A fluid flow meter comprises a chamber having a fluid inlet and a fluid outlet.
一种流体流量计包括具有流体入口和流体出口的腔室。
Fill oil into the oil tank, when the hydraulic pump is full of oil fluid, manually turn the coupling, till there is no bubble in the oil outlet.
向油箱灌油，当油液充满液压泵后，用手转动联轴节，直至泵的出油口出油并不见气泡时为止。
The numerical analysis was performed on temperature distribution of the outlet nozzles in main vessel of SCWR(supercritical water reactor) by using computational fluid dynamics software CFX.
采用计算流体力学软件CFX对超临界水冷堆主容器出口管的温度分布进行数值分析。
The boundary and initial condition, such as the inlet of the primary fluid and the secondary fluid, the outlet of the injector are given, and make the relevant numerical disposal.
给出了可调式引射器工作流体和引射流体入口、引射器出口的边界条件以及初始条件，并进行了相应的数值处理。
The influence of the working fluid pressure and the structure of ejecting nozzle on the outlet temperature, ejecting coefficient and heating efficiency of the ejecting-mixing heater were analyzed.
对多喷嘴引射混合式加热器的加热性能进行了试验研究，分析了工作流体压力和引射孔结构对引射混合式加热器的出口温度、引射系数以及加热效率的影响。
Each fluid enters through its own pump inlet and outlet.
各种流体进入其自己的泵入口和出口。
The recess is preferably formed so as not to provide fluid, communication, from the inlet to the outlet across the rotor end surface.
所述凹部优选地这样形成，以使得流体不会经由凹部从腔室入口到 腔室出口横跨转子端面地流通。
The COP of conventional trans critical carbon dioxide air conditioning cycle depends strongly on the working fluid temperature at the gas cooler outlet.
常规跨临界二氧化碳空调循环的性能系数对气体冷却器出口工质温度十分敏感，该温度越低，同等条件下性能越好。
The chamber has an inlet in flow communication with the channel and an outlet in flow communication with the plurality of fluid flow paths of the heat exchange tubes.
该腔具有一与该通道流体连通的入口和一与热交换管的多个流体流动通路流体连通的出口。
The end section of the lower sleeve is the outlet of the air, liquid mixing fluid.
下套管末段为气液混合流体出口。
Results show that the measuring method with the conductivity electrode placed at the nozzle outlet can describe objectively the distribution of the tundish fluid flow.
结果表明，只有将电导电极置于水口出流部位的测定方法才能客观地反映中间包内流体的流场分布情况。
Numerical 3d simulation and research on inner nozzle and outlet flow field of solid rocket motor of long range missile designed by Russia using STAR-CD computational fluid software.
采用STAR - CD计算流体软件对某俄式发动机的喷管内流场及喷管出口处流场进行了三维的数值仿真与研究。
During the operation of heat exchanger networks (HEN) with varying operating conditions, bypass optimal control is considered an effective method to adjust outlet fluid temperature and save energy.
在换热网络的运行过程中其操作条件时常发生变化，旁路优化控制是调节物流出口温度、节能降耗的有效途径。
Uniform incoming fluid flowing velocity is set for entry of computation region and pressure boundary condition is inducted for outlet.
在计算区域的进口处给定均匀来流速度，在出口引入压力边界条件。
One method to improve fluid flow without compromising product quality would be to confine process temperature in creases to around the evaporator outlet.
一种能改善磷脂流动性又不损害磷脂质量的方法是提高浓缩器出口范围的温度。
The louver is in fluid communication with the air outlet passageway and includes a cover providing an aesthetic surface configured to face outward from front portion in the closed position.
所述百叶窗与所述空气出口通道流体连通且包括提供了有美感的表面的盖，所述表面被构造以便在所述闭合位置处相对于所述前部部分面朝外。
The 3-D transient internal fluid of the exhaust manifold has been simulated with the inlet and outlet boundary conditions calculated by the thermodynamics.
通过热力学计算得到排气歧管的入口和出口边界条件，计算排气歧管的三维瞬态内流场；
A fluid flow path (56) extends from the first suction channel (22) to the second suction channel (24) and from there to the outlet (34).
流体流动路径(56)从所述第一吸入通道(22)延伸到第二吸入通道(24)并且从那里延伸到出口(34)。
Check valves are automatic valves to prevent the media back, fluid from the inlet to outlet side to side.
止回阀是防止介质倒流的自动阀门，流体从进口侧流向出口侧。
The fluid flow control system of claim 3, further comprising a temperature sensor disposed in an outlet stream and in communication with the electronic control module to form a feedback loop.
如权利要求3所述的流量控制系统，进一步包括放置在出水口水流中与电子控制模块相连并组成反馈回路的温度传感器。
Both fluid liquid inlet and outlet are equipped on each gland, which connect to the fluid liquid channels for the frame and the cylinder sleeve through the port plates.
端盖上各有一个流体进出口，经过配流盘与机体的配流通道及缸套的流体通道相通。
Three types of mufflers for fluid-filled pipes are designed to minimize noise radiation from the pipe outlet. An experimental pipe system is built and the performances of the mufflers are tested.
设计了三种水管路消声器，建立了一套水管路模拟实验系统，对所设计的消声器消减管口辐射躁声的性能进行了实验测试。
The smaller the distance between the porous plug and outlet, the stronger the influence of argon bubbling on the fluid flow characteristics is.
吹气位置越靠近中间包水口侧对流体特征参数的改变效果更佳；
The smaller the distance between the porous plug and outlet, the stronger the influence of argon bubbling on the fluid flow characteristics is.
吹气位置越靠近中间包水口侧对流体特征参数的改变效果更佳；
应用推荐