In the paper. the interference intensity of signal laser beam and the reference one is carried out in detail on a heterodyne laser probe with amplitude modulated laser source.
本文详细推导了用振幅调制激光为光源外差激光探针的信号光与参考光干涉光强表达式。
In flying height measuring method utilizing light intensity interference principle, the position control of micro flying head has effect on measuring error.
基于强度干涉原理的飞高检测方案中，微型飞行头位姿控制是影响测量误差的一项关键因素。
The paper stresses the importance of mechanical probability design and reliability forecast on stress and intensity interference model.
应力、强度干涉模型在机械的概率设计和可靠性预测中非常重要。
Results show that the effects of laser interference on IR system is opposite to IR source intensity.
结果表明：激光对红外系统的干扰效果与红外目标源的强度成反比。
According to the multi-beam interference occurred at the air gap for the polarizing light of Taylor prism, the transmitted light intensity depends on the incident Angle.
通过泰勒棱镜的单色偏振光束在空气隙处发生多束光的干涉，使得透射光强依赖于入射角的大小。
The distribution curves of light intensity of orthogonal biprism interference is made from experimental results.
通过实验结果作出正交双棱镜干涉的光强度分布曲线。
Soil erosion is greatly affected by artificial interference and farming intensity. The amount of soil erosion in hillside field system increases 20 times from natural protection to crop cultivation.
土壤流失量受人为干预、耕作强度的影响很大，坡地从自然保护到作物栽培，系统的土壤流失量提高20倍。
The most obvious interference effect is realized when IR source intensity lies in linear operation range of IR system.
当红外源强度在红外系统工作的线性范围时，激光对红外系统的干扰效果最明显。
The effects of experimental conditions on fluorescence signal intensity and interference from coexisting ions were studied.
研究了实验条件对荧光强度的影响和共存元素的干扰。
In this paper, the intensity distribution of interference field of holo-speckle interferometry is derived when the error of system geometry exists.
本文导出了存在系统几何偏差时全息一散斑干涉术中干涉场的强度分布。
To overcome the interference of background light, a new turbidity measurement method is described which uses light with modulated intensity as source.
为避免背景光的干扰，本文提出了采用调制光强测量浊度的新方法。
General expressions of intensity ratio of light in ring and output port were deduced according to multiple-beam interference, and optimum resonance condition was given.
从多光束干涉的基本原理出发，推导了集成光波导陀螺谐振腔一般谐振过程中，谐振环光强和输出光强表达式。
Sound intensity measurements accurately capture only the sound produced by the source under test, eliminating interference from other sounds and realizing the location of the sound.
声强测量可以剔除其他声音的干扰，准确的确定声源的位置，即进行声源定位。
On the basis of structure design of optical system and parameter option of optical components, the visibility of interference fringe with zero background intensity is optimized.
通过对光学干涉系统结构设计和元件参数选择，最大限度地优化了干涉条纹的可见度，并设计出零背景光强标准硅球直径精密测量系统。
In addition to alternating phase difference between two aims of interferometer, the intensity of light of the interference fringes will vary in the same frequency, which is called as phase modulation.
当两相干光附加一按固定频率变化的相位差时，其干涉条纹的光强将随之交变，即为相位调制干涉。
The interference of several optical vortices can generate intriguing intensity and phase distributions due to the particular helical phase structures and central singularities.
光学涡旋具有独特的相位奇点和螺旋相位结构，多个涡旋光场之间的干涉呈现出新颖的强度和相位分布特征。
The research works on the relationship between interference fringes and the factor of stress intensity are introduced. The quantitative expression of this relationship has been found and introduced.
介绍了在寻找全息干涉条纹与应力强度因子之间关系所作的研究，导出了干涉条纹最大值与应力强度因子之间的定量关系式。
Interference theory of application stress-intensity, analyze the traditional safety factor and the reliability simultaneously, reset the measuring index of safety factor.
应用应力—强度干涉理论，将传统安全系数与可靠性同时进行分析，重新建立安全系数的度量指标。
Moreover, with the decrease of the cone waist diameter, more cladding modes are excited, and more interference peaks with enhanced intensity are observed.
锥腰直径减小，激发更多包层模，干涉峰个数增多，强度提升；
The distribution of interference light intensity generated by multiple coherent laser beams on reference plane is derived in theory and the numerical calculation is carried out.
对参考平面上相干光产生的干涉光强分布进行理论推导和数值计算，从理论上定量地分析了多束相干光的波矢量、偏振态对干涉光强分布的影响。
Use the reliable theory intensity-stress interference model, utilizes the reliable method in the pressure vessel design, points out the reliability design goal, introduces the step of the design.
应用可靠性理论中的强度—应力干涉模型，将可靠性方法运用于压力容器设计，指出了可靠性设计目标，阐述了设计的具体步骤。
In the condition of assuming that stress and intensity obey normal distribution, the basic method of reliability design, stress-intensity interference model is discussed.
通过对应力—强度干涉模型的分析，针对安全部件专用电磁铁的特性，提出了安全部件专用电磁铁的释放可靠性理论。
Analysis software for total sample evaporation technique has been developed. The factors of interference measurement, such as sample size, signal intensity loss and sample residue, have been studied.
开发了用于全蒸发技术的测量软件，对影响测量结果的因素，诸如分析用样量、信号损失与试样残留等进行了研究。
Analysis software for total sample evaporation technique has been developed. The factors of interference measurement, such as sample size, signal intensity loss and sample residue, have been studied.
开发了用于全蒸发技术的测量软件，对影响测量结果的因素，诸如分析用样量、信号损失与试样残留等进行了研究。
应用推荐