The chip level linear minimum mean square error (LMMSE) equalizer in CDMA systems is introduced.
介绍了码分多址CD MA系统中码片级线性最小均方误差均衡器。
If applied voltage is below a limit, the V-A curve of both glass and polymer chip is linear, then its electrical model can be simplified as a resistance model.
在一定的电压范围内，玻璃和有机玻璃芯片的伏安特性都有线性段区域，因此在此线性段内研究芯片的电特性可以将其简化为电阻模型。
Rotary cutting it to the chip or equal to the width of the linear cutting chip thickness.
它等于旋削中的切屑宽度或者等于线性切削中的切屑的厚度。
This article designs the linear electric charge pump constant voltage chip mainly applies in 5.1V low pressure electric power supply.
本文所设计的线性电荷泵稳压芯片主要应用于5.1V的低压供电电源。
The influence of depth of grinding, feed rate and circular linear speed of the grinding wheel on the grinding forces with respect to the maximum chip thickness of a single active diamond was analyzed.
从单颗金刚石最大切削厚度的角度，分析了磨削深度、进给速度和砂轮线速度对磨削力的影响。
This system includes two parts of hardware and software. The hardware is composed of linear CCD scan-ning circuit and sing le-chip computer system.
该系统由硬件和软件两部分组成，硬件部分主要由线性CCD扫描电路和单片机系统组成。
This paper sets up an instantaneous cutting force model for a spiral cylinder cutter by analyzing the linear relationship between micro-unit milling force and instantaneous uncut chip thickness.
应用微分几何理论，给出了圆锥螺旋铣刀几何特性，据此导出了三维非线性铣削力模型，继而采用非线性规划识别切削力系数。
This paper sets up an instantaneous cutting force model for a spiral cylinder cutter by analyzing the linear relationship between micro-unit milling force and instantaneous uncut chip thickness.
应用微分几何理论，给出了圆锥螺旋铣刀几何特性，据此导出了三维非线性铣削力模型，继而采用非线性规划识别切削力系数。
应用推荐