Joint time frequency analysis method is a powerful tool for study of this kind of signal.
联合时频分析的方法是研究这类信号的有力工具。
In this paper, the pilot subcarriers on two consecutive OFDM symbols are utilized for joint frequency offset correction and channel estimation.
基于连续OFDM符号上的导频子载波,给出了联合频率偏移纠正和信道估计方法。
The location of joint surface has a close relation with the natural frequency of the structure.
接合面的位置对结构的固有频率也有较为明显的影响。
The fitting difference is reduced and the precise of quantitative interpretation is improved by means of joint TF inversion with time and frequency window data.
利用时间窗数据和频率窗数据所进行的联合时-频反演,缩小了拟合差,提高了定量解释精度。
This paper describes a novel joint acquisition algorithm of timing and carrier frequency for burst orthogonal frequency division multiplexing (OFDM) transmission system.
提出了一种新的正交频分多路(OFDM)传输系统定时和载波频率捕获联合算法。
In this paper, a new cumulants-based method for the joint estimations of frequency and DOA of spatial signal was discussed.
提出了一种基于频域高阶累积量的信号频率和到达角联合估计算法。
Therefore, we can identify the joint sounds according to the energy, frequency, amplitude and occurring time of the vibration on the joint sound sonogram.
根据关节音的声谱图特征,从关节音振动能量、频率、振幅、发生时间等方面对关节音进行鉴别,可能有助于判断颞下颌关节的功能状况。
The results indicate that it is more accurate to estimate joint frequency by using probability matrixes than frequency matrixes.
结果表明,在计算联合频率中应用风向和风速概率矩阵比应用频率矩阵更准确、可靠。
A joint blind estimation method based on spectrum overlap for uplink interleaved orthogonal frequency division multiple access carrier frequency offset and timing synchronization is proposed.
提出了一种基于功率谱叠加的交织正交频分多址系统上行链路载波频偏和定时同步联合估计算法。
Joint frequency and phase modulation (JFPM) utilize frequency and phase information to realize higher efficiency in the frequency and power.
联合频率相位调制(JFPM)同时利用频率信息及相位信息,具有较高的频带利用率和功率效率。
And the effects of parameters such as joint deformation and incident frequency of wave on the intensity variation of EME were investigated.
同时,研究节理的变形和入射波频率对电磁辐射强度的影响。
The reason of the Weld Joint Cracking on high frequency welding pipe was investigated by using macroscopic observation, metallographic technology, fracture analysis and EBSD technology.
本文通过使用宏观观察、金相分析、断口分析和电子背散射衍射(EBSD)等分析手段对高频焊管焊后弯管开裂的原因进行了分析。
Analysis of harmonic response found out the peak frequency of the joint possible to resonate and the stress and strain under peak frequency.
谐响应分析主要是研究联轴器的幅频响应特性,分析其可能的共振峰值频率以及峰值频率下的应力应变情况。
Investigates the problems of joint 2-d angular and frequency estimation based on uniform circular array (UCA).
研究均匀圆形阵列的联合二维角度-频率估计问题。
Objective To evaluate the diagnostic value of high frequency ultrasound in synovial diseases of the knee joint compared with the results of arthroscopy.
目的通过与关节镜结果检查对照,评价高频超声对膝关节滑膜病变的诊断价值。
This method analyzes VHF and UHF signal of detected cable joint, using time and frequency analysis. This method can be used for detecting PD pulse inside or outside the insulating joint.
该法对电缆绝缘接头处VHF和UHF信号的时域和频域分析可有效地识别被测电缆绝缘接头部内、外部的局放信号。
The joint interface is like a low filter, the higher frequency will be easily reflected, and the lower frequency will be easily transmitted.
节理面呈现出低通滤波器功能,频率越高越容易被反射,越低则越容易透射;
Based on the analysis, a new method to detect carrier frequency of FSK signal named time-domain joint and modern power spectrum estimation is put forward.
对电力远动通道FSK信号进行了时域和频域分析,在此基础上提出了一种新的FSK信号载波频率测量方法—时域拼接结合现代功率谱估计的方法。
An L-shaped band elimination filter on the T-shaped joint part is also used for restricting the resonance of the frequency multiplication of the first resonance frequency.
位于T形接合部上的L形带阻滤波器亦用来抑制第一谐振频率的倍频的谐振。
Based on the analysis of test results, the effect of both the surface topography and loading frequency on the joint closure behavior is discussed.
通过对试验结果的分析,获得加载频率和表面形态对节理闭合变形性质的影响规律。
This coaxial joint component combines two joints working on the same frequency. It is characterized by wide band, small VSWR and low insert loss.
这种交连组合采用同轴结构,将两路工作频率相同的交连有机地结合在一起,具有宽带、小驻波、低损耗特点,且体积小、重量轻。
Generalized into local frequency from integral frequency, the method of joint time-frequency distribution effectively analyzes the signal based on the variation of frequency with time.
联合时频分布方法把整体频谱推广到局部频率,根据频率随着时间的变化情况,对信号进行有效的分析。
Sonographic patterns of joint effusion were: anechoic, cloudy, mixed and snow-storm on high-frequency ultrasound.
关节囊积液的声像图特征为无回声、云雾状、混合状和暴风雪状。
Objective to investigate the diagnostic value of high-frequency ultrasound on knee joint diseases of rheumatoid arthritis (ra).
目的探讨高频超声在类风湿性关节炎(RA)膝关节病变中的诊断价值。
Methods 312 knee joint in 156 patients with ra were studied with high-frequency ultrasound and color doppler flow imaging.
方法选择156例RA患者312个膝关节行高频超声检查,观察二维声像图和彩色多普勒血流成像特征。
Conclusion High-frequency ultrasound and MRI are valuable imaging methods in the diagnosis of synovial diseases of the knee joint and provide useful information clinically.
结论高频超声和MRI在诊断膝关节滑膜病变方面均有一定的优势,可为临床提供客观信息。
At present, the joint estimation methods of time delay and frequency shift for satellite interference localization are mainly based on the principle of correlation, such as CAF algorithm.
目前,卫星干扰源时延和频移定位参数的估计主要采用基于相关原理的互模糊函数算法(CAF)进行联合估计。
As one of the best tools to analyze the non-stationary signals, it shows a good picture in the joint time-frequency domain and makes us know about the change of frequency along with the time clearly.
这种分析方法提供了时间域与频率域的联合分布信息,清楚地为我们描述了信号频率随时间变化的关系。
This paper chiefly studies joint symbol timing and carrier frequency synchronization.
本文主要研究载波和符号定时的联合同步。
The newly emerged JTFA (Joint Time-Frequency Analysis) method is a powerful tool in analyzing time-varying non-stationary signals.
近年来才兴起的时-频联合分析法是分析处理频率随时间而改变的非稳态信号的强有力工具。
应用推荐