This is another area where the tool can be the source of the spark or heat causing ignition of flammable materials.
这是工具可能成为火花源或热源并点燃可燃物的又一类区域。
A fire requires fuel to burn, air to supply oxygen, and a heat source to bring the fuel up to ignition temperature.
一把火需要燃料来燃烧、空气来提供氧气还有使燃料到底燃烧温度的热量。
The high plasma current allowed in a RFP is expected to be sufficient to heat the plasma to ignition without the need of auxiliary neutral-beam or radio-frequency heating.
在反场箍缩条件下可允许用强等离子体电流充分加热等离子体到点火温度，而不需要辅助的中性束或射频加热系统。
The ignition temperature and ignition delay time decreased with the increasing radiant heat flux.
结果表明，随着辐射热能流率的增加，着火时间缩短，着火温度降低；
The use of volatile technology, made of ceramic glow plugs heat the fuel evaporated into gas, fast ignition, combustion.
采用挥发技术，由陶瓷点火塞将燃油加热蒸发成气态，快速点火，燃烧充分。
Test results show that wood has longer ignition time, less CO yields and less specific extinction area, but its heat release rate is between CR and PVC belts.
结果表明，木材与CR ，PVC输送带相比点燃时间较长，热释放速率介于两者之间，CO生成率和比消光面积较小；
For external radiation ignition manner, a series of small-scale fire tests were conducted in a cone calorimeter in accordance with ISO 5660. Heat release rate and mass loss rate were measured.
外部辐射着火的方式采用符合ISO 5660标准的小型锥形量热计来实现，测量其热释放速率及质量损失速率。
Based on calculation of heat engineering, ways decreasing ignition energy consumption using hot air are discussed.
介绍了燃料气的化学组成和煤气热值，通过热工计算，探讨利用热风降低点火能耗的途。
Ignition start-up model of impulse micro-thruster is established, considering two phase flow and impact heat transfer of particle on the surface of propellant.
建立了微型脉冲推力器点火启动模型，模型中考虑了两相流动和颗粒对推进剂表面的冲击传热。
Two most common ignition manners, external radiation and internal heat, were used to ignite the material.
采用两种最常见的点燃方式，即外部辐射着火和内部受热着火，对材料多角度研究其燃烧特性。
The heat radiation in cylinder of a high speed light load compression ignition engine is measured using a heat radiation sensor.
在一台小型高速单缸压燃式发动机上，利用商用辐射传感器测量了缸内辐射传热量。
The control of auto-ignition time and heat release rate is the most difficult technical question in realizing HCCI combustion.
但HCCI燃烧存在运转范围窄、着火时间和放热率不好控制等缺点，具体实施上还有许多困难。
Additionally due to its compression ignition without throttle loss of valve throttle, it can make a higher heat efficiency.
又由于是压缩着火而且没有节气门的节流损失，可导致高的热效率。
Under the action of a same heat source, when the direction of grain is perpendicular to the direction of the action, the ignition delay time is the longest.
同样外部热源作用下，木材内部木纹方向垂直于作用方向时，着火延迟时间最长；
A heat recovery system, utilizing the hot air from the draft fan at the first zone of a draft strand cooler for ignition, heat preservation and sintering is introduced.
本文介绍一个用抽风带冷机第一段的热风进行点火、保温和烧结的余热利用系统。
Store in closed original packaging protected from any source of heat or ignition, in well ventilated areas.
请存放于空气流通之场所，并放置于原密封包装内。避免热源或是火源。
The diesel engines are compression ignition engines. The diesel engine uses the heat of compression to ignite the fuel.
柴油机和汽油机一个主要区别是柴油机的压缩比非常高。
As one of the ways to control HCCI combustion, EGR presents an important role on the rule of self ignition and heat release.
EGR作为控制HCCI燃烧的手段之一，影响着燃烧始点和放热规律。
As one of the ways to control HCCI combustion, EGR presents an important role on the rule of self ignition and heat release.
EGR作为控制HCCI燃烧的手段之一，影响着燃烧始点和放热规律。
应用推荐