In this paper, amidopyrine (p) and antipyrine (a) in the compound amidopyrine injection were determined by coefficient multiplication method.
本文用系数倍率法测定复方氨基比林注射液中氨基比林(p)和安替比林(A)的含量。
Commonly used methods to evaluate the injectability included testing injectability coefficient, pushing force and injection pressure.
常用的注射性能评价方法包括测定注射能力系数、推力和注射压力三种。
The electric charge injection is necessary to enhance pyroelectric coefficient of composite.
电荷注入机制是制成高的纯熟释电系数复合材料的必需条件。
The distribution of separate layer injection intensity appears lognormality, and the variable coefficient is one constant.
分层注水的层段注水强度服从于对数正态分布，并且其变异系数为一常数。
In the calculations of roll torque of ablation lag, a rapid method for calculating combined influence of ablation injection and roughness on skin friction coefficient is mainly described.
在烧蚀滞后滚转力矩的计算方法中，本文主要介绍滞后引射率和粗糙度对壁面摩擦系数联合影响的一种快速计算方法。
There existed a significant positive linear correlation between total Fe and active Fe in leaves after injection of iron fertilizer, the coefficient of correlation being 0.9842.
注铁后，叶子全铁含量与有效铁含量之间呈极显著的直线正相关，相关系数为0.9842。
The effects of nozzle structure, fuel gas injection velocity and excess air coefficient on NOx emission in high temperature air combustion were investigated.
通过两种结构烧嘴的热态燃烧试验对比，研究了烧嘴结构、燃气射流速度、过量空气系数对高温空气燃烧过程氮氧化物排放的影响特性。
The deflection angle of injection mainly depends on the valve port angle and almost has no relation to the valve size, but the reduction coefficient vavies with both of them.
射流的偏转角主要受阀口角度的影响，几乎与阀口尺寸无关；但射流的收缩系数则与两者都有关系。
Research shows that with the increased CO2 injection, dissolved gas oil ratio, volume expansion coefficient and coefficient increases, viscosity decreases, bound water volume expansion.
研究表明：随着CO2注入量增加，溶解油气比、体积系数和膨胀系数增大，粘度降低，束缚水体积膨胀。
The rotatory method was used to determine the content of amikacin injection in the light of its right rotatory. The average recovery was 100.17%, and the coefficient of variation was 0.54%.
根据丁胺卡那霉素为有旋光性物质的原理，采用旋光法测定了丁胺卡那霉素注射液含量，结果平均回收率为100．17％，变异系数为0．54％。
The result shows that cyclic water injection may be more effective if increasing oil-water percolation rate, standup pressure time and water holdup coefficient.
周期注水技术主要是通过油水交渗效应、毛管压力作用，增加注水波及体积，从而提高水驱采收率的技术。
The result shows that cyclic water injection may be more effective if increasing oil-water percolation rate, standup pressure time and water holdup coefficient.
周期注水技术主要是通过油水交渗效应、毛管压力作用，增加注水波及体积，从而提高水驱采收率的技术。
应用推荐