But there are materials that can directly convert heat into electricity without running some working fluid through a traditional generator.
而现在有种材料，无需工作流体通过传统发电机就可以直接将热能转化为电能。
Heat turns water to steam, steam moves turbines in the electric generator.
热量把水变成蒸汽，蒸汽带动发电机里的涡轮机。
Bioelectricity is created the same way fossil fuel-generated electricity is: Biomass is usually burned to generate heat, turning water to steam and driving an electrical generator.
生物电能的产生跟化石燃料的产生的电能相同：生物物质经常被焚烧产热，把水变成蒸汽，然后驱动发电机。
The concentrated sunlight is used to heat water, generating steam which is used to turn a traditional turbine and generator to produce electricity.
集中后的光线可用于给水加热，产生用于传统涡轮和发电机的蒸汽并进行发电。
Although we didn't have electricity for 10 days, we had a generator to run a small portable air-conditioner in the stifling heat.
尽管我们10天都没有电，但是我们有一台发电机来带动便携式空调来驱除炎热。
Heronomus contends that an electricity generator making use of ocean heat would be economically competitive with conventional sources.
赫隆若马斯坚持认为：利用海洋热能发电在经济上比传统能源有竞争性。
The initial phase of reactor cooldown is accomplished by transferring heat from the reactor coolant system to the steam and power conversion system through the steam generator.
停堆初期（第一阶段）的冷却过程：通过蒸汽发生器将反应堆冷却剂系统的能量传输给二次侧的蒸汽。
Condenser: vapor of the refrigerant from the generator is cooled down by the cooling water running in the heat transfer tubes of the condenser thus becoming condensate after condensation.
冷凝器：在发生器中产生的冷剂蒸汽，被冷凝器传管内流动的冷却水冷却，冷凝后变成冷剂液体。
When the temperature of heat source is relatively low, the falling film generator in the lithium bromide absorption machine can improve its heat and mass transfer performance.
热源温度较低时，在溴化锂吸收式制冷机或热泵中使用降膜式发生器可以改善传热传质的性能。
Online calculation of heat to power output efficiency of thermal generator set is important for the load coordination control in the CFB boiler thermal generator set.
为解决循环流化床锅炉发电机组负荷变化时的机炉协调控制问题，需要对发电机组的热功效率进行在线计算。
Numerically simulates the pressure distribution and heat transfer characteristics of fluid in a new vortex generator with different conic angles and different inlet sizes.
数值模拟了流体在不同圆锥角度和不同入口尺寸的新型涡旋发生器中的压力分布和传热特性。
Presents several heat exchanging modes of the diesel generator room and the composition of heat release.
介绍了柴油发电机组的几种换热方式与发热量的构成。
Heronomus contends that electricity generator making use of ocean heat would be economically competitive with conventional sources.
赫隆诺马斯坚持认为：利用海洋热能发电在经济上比传统能源有竞争性。
Discharge of plasma generator in electrothermal launchers is a main process of converting electrical energy to heat energy.
在电热化学发射中，等离子体发生器的放电过程是电能转化为热能的重要阶段。
The falling film generator is applied in the lithium bromide absorption chiller and heat pump.
降膜式发生器在溴化锂吸收式制冷机与热泵中得到了一定的应用。
Low alloy heat-resistant steel is widely applied to large steam turbine generator equipment.
低合金耐热钢广泛应用于大功率汽轮机等发电设备中。
Based on practice, this paper discusses how to improve the load capacity of generator when heat supply is at a certain level.
本文结合本厂实际，对在供热量一定时，如何提高发电机的负荷能力做了有益的探索，并提出了具体解决办法。
The working principle, structure and parameters design of plasma arc generator for heat treatment are described. Experiment has shown that it has good effect on partial surface hardening.
论述了用于金属材料表面热处理的等离子弧发生器的工作原理、结构特点和参数设计。试验证明这种发生器对材料的表面局部硬化非常有效。
The whole structure of the unit was involved, and the applied equipment of waste heat of exhaust gas, a new evaporator and generator was also designed.
简要说明了机组整体的布置，并设计了实用型尾气余热利用装置以及新型蒸发器和发生器。
The heat-transfer area demand of the heat-exchange equipments, such as generator, condenser, evaporator, absorber and solution heat exchanger, are computed.
进行了发生器、冷凝器、蒸发器、吸收器、溶液热交换器等换热设备所需的传热面积计算。
The paper presents status of failure incidents of PWR steam generator heat transfer tubes in Japan as well as causes of failure and measures used for protection.
本文介绍日本压水堆核电站蒸汽发生器传热管破损情况，破损原因和防止传热管破损的措施。
The results would offer theoretical basis for control system of heat recovery steam generator in the combined cycle.
研究结果为联合循环余热锅炉控制系统的设计提供了理论依据。
This article has described the research and upgrading of the final heat treatment process for the generator shaft end, the optimized process has been selected and put into the operation.
对发电机轴端头的最终热处理工艺进行了研究和改进，筛选出了最佳工艺条件并进行了实施。
The calculation of the temperature field of large synchronous generator is the main means analyzing the heat of generator.
发电机温度场计算是研究发电机发热的主要手段。
Discussed the selecting principle of pinch point and approach temperature point it is belong to the HRSG (heat recovery steam generator) of minitype combined gas-steam cycle.
论述了小型燃气—蒸汽联合循环中余热锅炉节点温差和接近点温差的选取原则。
The heat is then channelled through a conventional generator.
热然后被引导过一个传统的产生器。
The heat is then channelled through a conventional generator.
热然后被引导过一个传统的产生器。
应用推荐