That should allow you to also calculate the friction coefficient.
你们同样可以，计算摩擦系数。
The friction coefficient decreases with the increase of load.
随载荷的增大摩擦系数减小；
I'll give you the Angle and I want you to calculate that friction coefficient.
我会读出角度，你们帮我计算摩擦系数。
Friction coefficient increased with abrasive size and concentration increased.
当磨料的添加量和粒度增加时摩擦系数增大。
Advantages: good toughness, low friction coefficient of the ruby head, long life.
优点：有较好的韧性，宝石头部摩擦系数低，具有超长的使用寿命。
Low friction coefficient guides to ensure that the barrel weight fully to the mattress.
低磨擦系数导轨，保证滚桶重量完全作用于床垫上。
Typically, the staticfriction coefficient is higher than the kinetic friction coefficient.
静摩擦系数典型地高于动摩擦系数。
If the roll core is made of special materials, smaller friction coefficient of tile can be used.
客户的卷芯如果是特殊材料制造的，可采用摩擦系数较小的瓦片材料。
And more significantly, it has very low friction coefficient and nice self-lubricating properties.
更有意义的是它具有超低的摩擦系数和优良的自润滑性能。
The humidity results in low friction coefficient, but the braking presure will decrease the effect.
湿态环境下平均动摩擦系数降低，但随着压力的增大，这种影响减小。
It is the high surface energy that contributed to larger friction coefficient of polyurethane threads.
高表面能引起的粘着为聚氨酯摩擦系数较高的主要原因。
The low density graphite gets higher friction coefficient and bulk worn loss than the high density graphite.
低密度石墨的摩擦系数和体积磨损量比高密度石墨材料高。
So you should be able to calculate what the friction coefficient is using the equation tangent alpha equals mu s.
你们则需要学会,计算摩擦系数,使用μ静=tanα这个公式。
In the default model the friction coefficient is defined as afunction of the equivalent slip rate and contact pressure.
在默认模型里，定义摩擦系数为等效滑移率和接触压力的函数。
The variation of local friction coefficient is similar to velocity and local minimum value occurred in reverse flow area.
摩擦阻力的变化趋势与速度类似，在产生逆向流处出现局部极小值。
That should allow you to calculate the static friction coefficient and you'll get a chance to do that in your third assignment.
这样一来，请计算静摩擦系数，它将作为你们第三次作业的，一部分。
The experimental results indicate that this material possess low friction coefficient and excellent antifriction property.
试验结果表明：此各材料具有较低的摩擦系数和良好的减摩耐磨性能；
It is found that the friction coefficient increases with the increase of sliding velocity, and there is critical velocity.
试验发现，摩擦系数随滑动速度的增加而增加，存在临界滑动速度。
When selecting brake shoe, the dynamic friction coefficient must fulfill the request of both brake capability and stability.
选择鼓式制动器摩擦片时，动摩擦系数的选择既要满足制动性能，同时也要满足稳定性。
However, the friction coefficient between Ni and APS increased with sliding velocity increasing and reduced with load increasing.
而镍与APS间的摩擦系数随滑动速度的增大而增大，随载荷的增大而减小。
Hardness and friction coefficient of the three composites were determined to investigate the influence of particle type and content.
研究了颗粒性质和含量对复合材料硬度、摩擦系数和耐磨性能的影响。
If indeed the friction coefficient is independent of surface area, then when I tilt them they should start to slide roughly at the same Angle.
若摩擦系数真的，与接触面积没有关系，那么两者下滑时的角度，应该基本相当。
The effects of metal base content and NiCr alloy addition on hardness, friction coefficient and wear rate of the composites were studied.
研究了金属基体及其中镍铬合金的含量对复合材料的硬度、摩擦系数和磨损率的影响。
The real-time identification of material properties and friction coefficient is as the key to intelligent control of deep drawing process.
材料性能参数和摩擦系数的实时识别是实现拉深过程智能化控制的关键。
Friction coefficient of different tobacco package paper was measured, and the data was analyzed and compared with these different parameters.
通过对不同的烟标纸进行摩擦系数的测试，比较并分析了不同因素对烟标纸摩擦系数的影响。
The friction coefficient is decreased with brake pressure increasing for constant initial rev and also decreased with initial rev increasing.
当初始转速恒定时，摩擦系数随刹车压力的增大而减小；
The total adhesive friction coefficient is expressed as a combination of adhesive friction coefficients in elastic and plastic contact regime.
总的粘着摩擦系数被表示为弹性接触区与塑性接触区的粘着摩擦系数的组合。
Under normal production conditions, the die angle, friction coefficient, tube material and material temper can be neglected in the calculation.
双周数表通用性较强，在一般的生产条件下，可以不考虑模角、摩擦系数、管材材质及其状态等因素；
The result shows that load, seal gap and seal height have influence on the maximum stress while friction coefficient has little influence on it.
分析表明，载荷、密封间隙、橡胶密封筒高度对应力最大值有影响，而摩擦系数影响很小。
The result shows that load, seal gap and seal height have influence on the maximum stress while friction coefficient has little influence on it.
分析表明，载荷、密封间隙、橡胶密封筒高度对应力最大值有影响，而摩擦系数影响很小。
应用推荐