It also shows that the average creep displacement value of the cofferdam structure is 2-3 times of the initial displacement.
围堰结构的后期流变位移平均值是流变初期时位移的2 ~3倍。
The influence of initial displacement on load bearing capacity and critical load of steel concrete composite structure is discussed.
讨论了钢材的初始挠曲对钢混凝土连续组合梁的极限承载力与失稳屈曲临界荷载的影响。
Based on the assumption of random installation deviation, the finite element met hod analyzing the initial displacement and stress of grid structures was set up.
基于随机安装偏差模式，利用空间有限单元法和概率方法，分析了网架结构由于安装偏差引起的初始应力和初始位移。
The occurrence of complications following fixation is multifactorial. Initial displacement and timing and accuracy of reduction are the key factors affecting outcome.
影响固定并发症的因素较多，初始移位和时限及复位精确度是影响结果的关键因素。
In the experiment of measuring gravity acceleration with a pendulum, a few error factors are existed, such as complex pendulum, air buoyancy, air resistance and initial displacement.
在利用单摆测重力加速度实验中，有复摆、空气浮力、空气阻力、摆角等多种误差因素。
PURPOSE: to study the stress variation and distribution of the periodontium and the tooth initial displacement when the lingual fixate forces were applied to the depressed periodontal height.
目的：研究牙周支持高度降低状态下施加舌向集中力时，牙周组织的应力变化、分布规律和牙的初始位移。
We know the initial conditions, and we know it's a simple harmonic oscillation, and we want to know what the maximum displacement is going to be.
我们知道初始条件，我们知道这是简谐振荡，我们想知道，最大位移是多少。
Despite adherence to these guidelines, further displacement often occurs after the initial diagnosis and stability assessment.
可尽管严格按照这些指标，在初始诊断和稳定性评价后，进一步的移位时有发生。
However, the displacement and deformation of surface ground by underground mining have destroyed initial equilibrium between the building and the ground.
但是由于地下开采引起地表产生的移动和变形，破坏了建筑物与地基之间的初始平衡状态。
The graphs for the displacement, energy and the trajectory of the bob are gotten by recording the position of the bob in real time under different initial conditions.
通过实时记录摆球的位置，得到了不同初始条件下，弹簧摆振动的位移曲线、能量曲线和摆球运动的轨迹。
The plane displacement of hyperelasticity was discussed. Aimed at a complex strain energy density function, a group of hyperelasticity governing equations defined on initial configuration were solved.
针对一种复杂的应变能密度函数形式，在平面位移情况下，对定义在初始构形上的超弹性基本方程进行了直接的解析求解。
Because of the interstice between pin and pinhole, the initial geometric displacement is generated, and then the bearing capacity of the structure is reduced.
销孔间隙会使体系产生初始几何位移，并对结构的承载力产生不容忽视的影响。
A new model of plate bending Similar to the model of three-order displacement is proposed by means of the method of initial functions.
利用初始函数法，提出一种类似三阶位移模型的板弯曲方程新模型。
The application of tangent-initial-displacement method in solving fabrication geometry is introduced.
介绍了切线初始位移法在求解制造线形中的应用。
Based on the initial parameter method, a concise relation between displacement vector and force vector at both ends of the pipe is obtained.
借助初参数法的思路，建立管两端位移、内力向量间的关系。
Both initial and boundary-value problems, including displacement, traction and mixed boundary conditions are solved.
解决了初始和边值问题，包括位移的、曳力的和混合的边值条件。
Finally, it validated established model with each point displacement velocity chart, analyzed and summarized the established of state equation and selection of initial value at the same time.
并采用各点点位位移速度图对所建立的函数模型进行验证，同时对状态方程的建立及初始值的选取进行分析总结。
The stress displacement equations of cylindrical shell with initial imperfection are deduced on the basis of definitions of imperfection.
基于初始缺陷的定义式，推导出有初始缺陷的圆柱壳的几何方程。
Displacement, Initial velocity, Final velocity, Acceleration and Time.
位移，初速度，末速度，加速度和时间。
Growth faults have special fault plane form in their initial phase during which the displacement of the two blocks creates two kinds of stress states pore belt and sealing belt.
生长断层成长初期具有独特的断面形态，断层两盘在错动过程之中会产生空隙带和闭合带两种应力状态。
Regarding initial stresses as parameters, a variational principle of displacement is suggested.
用初应力作为参数，提出初应力位形上小变形问题的位移变分原理；
Based on the consistent mode imperfection method, the initial defect model was determined by the least order mode of eigenvalue buckling, and the maximum displacement value.
初始缺陷的模型是根据一致缺陷模态法，按最小特征值屈曲模态分布，并控制其最大值的方法确定。
Based on the consistent mode imperfection method, the initial defect model was determined by the least order mode of eigenvalue buckling, and the maximum displacement value.
初始缺陷的模型是根据一致缺陷模态法，按最小特征值屈曲模态分布，并控制其最大值的方法确定。
应用推荐