This paper also discussed the combustion cyclic variability at idle condition.
论文还对在怠速工况燃烧循环变动进行了统计分析。
The mechanism of backfire in idle condition is theoretically analyzed and the idle control strategy is studied.
对怠速工况下回火现象的生成机理进行理论分析，研究了氢燃料发动机怠速控制策略。
A mechanics model for engine mount system is established with MATLAB based on dynamic stiffness of engine mounts in idle condition.
建立了基于悬置元件怠速工况下动刚度的发动机悬置系统MATLAB力学模型。
The experiment shows that the power of converted engine is the same of the base engine, the emission at idle condition is lower than the national regulation GB14761.5-93.
实验表明，经改造后的发动机的动力性与原机相当，初步测试表明其怠速排放性能远低于我国现行标准GB14761.5—93。
We simulate engine performance in various operating conditions:in idle condition, it reduces the residual gas coefficient and increases airflow velocity, so that idle stability is improved.
模拟计算了各种工况下的发动机性能：怠速工况降低了残余废气系数，提高了进气流速，稳定性得到改善；
The expression uses the *VALUE, *LT, *AND, and *EQ criteria functions to test for the condition CPU idle time being too low.
表达式使用 *VALUE、*LT、*AND 和 *EQ标准函数来测试CPU空闲时间过低的条件。
Gear pump is the first run, or long-term idle before using, had better under the condition of no load or small load to run one hour or so.
齿轮泵若是第一次运行，或长期闲置后再使用，最好在空载或小负荷情况下先跑合一小时左右。
Under the condition of permission the idle insert, a job sequence was determined, which minimize the maximum earliness.
在允许机器空闲的条件下，寻找一个工件排序，使得最大提前完工时间最小。
The proceedings of idle speed are so complex that it is very difficult to design a good controller based on the mathematical model of gasoline engine idling condition.
由于发动机的怠速运转是非常复杂的一个过程，所以要在发动机怠速的数学模型的基础上来设计控制器是很困难的。
The characteristic of engine exciting is analyzed. The hydraulic mount system' simulating calculation on idle working condition and high speed working condition is carried out by ADAMS.
分析了发动机激励的特点，运用ADAMS进行了动力总成液压悬置系统的怠速和高速工况下的仿真计算。
The characteristic of engine exciting is analyzed. The hydraulic mount system' simulating calculation on idle working condition and high speed working condition is carried out by ADAMS.
分析了发动机激励的特点，运用ADAMS进行了动力总成液压悬置系统的怠速和高速工况下的仿真计算。
应用推荐