Result: Isogradient HA-coated implants had a greater average interface shear strength than the uncoated ones at each time span.
结果：术后每一时间段涂层植入体界面抗剪强度均显著高于非涂层者。
Result: Isogradient ha coated implants had significantly greater average interface shear strength than the uncoated implants at each of the time interval.
结果：在术后任一时间段涂层植入体界面抗剪强度均显著高于非涂层者。
However, the interface strength decreases after size scaling while the initial shear modulus increases, which cannot be ignored.
而粒径缩尺后的接触面强度会降低，同时初始剪切模量则有所增长，其影响不能忽略。
And we used shear strength of composites to research adhesive character of amorphous metal ribbon reinforced polymer composites. Using SEM technique, we examine the interface of this kind composite...
用扫描电镜(SEM)微观分析技术分析研究了经过表面处理前后的非晶态合金带增强的复合材料的表面和界面。
Results indicate that the coatings deposited by the coarser powder have higher shear strength and more crystalline hydroxyapaptite. The mechanical bond plays a dominant role in the interface j…
结果表明：采用粗粉末喷涂后得到的涂层结合强度较高，结晶程度也较高，但涂层与基体的结合机制仍为机械嵌合。
Results shows that all these three methods can be used to measure the shear strength of explosion cladding interface, and the most practical one is the double-notch method using symmetry specimen.
最后分别对3种方法进行了测试试验。结果表明，3种试验方法均能有效测试爆炸复合接头的剪切强度，其中对称试件双切口拉伸法最适合实际应用。
The turbulent strength, velocity flux, and skew were the largest at forest-atmosphere interface, as well the wind shear.
湍流强度、速度方差和速度偏度在林冠与大气交界面处达到最大，同时剪切也达到最强；
The turbulent strength, velocity flux, and skew were the largest at forest-atmosphere interface, as well the wind shear.
湍流强度、速度方差和速度偏度在林冠与大气交界面处达到最大，同时剪切也达到最强；
应用推荐