It was suggested that in the rotational molding, the initial viscosity controlled the wall thickness of the product and the gel rate controlled the uniformity of the wall thickness.
试验表明，树脂体系的初始黏度对制品最终壁厚影响较大，体系的凝胶速率对制品壁厚均匀性影响较大。
The recorded curve, called an amylogram shows that with increasing temperature there is an initial small fall followed by a steep rise in viscosity to a maximum value.
所纪录的曲线称为淀粉糊粘度图谱，该图展示了随着温度的增加， 粘度先是小幅度下降，然后迅速上升至最高点。
Faster injection (up to a point): less cooling during filling, hence a thinner initial frozen layer, lower viscosity due to shear thinning;
较快注塑（到点）：在填料过程中冷却较少，因此初始固化层较薄，由于剪应变稀少而粘性较低；
Tengxi 180 and Fushiguang had high taste value, max viscosity and break down than Shuiludaol and Dongnong 416, whereas had lower initial pasting temperature, final viscosity and setback.
藤系180、富士光的味度值、最高粘度、下降粘度值明显高于水陆稻1号和东农416，而糊化开始温度、最终粘度、粘滞峰消减值则相对较低。
Up to now, there are about 100 non-viscosity initial velocity formulas which have been put forward.
到目前为止一百多年来，所提出的无粘性颗粒的起动流速公式已在100个左右。
Up to now, there are about 100 non-viscosity initial velocity formulas which have been put forward.
到目前为止一百多年来，所提出的无粘性颗粒的起动流速公式已在100个左右。
应用推荐