The pump consists of three sections from bottom to top: the hydraulic section, the shaft seal section and the motor section.
主泵由三个部分组成(由下而上)：水力部件，轴密封部件和电机部件。
The hydraulic section consists of the inlet and outlet nozzles, casing, flange, impeller, diffuser, pump shaft, pump bearing, thermal barrier and thermal barrier heat exchanger.
水力部件由以下组成：出入口管，壳体，法兰，叶轮，导叶，泵轴，泵轴承，热屏和热屏热交换器。
It is shown that the optimal hydraulic section for compound canal has smaller section area and narrower breadth of water surface than trapezoidal canal by calculation and comparison.
并通过算例比较证实，复合断面水力最佳断面的面积和水面宽度比梯形水力最佳断面的小。
The driller checks the end of the new drilling line for damage, and cut off any defective section by using of a hydraulic line cutter.
司钻检查新大绳的快绳头，如有任何损伤或缺陷，就用液压切绳器把它切掉。
This circular curve shape is actually the extension of the hydraulic optimum section in hydraulics to the situation of considering ban stability.
该圆弧形曲线形状实际上是将水力学中的水力最佳断面推广到考虑边坡稳定的情况。
This circular curve shape is actually the extension of the hydraulic optimum section in hydraulics to the situation of considering bank stability.
该圆弧形曲线形状实际上是将水力学中的水力最佳断面推广到考虑边坡稳定的情况。
The frame of mast derrick that is designed for hydraulic wheel tractor hoist adopt welding of armor plate, its section is oblong armor plate, and its material is HG60.
为满足液压轮式通井机的使用要求而设计的桅杆式井架采用板焊结构，主体截面为长方形的方形钢，材料为HG60。
The hydraulic state in critical downhill section of long pipeline is unusual, and installing pressure regulation station is a widely used method for meeting its special requirement.
输油管道的大落差段有特殊的水力状态，设置压力调节站是适应这种水力状态而广泛采用的技术。
The up jarring section takes use of hydraulic mechanism, the jarring force can be adjusted according to up elevating load but can not exceed the max. load for tool load rated.
上击器采用液压原理，其震击力可由上提力的大小自由调节，但使用时不允许超过工具限定的最大负荷。
Lifting operation hydraulic system should be no-load operation, adjust the lifting sleeve frame roller and the mast section clearance, hoisting torque and balance torque balance;
顶升作业时液压系统应进行空载运转，调整顶升套架滚轮与塔身标准节的间隙，使起重力矩与平衡力矩保持平衡；
The section integration used for steam network hydraulic calculation is put forward. The influence of steam being as elastic medium on the section pressure drop is considered in this method.
提出了可用于蒸汽管网水力计算的分段积分法，该方法考虑了蒸汽作为弹性介质对管段压力损失的影响。
Design principle of hydraulic system on whole section tunneler and the application of proportional technique are introduced in this article, starting from a typical system.
本文从一个典型系统人手，介绍全断面隧道掘进机液压系统的设计原则和比例技术的应用。
Taking the outlet section as a special hydraulic element, the hydraulic transient process under the free outflow mode of pump system is calculated herein with the method of characteristics.
将泵系统出口段作为一种特殊水力元件，应用特征线法计算泵系统自由出流下的水力过渡过程。
This design topic is the entire plunger elevator design, it mainly includes three partial contents: Host computer design, hydraulic system design, control section design.
本次设计的题目是全液压升降机的设计，它主要包括三个部分的内容：主机的设计，液压系统的设计，控制部分的设计。
The structure of the derrick is triple-section telescoping structure, substructure is parallelogram structure, can be lifted by hydraulic cylinder.
井架采用三节伸缩式结构，底座采用平行四边形结构，能用液缸整体起升。
The design method of U-shaped channel optimal hydraulic cross section and the calculation equation used to determine the bottom circle's radius of U-shaped channel is proposed in this paper.
提出了U形渠道水力最佳断面的设计方法，并给出了确定U形渠道水力最佳断面底弧半径的计算公式。
Hydraulic transients in piping systems are usually calculated by one-dimensional theory, in which real 3-d piping is replaced, by an equivalent straight conduit with the same cross section.
管道系统的水力过渡过程通常是采用一维理论进行计算的，因此实际的三维管道通常采用沿中心线延伸变成具有相同过流断面的等效直管来代替。
The Cd increased with the depth-width ratio of notch cross-section, and increased to some extent with the hydraulic diameter of notch cross-section.
流量系数随矩形节流槽截面深宽比增大而增大，并随截面水力直径增大而有所增大。
Based on the basic critical flow equation, formulae, which used to determine section factor Z and hydraulic exponent M for critical flow in city gate and horseshoe conduits, were derived.
针对水利工程上常用的城门洞形及马蹄形过水隧洞，利用临界流方程，给出了旨在用于临界流分析的断面参数Z和水力指数M 的计算公式和表示水深与Z以及M 之间的关系曲线。
The optimum passage section figure of rectangle is square, and the rectangle has 4 optimum comer circular arcs which make the hydraulic loss of friction loss of per unit length passage the least.
矩形流道断面以正方形为最优，且存在最优角圆，使单位长流道沿程水力损失最小。
The hydraulic calculation for cleaning of alluvial plain in the tailrace outlet section of Jintang Hydropower Project was made to reduce excavation quantity of the alluvium plain o…
在上游蓄水高程一定的情况下，尽量保持尾水出流平顺和降低尾水高程是增加电站机组出力、提高经济效益的重要手段。
The hydraulic calculation for cleaning of alluvial plain in the tailrace outlet section of Jintang Hydropower Project was made to reduce excavation quantity of the alluvium plain o…
在上游蓄水高程一定的情况下，尽量保持尾水出流平顺和降低尾水高程是增加电站机组出力、提高经济效益的重要手段。
应用推荐