These are the results of possible variations in fluid properties, flow rates, scaling or deposits on the heat transfer surfaces.
这些是在流体性质，流动速率，传热面上的缩放和沉淀中是可能变动的结果。
The air loop (102) is used to chill ambient air that is blown across heat transfer surfaces of equipment mounted in data center racks (110).
空气环路(102)用于使吹过安装在数据中心机架(110)中的设备的传热表面的环境空气冷却。
Water velocities, temperatures of the heat transfer surfaces and system configuration also affect the tendency of a system to form and accumulate scale.
水速度，热移动表面和系统结构的温度也影响系统的趋向形成而且累积刻度。
The formation process of calcium sulphate deposition during subcooled flow boiling heat transfer was reported. Fouling runs were carried out at different flow velocities and heat transfer surfaces.
在过冷流动沸腾条件下，对硫酸钙的沉积过程进行了研究，考查了不同流速和不同加热器表面条件下硫酸钙的结垢状况。
Modeling the heat transfer capacity of cleanly heating surfaces based on statistical analysis.
建立了基于统计分析的锅炉清洁受热面传热量的计算模型。
A new physical model of condensation heat transfer on cosine-type corrugated surfaces is presented.
本文提出了在余弦型波纹表面上进行冷凝传热的一个新物理模型。
The calculation model of heat transfer entropy productions of convective heating surfaces of boiler is set up, and the calculating formula of heat transfer entropy production is presented.
建立了锅炉对流受热面传热熵产的计算模型，并给出了传热熵产生数的计算公式。
Therefore , the rule of the influence of the specialty of different anticorrosion surfaces on the flue gas forced convection heat transfer with condensation was obtained.
从而得出不同镀层表面特性对烟气受迫对流凝结换热的影响规律。
In this paper theoretic and experimental researches on the heat and mass transfer on corrugated plate surfaces are carried out.
本文正是通过理论和实验计算两方面来分析波纹板片上的强化吸收传热传质问题。
New physical models of condensation heat transfer on semicircle type corrugated surfaces were presented.
本文提出了一个半圆型垂直沟槽管冷凝传热的物理模型。
Conventional heat exchangers of convective heat transfer for the recovery of diesel exhaust heat suffer from easily fouled heating surfaces and a low heat transfer factor.
传统的对流换热式柴油机余热锅炉存在受热面容易污染和传热系数低的缺点。
Simplified heat transfer models like cylindrical surfaces and fins are used for calculating the overall heat transfer coefficients of gland blocks, stationary blades and diaphragms.
采用圆筒壁与肋片传热等简化模型来计算汽封块、静叶和隔板的传热过程总传热系数。
Researches on boiling heat transfer enhancement on porous surfaces are reviewed.
本文综述了多孔表面用于强化沸腾传热的研究工作。
The method has been proved to be successful for high resolution measurements in internal heat transfer on surfaces with complex geometries.
瞬态液晶技术用于复杂几何表面传热系数高分辨率的测量是成功的。
The effects of heating ways, geometric surfaces and working media on hysteresis are studied in boiling heat transfer, and the ways of lessening hysteresis are proposed.
本文研究了沸腾传热过程中不同加热方式，不同几何结构表面和工作介质对沸腾滞后的影响，并提出了减少滞后对沸腾传热影响的措施。
In this paper, theoretical analysis and experimental investigations are carried out of condensation heat transfer on the porous surfaces of horizontal tubes.
本文对水平管多孔表面的凝结换热进行了理论分析和实验研究。
The theoretical models for description of the heat and mass transfer on surfaces of fillers in cooling towers are related to an empirical coefficient the mass transfer coefficient.
冷却塔填料表面传热传质过程的理论计算都与一个经验参数——传质系数有关。
The heat transfer was augmented distinctly with increase of Reynolds number. The bleeding ratio also affects the value and distributions of heat transfer coefficients of all inner surfaces.
换热随雷诺数的增大而增强。出流比对各个面的换热分布及大小也有一定影响。
The effects of surfaces tension and gravity drainage on heat transfer of fin flanks are considered in the theoretical model.
对翅侧的换热，既考虑到表面张力的影响，又考虑到重力的作用。
Air side heat transfer and fluid flow characteristics of slotted fin surfaces with arc-type and X-type strip arrangement in a pressurizing air cooler were studied by visualization experiments.
对附带亲水层和没有附带亲水层的开缝翅片管换热器在析湿工况下的空气侧特性进行了实验研究，分析了亲水层对空气侧换热和压降特性的影响。
The difference of heat transfer between the leading and trailing impingement surfaces decreases with the rotating velocity increasing.
同时前尾缘冲击面换热的差别随着转速的增加将越来越小。
Evaporation heat transfer inside the micro-structure of porous surfaces;
本文综述了多孔表面用于强化沸腾传热的研究工作。
Evaporation heat transfer inside the micro-structure of porous surfaces;
本文综述了多孔表面用于强化沸腾传热的研究工作。
应用推荐