The utility model relates to an electric ceramic water mixing valve which belongs to fluid valve control technical field.
本实用新型涉及一种电动陶瓷混水阀，属于流体阀门控制技术 领域。
The utility model relates to a fluid valve of self-balanced pressure, whose valve core is composed of more that two pistons.
本实用新型的阀芯至少由二个以上的活塞所组成。
The fluid valve of self-balanced pressure can meet the requirement of on-off of the pipeline working under the condition of high, middle and low pressure.
这种闸阀能够满足在高、中、低压条件下工作的管路通断的要求。
Vacuum pump's start order is: First turns on the driving fluid valve, pours into the driving fluid to the pump, then the starting motor, turns on the inspiration pipeline once more, normal work;
真空泵的启动顺序为：首先打开工作液阀门，向泵内注入工作液，然后启动电动机，再次打开吸气管路，正常工作；
Under the flow for spool valve closure and relatively easy changes in fluid pressure and flow and less.
对于阀芯下流动，阀门相对地容易关闭而且流体压力和流量变化和少。
AW pneumatic actuator used, make sure the valve opens, closing torque, and then do the valve using a fluid medium, added security value.
选用AW气动执行器时，先确定阀门启、闭的扭矩，再根本阀门使用的流体介质，增加安全值。
How it works: the piston moves from left to right, form a negative pressure pump cylinder, then the suction tank fluid through the valve into the pump cylinder.
工作原理：活塞自左向右移动时，泵缸内形成负压，则贮槽内液体经吸入阀进入泵缸内。
When the control valve when the reverse, so that both fluid along the direction of movement of spool when closed, the flow control valve capacity will be increased.
当调节阀反向使用时，既流体沿着使阀芯关闭的方向流动时，调节阀的流通能力会增大。
The in-line spring-actuated lift check also is referred to as the "silent check" because the spring closes the valve before gravity and fluid reversal can slam the valve closed.
由于这种止回阀能够在重力和介质倒流撞击启闭件之前关闭阀门，因此这种直通弹簧驱动升降式止回阀也称为“静音”止回阀。
Swing-type check off er the least pressure drop and offer simple automatic closure; when fluid flow stops gravity and flow reversal closes valve.
旋启式止回阀压降最小，能够完全自动关闭，即在介质流动停止、重力和介质倒流的状态下自动关闭阀门。
Slamming of check valves is the result of failure of the valve disc to reach its closed position before the fluid flow reversal.
止回阀的撞击现象，是由于在流体倒流之前，阀门的阀瓣没有到达关闭位置造成的。
Intercept the fluid medium upstream of the valve to be inspected with a shut-off valve and ensure that the subject valve is not under pressure (vent downstream, if necessary).
截取阀门上游的流体介质，用一个关闭阀门来进行检测，确保相关的阀门不处在压力下(如果必要的话，排除下游的流体介质)。
It consists of a compressor, a condenser, a throttle or expansion valve, an evaporator, and a working fluid (refrigerant).
它由压缩机、冷凝器、节流阀或膨胀阀、蒸发器，以及一种工作流体(冷冻剂)组成。
The use of rechargeable battery charging to the valve, fluid flow of the energy supplement for battery power.
利用充电蓄电池向阀门充电，流体流动产生的能量可为蓄电池补充电。
As a replacement of valve number 1 with Red valve's Type a and pneumatic fail-safe system 700, valve number 3 has accomplished an improvement in the fluid dynamics of the system.
作为1号阀的替代品，美国红阀公司A型夹管阀和无故障气动系统700，也就是左图中的3号阀，极大地改善了流体介质的流动性。
A type of valve, typically found on small-diameter pipework, that incorporates an orifice or flow-restriction device to control fluid flow.
一般用于小直径管道系统的一种阀。它包括一个用于控制流体流动的孔板或限流装置。
As a completion accessory, a circulation valve is included to circulate fluid for well kill or kickoff.
作业完井的一个辅助工具，循环阀用于在压井或启动时循环流体。
The valve rod (steel 35) is nitrided in the fluid soft nitriding process, the main material being made up of urea.
采用以尿素为主要原料的液体软氨化工艺，对阀杆(35钢)进行了氮化处理。
Right In the fluid control and shut down and so on, spool orientation is important for the spool valve core and valve.
对于流体的控制和关闭等，阀芯的导向十分重要，阀芯导向用于阀芯和阀座的对中配合。
Piping vibration or damage caused due to dynamic loads, such as mechanical vibration, acoustic vibration, fluid hammer, pulsation and relief valve discharge.
由于动荷载引起的管道震动和损坏，例如机械震动，声波震动，液击，压力脉动和泄放阀门泄放时引起的震动。
UK ROTORK valve (ROTORK) is Europe's main production area of fluid control and suppliers.
英国罗托克阀门(ROTORK)是欧洲地区流体控制领域的主要生产和供应商之一。
Valve repositioning allows fluid passage and sliding of the piston joins the first and second components.
重新定位阀 件允许流体通过，滑动柱塞使第一和第二组分会合。
A check valve that controls fluid flow rates to maintain a predetermined, constant pressure upstream from the valve.
为保持阀的上游的预定不变的压力所用的控制流体流量的一种止回阀。
A manual or automatic, conical needle in a seat valve that can be changed to alter the amount of fluid flow through it.
在座阀中的一个手动或自动的锥形针状体。对它进行调节就可改变流过的流体的流量。
Fluid end consists mainly of module, suction and discharge valve assembly, suction and discharge spring, suction and discharge pipe, plunger, packing, safety valve and pressure regulator, etc.
液力端主要由液缸、吸入、排出阀总成、吸入、排出弹簧、吸入管、柱塞、盘根、安全阀、稳压器等部件组成。
Reliability- The process fluid flows through the trim, flushing away solid deposits above and below the guide bushing , thus reducing the possibility of a sticking valve plug.
可靠性过程流体流动，通过修剪，冲掉上述固体存款和指导下套管，从而减少了一贴阀芯的可能性。
TYB series waterflood pressure regulating systems consist of two cylinder four chamber pump body, electro hydraulic reversing valve, control fluid circuit and control current circuit.
TY B系列调压注水装置由双缸四腔泵体、电液换向阀、控制液路及控制电路组成。
TYB series waterflood pressure regulating systems consist of two cylinder four chamber pump body, electro hydraulic reversing valve, control fluid circuit and control current circuit.
TY B系列调压注水装置由双缸四腔泵体、电液换向阀、控制液路及控制电路组成。
应用推荐