BeagleBoard is supported by a large community and its design documents, including architecture drawings of the printed circuit board (PCB) for use in manufacturing, are freely available for download.
BeagleBoard受一个规模很大的社区支持，而它的设计文档，包括生产用的印刷电路板(PCB)的架构草图，均可免费下载得到。
Then the design of the RS-422 serial communication module is introduced in detail, including the whole scheme of serial communication module and the design of functional circuit.
并且详细介绍了测试系统中需要自行研发的RS- 422串行通信模块设计，包括串行通信模块总体框图和功能电路设计方案。
The third chapter mainly introduces the hardware design of soft starter, including the main circuit, control circuit, drive circuit, and protect circuit and auxiliary switched power design.
第三章详细介绍了软起动控制器的硬件设计，包括主电路、控制电路、驱动保护回路和辅助开关电源电路的分析和设计。
The paper mainly describes the design of the inverter, including circuit, DSP software design and PWM waveform generate theory.
重点叙述逆变器的设计，包括电路结构、DSP软件的设计、PWM波形的产生原理；
This research works out a design of signal adaptor circuit of serial communication port between PLC and PC, including input interface circuit and output interface circuit.
设计了PLC与PC机串行通讯口之间信号适配器硬件电路，包括输入接口电路、输出接口电路。
Then introduced the theoretical basis of the antenna design and performance parameters: including the circuit parameters and radiation pattern.
接着介绍了天线设计的理论基础和性能参数：包括电路参数和辐射参数。
The circuit design is carried out by taking chip of RF-ID U2270B as core, including power module, frequency module, antenna module and data input;
采用以射频卡U2270B器件为核心完成支撑电路设计，包括电源模块、频率模块、天线模块和数据输入；
The chapter two introduces the sensor that is important for gather system, including the collection of sensor and the design of circuit.
第二章介绍了采集系统的重要内容—传感器，包括传感器的选择和电路的软硬件设计方案。
In the hardware of system, it introduces the detailed hardware of DSP excitation regulator, including the design of DSP peripheral circuit, digital circuit and impulse unit circuit.
在硬件组成中，详细地介绍了DS P励磁调节器的硬件组成部分，其中有DSP外围电路的设计，数字电路和脉冲产生单元的设计。
The ECT system used to imaging the distribution of sintering ore and cokes in lump zone of a blast furnace is studied including the sensor design, measuring circuit design and system software design.
介绍了用于实现高炉块状区物料分布可视化监测的E CT系统，包括系统的硬件检测电路构成、传感器设计及软件设计。
Eddy current testing for measuring rebound clearance of aluminum skin caused by bending is described including its basic principles, characteristics and the design of measuring circuit and software.
介绍应用涡流检测技术测量铝蒙皮拉弯成型回弹量的基本原理与特点，以及应用系统机实现测量的电路设计与软件编制。
The design method is briefly introduced in the thesis, including the selection of hardware parts, the design of hardware circuit and software.
文中简要介绍了嵌入式系统的设计方法，包括硬件选型，硬件电路设计及软件设计方法。
The author completes the whole design flow of the signal generator based on DDS, including project design, hardware circuit design and VHDL programming.
作者完成了整个DDS信号产生器的设计流程，包括方案设计、硬件电路设计、以及VHDL程序设计。
This paper introduces the design of high power supersonic inverting power supply, including main circuit, controlling circuit, driving and protecting circuits, and gives experimental results.
主要介绍一种大功率超声波逆变电源装置的主电路、控制电路、驱动与保护电路的设计，并给出实验结果。
To introduce a kind of toxic gas detection intelligent instrument based on LONWORKS, including its functional principle, hardware circuit and software design.
介绍了一种基于LONWORKS总线的有毒气体智能仪表的工作原理、硬件电路设计和软件设计。
In this part, some points are presented in detail, including hardware choosing, unit circuit design, control principle and control algorithm.
论文对核心器件的选型，单元电路的设计，控制原理以及控制算法都进行了详尽的说明。
The second part of the paper introduces the hardware design of the system, including the circuit design of host station RF module and measurement station RF module.
第二部分介绍了系统硬件设计，包括主站射频模块和测站射频模块电路的设计。
The present paper discussed the overall design scheme of this system, including the designs of generating sector, receiver sector, single circuit initiating.
本文论述了系统设计的总体方案，发射端、接收端和单路起爆电路的设计，以及系统实现的方法和原理。
This paper introduces the design and implementation of ventilator control system based on FPGA including principle and electric circuit.
本文详细介绍了基于FPGA的呼吸机控制系统的设计和实现，包括原理和电路结构图。
This paper introduces in detail the design and implementation of ventilator SPONT control chip based on FPGA, including principle and electric circuit.
本文详细介绍了基于F PGA的呼吸机SPONT 模式控制芯片的设计和实现，包括原理和电路结构图。
In Chapter 2, the analysis methods concerned with high speed interconnect design are discussed, including the formulation of circuit equations and model reduction algorithm.
第二章论述了现今高速互连设计使用到的分析方法，包括电路方程的表述和模型简化算法。
The project also carried out system design, including: the overall cooling control system design, hardware design and selection, circuit design.
本课题还进行了系统设计，主要包括：冷却控制系统整体设计、硬件设计及选型、电路设计。
Design of concentrator module including circuit connecting design, working design of concentrator and so on.
集中器模块设计包括集中器的电路连接设计，集中器的工作流程设计等问题。
This paper studies the method of designing PXI system controller using ETX embedded computer module, presents the design solution and complete the circuit including the trigger bus.
本文研究了利用ETX嵌入式计算机模块来设计PXI零槽控制器的方法，提出了总体方案，完成PXI触发总线的设计，并实现了具体的电路设计。
Then, the paper elaborates the design principles of RF front-end circuit, including high efficient rectifier, modulation circuit, demodulation circuit and ESD protection.
然后本文详细阐述了射频前端电路设计原理及过程，包括高效倍压整流电路、调制电路、解调电路和ESD保护电路。
The design of the whole hardware circuit, including theCPLD processing of the sensor signal, the PCI bus inter-face circuit is introduced.
详细介绍了整个系统的硬件电路设计，包括光栅传感器信号的CPLD处理、PCI总线接口电路设计；
Hardware circuit design includes a central processing unit circuit, clock circuit, assembly language software to achieve, including the main program, subroutine, such as set-up time software modules.
硬件电路设计主要包括中央处理单元电路、时钟电路、软件用汇编语言来实现，主要包括主程序、时光设置子程序等软件模块。
In the light of the new design, Lumileds companies have 18 red led light source, including the loss of circuit, a total power consumption of 14 watts to generate the same optical effect.
而在新设计的灯中，Lumileds公司采用了18个红色led光源，包括电路损失在内，共耗电14瓦，即可产生同样的光效。
In the light of the new design, Lumileds companies have 18 red led Lighting source, including the loss of circuit, a total power consumption of 14 watts to generate the same optical effect.
而在新设计的灯中，Lumileds公司采用了18个红色led光源，包括电路损失在内，共耗电14瓦，即可产生同样的光效。
Three aspects on magnetic circuit design of MR devices including selection of magnetic core material, determination of magnetic field direction and magnetic circuit calculation were investigated.
从磁芯材料选择、磁场方向确定和磁路设计步骤三方面总结了磁流变器件磁路设计的一般方法。
应用推荐