rectangular movements for torque control.
驱动电机使用三角波驱动器控制角度，负载吸收电机通过矩形运动控制转矩。
There is a larger effect of flow Angle of attack caused by high altitude wind on aerodynamic load and flight environment in rocket flighting.
高空风引起的气流攻角对火箭飞行中的气动载荷和飞行环境有较大的影响。
The relation between load and deformation of the spring element is analysed and the calculating methods of constant angle and maximum axial load are set up.
本文研究了自动调心分离轴承装置的结构和调心原理，分析了弹性元件载荷与变形的关系，给出了分离轴承接触角和极限轴向负荷的确定方法。
The effect of Angle of inclination at the interface of a viscous fluid and thermoelastic micropolar honeycomb solid due to inclined load is investigated.
研究倾斜荷载作用在黏性流体与热弹性微极蜂窝结构固体界面上时，荷载倾斜角的影响。
The crack appears at the edge angle due to stress concentration caused by alternating load, which finally leads to the fissuring of die plate.
凹模在使用过程中，由于交变载荷的作用，使碳化物的棱角处应力集中出现裂纹，最终导致凹模开裂。
The effects of different structural parameters, such as contact Angle, deformation and stiffness and load parameters on bearing mechanical properties were studied.
研究了不同结构参数和载荷参数对滚珠轴承力学特性的影响，得到了滚珠轴承接触角、变形以及接触刚度的变化规律。
Select the part of the batter pile to be load tested, comparative study of the impact of different tilt angle pile in bearing capacity and the law.
选取部分小倾斜桩进行现场载荷试验，对比研究不同倾斜角度对桩承载力的影响及规律。
The transient Angle stability margin and critical clearing time are computed by FASTEST under different proportion of dynamic electric load model using in Henan Power Grid.
以河南电网为例，采用暂态安全定量分析软件FASTEST计算了不同动态负荷模型比例时的暂态功角稳定裕度和临界切除时间。
The approximate formula for limit load is found when the fraction angle is less than the half conical one.
在摩擦角小于半锥角的情况下，给出了极限承载能力的近似计算公式。
Base on what is mentioned above, the paper recommend the load Angle range of Forsus and scope of condylar reconstruction.
在此基础上给出了Forsus加载角度推荐范围、髁突生长改建范围和第一磨牙远中平移效果的方法。
The rupture Angle in the equivalent thickness of soil layer method is the Angle with no arrangement for the load. But the rupture Angle must change when the vehicle load is arranged.
等代土层厚度法中破裂角为没有施加荷载时的角度，而施加上车辆荷载后破裂角必然发生变化。
The optimum tilted angle is dependent on the site and meteorological data, but independent of the load, array area and battery capacity.
最佳倾角与现场的地理位置及气象条件有关，而与负载大小、太阳电池及蓄电池容量等因素无关。
This paper concludes general calculative regularity of readings of two-wattmeter method using the impedance Angle of balanced load.
本文归纳出利用对称负载的阻抗角，计算二瓦特计法表读数的一般规律。
This paper concludes general calculative regularity of readings of two-wattmeter method using the impedance Angle of balanced load.
本文归纳出利用对称负载的阻抗角，计算二瓦特计法表读数的一般规律。
应用推荐