128 * 64 dot-matrix LCD driver, controller chips for ks0108.
128*64点阵液晶体驱动程序，控制芯片为ks0108。
Additionally, a LCD driver circuit is implemented by the SOPC.
同时，系统还实现了液晶显示屏(LCD)的硬件驱动。
A low power CMOS buffer amplifier for LCD driver is presented in this paper.
设计了一种用于LCD驱动的低功耗CMOS缓冲放大器。
The program is written based on my self-ST7920 LCD controller serial LCD driver.
本程序是本人自写的基于ST7920液晶控制器的串行LCD驱动程序。
Absrtact: a new method of designing LCD driver based on DSP and CPLD is introduced.
摘要：提出了一种新的基于DSP与CPLD的液晶显示驱动设计方法。
A buffer with Miller compensation and feed-forward path for charge pump of TFT-LCD driver IC was designed.
针对TFT - LCD驱动芯片的电荷泵，设计了一个带密勒补偿和一条前馈通路的缓冲电路。
Meanwhile, the measuring and result can be displayed at real time on a LCD which is driven by a special LCD driver.
同时该系统利用专用LCD驱动器将测量过程和结果实时地在LCD上进行显示。
Based on the detailed analysis of the loading properties of a medium or small size TFT-LCD driver IC, a novel output buffer circuit of driving voltages is proposed.
在分析中小屏幕TFT - LCD驱动芯片的负荷特性的基础上，提出了一种新型的驱动电压输出缓冲电路结构。
Embedded system resources are limited, after adding LCD driver and touch screen driver to the kernel, cut some modules which is unnecessary during the development process to make the kernel minimize.
嵌入式系统资源是有限的，在为内核添加了LCD驱动和触摸屏驱动后，将开发过程中不必要的模块进行了裁剪，使内核达到最小化的需求。
A single chip Liquid Crystal Display (LCD) driver chip is developed based on dynamic scanning, which is a high voltage CMOS digital and analog mixed signal IC.
文章介绍了一种基于动态扫描原理的液晶显示(LCD)驱动芯片，该芯片为高压CMOS数模混合集成电路。
A single chip Liquid Crystal Display (LCD) driver chip is developed based on dynamic scanning, which is a high voltage CMOS digital and analog mixed signal IC.
文章介绍了一种基于动态扫描原理的液晶显示(LCD)驱动芯片，该芯片为高压CMOS数模混合集成电路。
应用推荐