LCD modules with a full scale reading at 200mv.
液晶显示模块与全面读200mV。
At the same time, we also produce sections of standard LCD modules.
同时，我们还生产各款标准型液晶显示模块。
The latter can be divided into two types: character LCD modules and graphics LCD modules.
后者又可分为两种：字符型液晶显示模块和图形液晶显示模块。
The core of the system is MSP430F449, including peculiar sensors, signal process circuits, LCD modules, key modules and some alarms.
该系统是以MSP430F 449为核心，包括附叶式传感器，信号处理电路，液晶模块以及键盘模快以及报警设施。
The programmed give full play to the characteristics of human nature, the use of ISD1420 voice, with TG12864 LCD modules, with analog voice prompt realization of the taxi pricing system.
本方案充分发挥人性化的特点，利用ISD1420的语音功能，配合TG 12864液晶模组，模拟实现带语音提示的出租车计价系统。
The software, which employs modularization method, includes modules such as main programs, keyboard management, LCD, break service, measurement control and results treatment etc.
软件部分采用模块化设计方法，主要有主程序、键盘管理、液晶显示、中断服务、测量控制及结果处理等几个模块。
The software comprises of the currency modules of keyboard, LCD display and the special modules aiming at data processing and analysis of different experiment.
软件部分由键盘、液晶显示等通用模块和针对不同实验的数据处理、分析等专用模块组成。
These LEDs and display modules address a wide range of markets, including electronic signs and signals, automotive, solid state lighting and LCD display backlighting.
这些发光二极管和显示模块应用广泛，包括电子显示屏和信号灯、汽车、固态照明和液晶显示器的背光。
Embedded system resources are limited, after adding LCD driver and touch screen driver to the kernel, cut some modules which is unnecessary during the development process to make the kernel minimize.
嵌入式系统资源是有限的，在为内核添加了LCD驱动和触摸屏驱动后，将开发过程中不必要的模块进行了裁剪，使内核达到最小化的需求。
The hardware of system is the data acquisition equipment (DAQ), DAQ includes three main functional modules: FPGA, analog sampling and LCD controlling.
系统的硬件部分是数据采集卡，数据采集卡在功能上分为FPGA，模拟采样和液晶驱动及控制三个组成部分。
Abstrat: This system is composed by FPGA, MCU controller, keyboard, LCD, DAC and amplifier modules.
本系统由FPGA、单片机控制模块、键盘、LCD液晶显示屏、DAC输出电路和末级放大电路构成。
Based on modular design, the meter is divided into 4 modules: sensors module, main-board module, LCD and key-board module, mini-board.
本设计采用模块化的设计思想，整个仪表分成传感器、核心板、扩展板和液晶及按键四个模块。
Based on modular design, the meter is divided into 4 modules: sensors module, main-board module, LCD and key-board module, mini-board.
本设计采用模块化的设计思想，整个仪表分成传感器、核心板、扩展板和液晶及按键四个模块。
应用推荐