This paper set up limit equation of reliability analysis for factor of safety method in the stability analysis method of slope.
本文针对土坡稳定分析方法中的安全系数法建立了可靠度分析的极限方程。
Our proposed limit analysis approach is conceptually simple: we simply aim to maximize the load factor under the same set of conditions that would apply to a holonomic analysis.
我们提出的极限分析方法是在概念上的简单：我们根本目的是最大限度地利用负荷因素根据同一套条件将适用于一个完整的分析。
Analysis and comparison between the finite element analysis and experiment results for stress concentration factor, limit load, burst pressure and failure location were performed.
从应力集中系数、极限压力、爆破压力和爆破失效位置四个方面对有限元计算结果和试验结果进行对比分析。
Analysis and comparison between the finite element analysis and experiment results for stress intensity factor, limit load, and flexibility factor were performed.
从应力系数、极限载荷和柔度系数三个方面对有限元计算结果和试验结果进行对比分析。
Based on analysis of scaling equations, we found that the measuring range can be changed easily by modifying only two parameters-the scale factor and the lower limit of the range.
通过对标度方程进行分析得知，要改变量程只须改变两个参数——标度因子和量程下限。
The results show by the analysis and comparison, that the Swedish method and un equilibrium thrust method give low limit value with the least stability safety factor.
通过分析比较，说明瑞典法、不平衡推力法都是极小值解，稳定安全系数最小；
Through one example, factor of slope stability computed by limit equilibrium methods and limit analysis methods is more conservative than that computed by FEM based on the shear strength reduction.
通过算例对极限平衡法，极限分析法和强度折减法进行比较，说明前两种方法计算结果过大。
Through one example, factor of slope stability computed by limit equilibrium methods and limit analysis methods is more conservative than that computed by FEM based on the shear strength reduction.
通过算例对极限平衡法，极限分析法和强度折减法进行比较，说明前两种方法计算结果过大。
应用推荐