Moreover, the friction angle' s change rule and the reasons of different granules were analyzed and pointed out under the same water ratio.
在此基础上进一步分析了不同粉砂粒含量的土在相同含水率时的摩擦角变化规律及其原因。
Analyses parameter have inclined Angle, pipe diameter size, gas liquid ratio and friction factor and so on.
分析参数有：倾斜角度、管径大小、气液比和摩阻系数等。
Based on the tire magic formula model, the dynamic variation process of the tire optimal slip ratio and the maximum friction coefficient on the road with the vehicle velocity is researched.
基于轮胎的魔术公式模型，研究了轮胎在路面的最佳滑移率和最大摩擦系数随汽车速度的动态变化过程。
The present study shows that there is a critical seal pressure which is only related to the compression ratio and the friction coefficient, but does not depend on the radius of the elastomer ring.
分析结果表明，临界密封压力只与橡胶圈的压缩量和密封面摩擦系数有关，与橡胶圈截面半径无关。
For the sake of the tyre works under optimal slip ratio, a braking variable structure control (VSC) law based on slip ratio control was introduced so as to obtain the maximum friction coefficient.
飞机防滑刹车控制的关键是控制机轮的滑移率，为了使机轮工作在最佳滑移率，得到最大结合系数，提出了一种基于滑移率控制的防滑刹车变结构控制律。
It is found that the load critical depth and the friction range increase while the cap breadth increases with the same replacement ratio.
发现置换率相同时，承台板宽度大，水泥土桩的荷载临界深度也大，桩侧摩阻力分布深度下移。
Both the ratio of friction velocity to free stream wind velocity and the thickness of airflow are subject to the sidewall effect, showing the increase trend with the decreasing aspect ratios.
随着风洞宽高比的减小，断面内中垂线上的气流摩阻速度与自由流速的比值以及受风洞边壁影响的气流厚度均增大。
Axial force transmission, distribution of skin friction, tip resistance of pile, as well as tress ratio between pile and soil are changing with pillow.
研究了褥垫层厚度变化对桩身轴力传递、桩侧摩阻力分布、桩端阻力发挥、桩土荷载分担及桩土应力比的影响。
We have also analysed the ratio between tangential forces and normol forces with respect to both chip formation forces and friction forces. The ratio generally falls within the range of 0.2~0.59.
从切屑变形力与摩擦力两方面分析了切向磨削力与法向磨削力的比值，大体上应在0.2～0.59范围内。
Otherwise, the development of human resources as the first resource will bring to the enterprise internal friction, so that the input-output ratio reduction.
否则，人力资源作为企业开展的第一资源将会给企业带来内讧，使投入产出比降低。
Z6, Semi-ceramic with low asbestos fibers. High friction coefficient, high temperature tolerance and less wear ratio.
半陶瓷低石棉型，特点：高温热稳定性好，刹车舒适，无噪音，摩擦系数稳定，耐磨性好， 米黄色。
Z6, Semi-ceramic with low asbestos fibers. High friction coefficient, high temperature tolerance and less wear ratio.
半陶瓷低石棉型，特点：高温热稳定性好，刹车舒适，无噪音，摩擦系数稳定，耐磨性好， 米黄色。
应用推荐