The results may be used as fundamental solutions to solve a general crack system of plane.
该结果可作为基本解用于求解一般裂纹系问题。
This paper presents a fundamental solution which can be used to solve the general radial crack system on half-plane. An example is given for check up.
本文给出了可用于解决半平面上一般射线裂纹系的基本解。文中作了例题验证。
Starting from a general case for problems of torsion-bending of a cylinder, a so called crack-cutting method is presented in this paper.
本文从柱体的扭转-弯曲问题的一般情况出发，介绍裂纹切割法的基本思想。
However to the large deformation shaft without crack, general predictive theory has been applied to built up the multi-steps straightening stroke predictive algorithm.
针对单弧度弯曲大变形无裂纹轴校直问题，根据广义预测控制理论，建立了多步校直行程预测算法。
On the one hand, by calculating the general dimension of the measured signal and extracting its sensitive dimension, the crack fault of measured signal is diagnosed and identified.
一方面，通过计算实测信号的广义维数，提取其敏感维数，进而对实测信号的裂纹故障进行诊断识别。
The crack in windowsill in the first storey is a general defect in architecture.
首层窗台裂缝是建筑工程中常见的质量通病。
This paper discusses the energy release of crack and cut in propagation under general boundary conditions and points out that the use of force potential can result in an error under these conditions.
本文讨论了一般边界条件下裂缝扩展的能量释放，指出了此时运用力势概念所能导致的错误。
Plastic deformation takes place first at the crack tip and spreads across the solid as the applied load is increased beyond general yielding.
塑性变形首先发现在裂纹顶端，当工作载荷超过了普通屈服时，则传播到物体中。
It is shown that in general cases, the field intensity factors increase as the ratio of crack length to hole-size become large.
结果表明：应力强度因子随着裂纹和孔的相对尺寸的增加而增加。
Aimed at the general reason of cracks of mass concrete, the calculation of temperature and the analysis of crack were made.
针对大体积混凝土裂缝的原因，进行了温度计算和抗裂分析。
Combining general four-node element around crack tip element, a hybrid-stress finite element model is developed, Accordingly a hybrid finite element method to fo.
与四节点单元相结合，提出一种求解自由边界面端部广义应力强度因子的杂交元法。
The paper studies the applicability of caustics to rock type media, hoping to have a general view of the caustics speckles surrounding the crack tip.
对焦散线法在岩石类介质的适用性进行研究，期望获得裂纹尖端周围焦散斑的大致情况。
Combined with general four-node element around crack tip element, a new hybrid finite element method to study stress intensity factors for interfacial crack is introduced.
与四节点单元相结合，由此提出了一种新的求解应力强度因子的杂交元法。
The general reason of cracks of mass concrete is introduced, it gives the calculation of temperature and the analysis of crack.
针对大体积混凝土裂缝的原因，进行了温度计算和抗裂分析。
One of the important performances of polyethylene cable jacket materials is environmental stress-crack resistance, while general-purpose LDPE resin cannot meet all kinds of demands.
聚乙烯电缆护套料的重要性能之一是耐环境应力开裂(ESCR)性能，普通的LDPE树脂不能满足要求。
Both the RC beams with cracks filled under loading and general RC beams have some maximal crack heigh about 0.7 ~ 0.8 times the test beam height.
持荷封闭裂缝梁与普通钢筋混凝土梁一样，都存在着止裂高度，即裂缝高度基本都稳定在梁高的0.7倍0.8倍。
The general problem of half-pipe jacket is the leakage of the welding line induced by crack.
半圆管夹套设备最常见的问题是夹套焊接部位开裂引起泄漏。
Abstract: General machinery combination lock password is easy to crack, therefore its security has been a serious threat.
摘要：普通机械密码锁的密码容易被破译，因此其安全性已受到严重的威胁。
Abstract: General machinery combination lock password is easy to crack, therefore its security has been a serious threat.
摘要：普通机械密码锁的密码容易被破译，因此其安全性已受到严重的威胁。
应用推荐