Heterogeneous bridging groups can raise the glass temperature according to their chemical composition.
不同类桥联基团根据它们的化学组成能提高玻璃化温度。
By studying the several important control indicators of glass powder, such as crystallization, glass temperature, the optimum proportion of glass powder is made certain.
通过研究玻璃粉的几个重要控制指标如析晶、玻璃化温度，确定了玻璃粉的最佳配比。
On the other hand, both the glass temperature and cold crystallization peak temperature of PEEK increases and melting peak strength decreases while the melting time becomes longer.
熔融时间延长时，聚醚醚酮的玻璃化转变温度和冷结晶峰温度均提高，熔融峰强度减弱。
If all of the material is heated to the glass transition temperature, no folding will occur.
若所有材料以玻璃转变温度进行加热，那就再不能进行折叠了。
First, the surface temperature of the hinge must exceed the glass transition temperature of the material, which is the point at which the material begins to soften.
第一，折痕表面温度必须超过材料向玻璃过度的温度点，即材料开始变柔软的温度点。
The noncrystalline structure is achieved by relatively rapid cooling below what is referred to as the glass transition temperature, around 1, 000 degrees Fahrenheit for the soda-lime variety.
它不结晶的结构往往是通过在玻璃化转变温度以下迅速冷却而得到，对于碱石灰玻璃而言，大约在华氏温度1000度左右。
Kim said, "We will be able to use a low-temperature polycrystal silicon with the sixth-generation size glass substrate."
Kim称：“我们现在已经可以在6G尺寸级别的基板上应用低温多晶硅技术。
Put a food thermometer in a glass of water on the middle shelf, where the air temperature is most accurate. Leave it there overnight and take a reading in the morning.
将食物温度计放在一杯水中，摆在一架子的中层——温度最准确处，过夜后，于第二天早上读取度数。
The temperature of glass creates suction that supposedly helps treat pain and relieve muscles of knots and swelling.
玻璃杯的温度所产生的吸力大概能治疗疼痛并缓解肌肉硬块、肿胀的症状。
Send thickness of the glass can be processed in accordance with the relevant requirements of glass conditioning, heating temperature may need to set in advance.
玻璃传送厚度可根据有关加工玻璃工艺要求调节，加热温度可按需要事先设定。
This article obtained foam temperature of foam glass by means of gradient furnace.
用梯温炉法确定了泡沫玻璃的发泡温度。
It is found that the bending strength of gauge glass increases when the temperature decreases.
随着温度降低，玻璃板的抗弯强度测定值增加。
Meanwhile , the absorption of carbon black on PVC molecular chain can reduce the flowability of PVC, but can increase its glass transition temperature and mechnical property.
同时，由于炭黑吸附在PVC分子链上，降低了PVC的流动性，即降低了加工性能，但提高了其玻璃化温度和力学强度。
Glass transition temperature goes up with the hard segment content increase. Heat history affect on glass transition of polymers apparently.
受热史对聚合物的玻璃化温度有较大的影响，随着硬段含量的增加而变大。
The glass transition temperature (T_g), tensile and impact strengths, and the solution viscosity of the PMMA plate increased with the increase of M_w.
板材的玻璃化温度、拉伸强度、冲击强度和溶液黏度均随摩尔质量的增大而增大。
The composition of carbohydrates in concentrated orange juices (COJ) and its effects on glass transition temperature and viscosity of the products were investigated.
研究了浓缩橙汁中的碳水化合物组成以及它们对产品的玻璃化转变温度和粘度的影响。
Below the glass strain temperature, interdiffusion coefficients are almost independence of sodium oxide concentration in the glasses and somewhat increase with long ion exchange time.
低于玻璃应变温度，互扩散系数几乎不依赖玻璃中的氧化钠浓度，而略随离子交换时间增加而增大。
Although the glass shape did not affect the concentration of ethanol vapor, the temperature did, with chilled champagne releasing less ethanol, but the same amount of carbon dioxide.
虽然酒杯的形状并不影响乙醇蒸气的浓度，但对于释放少量乙醇的冰镇香槟而言，酒杯形状却能对相同数量的二氧化碳产生影响。
The results shows that epoxy resins containing rigid rod structure or many epoxy groups have a high glass transition temperature (Tg) because of high cross-linking density.
研究结果表明：分子结构中含有刚性结构或连有较多的环氧基时，固化产物具有较高的交联密度，玻璃化转变温度较高；
This paper presents our study on the effect of fillers on mechanical damping of chlorinated butyl rubber above its glass transition temperature, Tg.
本文研究了填料对氯化丁基橡胶在玻璃化转变温度以上的温度范围里的力学阻尼行为的影响。
It is very important to truly determine the glass transition temperature of food to improve the conditions of food processing and storage.
准确测量食品的玻璃化转变温度对改进食品的加工和贮藏条件非常重要。
A model describing the free volume change with temperature in polymer glass is proposed.
提出了一个在聚合物玻璃体中自由体积随温度而变化的模型。
Thus, the quantitative relations between the fusion quality and the fields of velocity and temperature for glass melt were found.
这两个指数建立了玻璃熔制质量与玻璃液速度场和温度场的定量关系。
The calculating results are in good agreement with experimental values by using group - contribution technique to calculate glass transition temperature of biopolymers and its blends and copolymers.
应用基团贡献法计算生物高聚物及共混、共聚的玻璃化转变温度，计算结果与实验值吻合较好。
The thermal analysis was used to determine the crystallization temperature, the glass transformation temperature and low temperature relaxation temperature of the amorphous samples.
通过对非晶态样品的热分析，确定了它的晶化温度、玻璃转变温度和低温弛豫温度。
The temperature distribution of glass plate must be solved simultaneously with roller's temperature field which varies with heating time.
传动辊温度随加热时间而改变，在计算玻璃板温度时，必须与传动辊的温度场耦合求解。
The temperature distribution of glass plate must be solved simultaneously with roller's temperature field which varies with heating time.
传动辊温度随加热时间而改变，在计算玻璃板温度时，必须与传动辊的温度场耦合求解。
应用推荐