For example, cookies are limited to 4 kilobytes in size.
比如，cookie被限制在4k字节内。
Kbps: Reports back the amount of data transferred in kilobytes.
Kbps：报告已传输的数据量(单位为千字节)。
Note that the size is displayed in 512 byte blocks, not kilobytes.
请注意，所显示的大小是以512字节块为单位，而不是千字节。
Memory utilization has been reduced to a standard of tens of kilobytes
存储器占用已经减小为几十千字节的标准
Specify the size in bytes, kilobytes, megabytes, gigabytes, or terabytes.
以字节、KB、MB、GB或 TB 为单位指定大小。
TRS—The amount of RAM used for the text segment of a process in kilobytes.
TRS —用于进程文本段的RAM量（单位为 KB）。
Figure 4 shows the network kilobytes per second at different simulated user loads.
图4显示的是不同的模拟用户负载下，每秒全部网络千字节数。
In fact, typical 'scans' use only 6 kilobytes of data, less than a typical email.
事实上，典型的扫描只需要6千字节的数据。比一封邮件还小。
"Chunk-size" specifies the granularity of the chunks used for RAID-0 in kilobytes.
“chunk - size ”以千字节指定RAID - 0使用的块大小。
Note that the optional blobpage size is given in units of base pages, not kilobytes.
注意，可选blobpage大小参数以基页(而非千字节)为单位给定。
The -e option specifies the erase sector size of the flash (typically 64 kilobytes).
e选项确定闪存的擦除扇区大小(通常是64千字节)。
It shows the progress in percentage as well as the amount of kilobytes of received data.
它显示了进程的百分比以及已下载的字节数。
Kb_read: Reports back the total data (kilobytes) from your measured interval that is read.
Kb_read：报告在测量间隔中读取的总数据量(单位为千字节)。
Figure 4 provides a disk summary for each disk in kilobytes per second for reads and writes.
图4为每个磁盘的读写提供磁盘汇总信息，单位是千字节每秒。
Figure 3 shows the total disk kilobytes transferred per second at different simulated user loads.
图3显示的是不同的模拟用户负载下，每秒传送的全部磁盘千字节数。
If the value is 1000 or higher, Informix interprets the value as a specific number of kilobytes.
如果该值为1000或更高，Informix将其解译为一定数量的千字节。
Kb_wrtn: Reports back the amount of data (kilobytes) from your measured interval that is written.
Kb _ wrtn：报告在测量间隔中写入的数据量(单位为千字节)。
When messages are large (megabytes rather than kilobytes), memory requirements can be significant.
当消息较大(几兆字节而不是几千字节)时，可能需要较多的内存。
In addition to these two page sizes, newly available page sizes include 64 kilobytes and 16 gigabytes.
除了这两种页面大小外，最新可用的页面大小有64KB和16GB。
Using view folder size you can view file and folder sizes in bytes, kilobytes, megabytes and gigabytes.
使用查看文件夹大小，您可以查看文件和文件夹大小的字节，千字节，兆字节和千兆字节。
The "extend amount" has default units of kilobytes, but can be expressed as "10 MB", "32 GB", and so on.
“extendamount”具有默认的千字节数，但可表达为 “10MB”、“32GB” 等等。
The optional page size argument is given in units of kilobytes. The syntax for the this command is as follows.
可选页面大小参数以千字节为单位给定。
Nearly all traditional UNIX operating systems report the size in 512 byte blocks rather than kilobytes by default.
缺省情况下，几乎所有传统的UNIX操作系统都以 512字节块为单位报告大小，而不是千字节。
Relatively small footprint — size is in the range of 600 to 700 Kilobytes, which makes it easy to run on small devices.
占用的资源相对很小—大小在600k到700 k字节的范围内，这使它很容易在小型设备上运行。
Kb_read: Reports back the total data (kilobytes) from your measured interval that is read from the physical volumes.
Kb_read：报告在测量时间间隔中从物理卷读取的总数据量(单位为千字节)。
Kb_wrtn: Reports back the amount of data (kilobytes) from your measured interval that is written to the physical volumes.
Kb _ wrtn：报告在测量时间间隔中向物理卷写入的数据量(单位为千字节)。
To run Windows 1.0, you needed a minimum of 256 kilobytes, two double-sided floppy disk drives, and a graphics adaptor card.
运行Windows1.0，要求最低256千字节、两个双面软盘驱动器和一个显卡。
You can specify both sizes in terms of absolute kilobytes or as a percentage of the current size using sysadmin task commands.
您可以使用sysadmintask命令以绝对千字节数或当前大小百分比为单位指定两个大小。
For years, 4 kilobytes has been the standard page size for most operating systems, including the AIX 5l operating environment.
多年来，4KB一直都是大多数操作系统，包括AIX5l操作环境的标准页面大小。
If you want to specify a page size, the size must be an integral multiple of the default page size, not greater than 16 kilobytes.
如果希望指定页大小，指定的值必须是默认页大小的整数倍，而且不能超过16KB。
应用推荐