The fluid drop shape gives any outfit a hint of romance. Why not combine it with the matching earrings?
而线条流丽的水滴形坠饰,则为装扮注入浪漫气息。
It should prevent excessive doses, fluid drop too fast and too long in intravenous treatment, and intensive care in the course of medication.
应防止剂量过大,静脉滴速过快和疗程过长,同时在用药过程应中加强监护。
The Fluid Flow factors contained herein are calculated values. They are therefore approximations and cannot be used for highly critical flow or pressure drop calculations.
这里的液流系数是预测值。因此这些数据只是大致的数据,不能用作高流量临界值或压降估计值。
The focus of the research on the two phase flow, gas and non-Newtonian fluid in horizontal pipelines, is pressure drop, the law of liquid adhesiveness and the prediction of flow form.
水平管中气体和非牛顿液体两相流动研究的中心问题是压降和持液率的规律,以及流动型态的预测。
Swing-type check off er the least pressure drop and offer simple automatic closure; when fluid flow stops gravity and flow reversal closes valve.
旋启式止回阀压降最小,能够完全自动关闭,即在介质流动停止、重力和介质倒流的状态下自动关闭阀门。
The results of experimental investigation on heat transfer and fluid pressure drop of spirally fluted titanium-tubes for steam condensation are reported and analyzed.
摘要介绍了钛螺纹槽管传热及流动阻力的实验结果,并对结果进行了分析。
The laying position and well blowout pressure are analyzed and discussed briefly and the relationship curve of drill bit pressure drop vs flowrate and fluid density i.
对其安放位置及井喷压力进行了简要分析和探讨,建立了钻头压降与流量、流体密度的关系曲线。
Additional flow rate (AFR) method can overcome this problem beautifully by inject a kind of light and thin fluid into choke line to drop its pressure loss.
附加流速法通过向节流管线内注入轻质的附加流体降低了节流管线的压降,可以很好的解决上述的压井难题。
The results have shown that diameter, gas fraction and fluid viscosity have slight impact on flow rate of this boosting system, but have remarkable influence on pressure drop of this system.
研究结果表明,管径、含气率以及流体粘度对管泵系统的流量影响不大,而对压力降则有显著影响。
When no fluid is flowing through the pipe, the initial response is due to an ambient temperature drop and the valve begins to open.
当没有液体流经管路时,起初的反应是由于周围的温降和阀门打开时产生的。
The results of experimental investigation on heat transfer and fluid pressure drop of spirally fluted titanium-tubes for steam condensation are reported and analyzed.
介绍了钛螺纹槽管传热及流动阻力的实验结果,并对结果进行了分析。
The velocity is calculated from the drop in fluid pressure as the fluid accelerates through a restriction.
当流体加速通过扼流圈时,流体压力下降,由此可以计算出流体速度。
The maximum pressure drop and the operational pressure drop were investigated in a rectangular spouted bed with double nozzles by using air as spouting fluid.
在双喷嘴矩形喷动床内,以空气为喷动气体,研究了最大喷动压降与操作压降的变化规律和影响因素。
An indented profile creating a larger annular area causes the fluid flow rate to drop and allows debris to drop into a basket or receptacle located at the base of the tool.
具有较大环形面积的凹纹型面使流体流量下降,并使碎片落入位于工具底部的篮或接受器内。
This paper discusses fluid mechanics performance of packed tower with baffle, describes cases of experiment and presents computational equation for pressure drop drop and flooding velocity.
本文对带折流板式填料塔的流体力学性能进行了探讨,介绍了实验情况,提出了压降和泛点气速的计算式。
Designed for spraying heavy bodied fluids such as roof coatings, block fillers, and similar materials, the Model 7e2 has extra large fluid passages in a plated drop-forged brass head.
专为诸如屋顶喷涂涂料,填料重块体的液体,和类似的材料,示范7e2多了一个大型的镀落伪造的铜头流体通道。
Basing on the conception of local drag coefficient in the pipeline field, the pressure drop coefficient of fluid in each inclined flue under different condition of pressed brick was calculated.
借鉴管路计算中局部阻力系数的概念,进一步计算了斜道区不同压砖情况下的压力损失系数。
Pressure drop of working fluid in LHP is calculated and analyzed.
文章对 LHP内工质的流动压力降进行了分析和计算 ;
According to the flowing conditions of the fluid in rotator, the factors causing the pressure drop due to the frictional and centrifugal forces are analyzed.
根据流体在管道中的流动状况,分析了阻力压降损失和离心压降损失。
The corresponding static bed height of the biggest spout fluid operating range and the relation between bed pressure drop and spout fluid velocity were determined.
测定了不同物料最大操作区所对应的静床高及喷动流化气速与床层压降、床层空隙率分布的关系。
The corresponding static bed height of the biggest spout fluid operating range and the relation between bed pressure drop and spout fluid velocity were determined.
测定了不同物料最大操作区所对应的静床高及喷动流化气速与床层压降、床层空隙率分布的关系。
应用推荐