If so, turn the ignition switch in the on position, put the car in two gear, foot clutch, vehicle drag, when traveling to a certain speed, release the clutch, the car would start.
如果是这样，拧动点火开关在ON的位置，把车挂二挡，脚踩离合，用车拖拽，当行驶到一定速度时，松开离合，汽车就能自然启动。
He should also check ignition wires and connections, adjust idle speed and replace PCV valve. Attention to these service functions will improve engine performance and fuel economy.
还应检查点火连线及其接头，调整空载速度，更换压力调节阀。注意上述维修工作将提高发动机性能并节省燃料。
He should also check ignition wires and connections, adjust idle speed and replace PCV valve.
还应检查点火连线及其接头，调整空载速度，更换压力调节阀。
The software mainly processes the rotate speed signal of the crankshaft and camshaft position signal to export ignition control signal.
软件部分主要对曲轴速度信号、凸轮轴基准信号等进行处理计算，输出点火控制信号。
The electronic control unit allows current to flow through the ignition coil primary winding until it senses a triggering voltage pulse from the speed sensor, or pickup coil.
电子控制单元使电流通过初级绕组直到感知到一个从转速传感器或拾波线圈产生的触发电压脉冲。
In this paper, equipment for ignition and speed for temperature rising in deferent conditions are discussed, problems for packing, handling and bricks laying are analyzed.
对点火升温所用设备，不同情况下升温速度进行了讨论，对包装、储运、砌筑等方面的一些问题提出了看法。
In addition, the influence of the spark energy, the gas stream speed and the electrode distance on the lean ignition limit of the gasoline-air mixtures by an automobile ignition coil was determined.
此外，利用汽车发动机点火系统测试了电火花能量、来流速度、电极距离等因素对汽油-空气预混气的着火稀限的影响。
The result showed that, by using a quick ignition technique, the transmitting speed and ignition pressure of the flash tubes increased obviously, and more stable combustion were obtained.
试验结果表明：采用快速点传火技术的传火管传火速度大大提高，点火压力增大，点火后燃烧稳定。
Software design includes: writing programs of rotate speed computing module, ignition timing computing module and ignition control module and curve fitting.
软件设计部分包括转速计算模块、点火时间计算模块、点火控制模块和曲线拟合等的程序编写。
These factors are mixture concentration, ignition advance Angle, engine speed, temperature of cooling water and carbon deposit on the SUrfaces of the combustion chamber, etc.
通过试验找出了诸因素对怠速排放污染物浓度的影响规律，如混合气质量，点火，发动机转速，冷却水温度及燃烧室表面积炭等。
This paper studies the characteristics of cyclic combustion variation in spark ignition engines by using high speed schlieren photographs.
介绍了运用高速纹影摄影对火花点火发动机循环变动特性的研究。
When the pipeline length and diameter ratio was certain, the flame travel speed of gas explosion and ignition energy would be in a quadratic function relationship.
在管道长径比一定时，瓦斯爆炸火焰传播速度与点火能量呈二次函数关系。
The high speed photography was applied to visualize the fuel spray and ignition process in main and prechamber in a swirl type diesel engine at cold starting condition.
本文对涡流室式柴油机在冷起动条件下主、副燃烧室内燃油喷雾和着火过程进行了高速摄影。
The effects of converter position, ignition timing and idle speed on catalytic converter light-off behavior were studied on an electronically controlled LPG injection engine.
研究了电控LPG发动机的催化转化器安装位置、点火提前角和怠速转速对催化转化器快速起燃的影响。
The heat radiation in cylinder of a high speed light load compression ignition engine is measured using a heat radiation sensor.
在一台小型高速单缸压燃式发动机上，利用商用辐射传感器测量了缸内辐射传热量。
Beginning from the analysis of ignition waveform, this paper researches the influence of engine rotate speed variation to high voltage ignition waveform.
从点火波形分析入手，研究发动机转速变化对高压点火波形的影响。
The variation of combustion velocity, fired gas temperature and flame propagation speed, when the press, excess air ratio and ignition timing changed, was calculated by this quasi-dimensional model.
此模型能根据实测的燃烧压力曲线计算出层流燃烧速度、已燃气火焰温度及火焰传播速度等参数随压力、当量比、发动机转速、点火提前角的变化规律。
It's for detection of engine speed, piston top dead center position, signal ignition and injection control in top dead center of each piston.
主要用来检测发动机转速，检测活塞上止点位置，包括检测用于控制点火的各缸上止点信号、顺序喷气的第一缸上止点信号。
Then basic calibration such as ECU I/O calibration, idle speed calibration, cold start calibration, ignition advance calibration, air fuel ratio calibration, boost pressure calibration are conducted.
同时对稀薄燃烧、增压中冷发动机做了ECUI/O标定、怠速标定、冷启动标定、对电控系统进行全工况内点火提前角的标定、内空燃比的标定、发动机增压压力标定。
The control system is made up of a single-board microcomputer and an electronic ignition system. The feedback signal is detected by a speed sensor.
该系统由一单板微处理机和一套全晶体管电子点火装置组成，反馈信号由汽油机转速传感器检取。
The measurement and analysis of some experimental models revealed that the engine revolving speed bore a matching relationship to the electronic ignition system in an automobile.
通过对实验模型的测定、分析，提出发动机转速对电控点火系统的匹配关系。
Universal modules of engine speed calculation, crankshaft and camshaft positions detection, actuators drive, injection and ignition parameters calculation, as well as control module were designed.
设计了通用的转速计算、位置判断、执行器驱动、存储器通信、喷油点火参数计算及控制模块。
Experimental results show that the position of the converter nearer to the exhaust port, the retard ignition timing and the higher idle speed can promote the catalytic converter light-off.
试验结果表明，催化转化器的位置距排气口近可提高排气温度，大大提高催化转化器的转化效率；推迟点火提前角和提高怠速转速均有利于使催化转化器进入快速起燃状态。
The utility model relates to a motorcycle speed-limiting device, comprising an engine revolution speed transducer (1), a driving speed transducer (2) and an ignition controller.
本实用新型涉及的摩托车限速装置，包括发动机转速传感器（1）、摩托车车速传感器（2）及点火控制器；
The utility model relates to a motorcycle speed-limiting device, comprising an engine revolution speed transducer (1), a driving speed transducer (2) and an ignition controller.
本实用新型涉及的摩托车限速装置，包括发动机转速传感器（1）、摩托车车速传感器（2）及点火控制器；
应用推荐