After you've written all the data, you close the file and reopen it for reading, again using the binary mode flag.
在写完所有数据之后，关闭文件并重新打开文件进行读取，还是使用二进制模式标记。
The error status of the function is captured and tested, but this example ignores a feature of send in non-blocking mode (enabled by the MSG_DONTWAIT flag).
函数的错误状态被捕获并测试，但这个例子忽略了send在无阻塞模式(由msg_dontwait标志启用)下的一个特性。
Okay, so if that is the case, what does the @Transactional annotation do in Listing 6 when the read-only flag is set and the propagation mode is set to REQUIRED?
如果是这样的话，清单6 中的 @Transactional注释在设置了只读标志且传播模式被设置为REQUIRED时，它的作用是什么呢？
But in this case, you must specify that you want to write to the file by using the 'w' mode flag.
但是，在这情况下，必须用'w '模式标记指定要写入文件。
The following excerpt illustrates the handling of the invocation flag "-s" to run the script in silent mode.
下列摘录说明了在安静模式下运用所调用标志“- s ”来运行脚本。
To change a trusted broker back to standard mode, use the -n flag on the mqsichangeproperties command.
把可信代理改为标准方式的方法是在mqsichangeproperties命令中使用- n标志。
The Connector.open method also accepts the access mode (values READ, WRITE, and READ_WRITE), and a flag to indicate that the caller wants a timeout notification.
open方法还可以接受访问模式(值为READ、WRITE和READ _ WRITE)以及一个用来表示调用者想要得到超时通知的标志。
Use this flag in cases where you know that parallel execution of the query will result in speedup, but PLINQ in the Default mode would execute it as sequential.
如果认为并行执行查询将带来加速，则使用此标志，但处于默认模式的PLINQ将按顺序执行它。
With these data structures, code modules, and system registers initialized, the processor can be switched to protected mode by loading control register CR0 with a value that sets the PE flag (bit 0).
当设置好这些数据结构，代码段以及系统寄存器之后，可以通过设置控制寄存器CR0的PE位(第0位)为1来进入保护模式。
With these data structures, code modules, and system registers initialized, the processor can be switched to protected mode by loading control register CR0 with a value that sets the PE flag (bit 0).
当设置好这些数据结构，代码段以及系统寄存器之后，可以通过设置控制寄存器CR0的PE位(第0位)为1来进入保护模式。
应用推荐