And the idea was for a system with a finite number of - states. The idea was so let's say, the way we had it before, there was one state with energy zero.
这是对有有限状态数的系统的想法，想法是，那么比方说，我们之前采取的方法，有一个状态对应的能量为零。
No region of a positive, finite volume of matter goes into zero or infinite volume .
物质的任何一部分正的、有限的体积都不会变成零或无穷大。
The resulting controller is a finite impulse response (FIR) filter and hence problem of non-minimum phase zero cancellation is avoided.
这种控制器给出了避免非最小相位过程零极点对消的有限脉冲响应滤波器。
The concept of the finite time sliding mode is introduced in which the advantage is that the linear dynamics tend to zero in finite time.
引入了有限时间滑动模态的概念，其优点是线性部分的状态在有限时间内趋近于零。
We will use the relevant hydrodynamics model and the state equations at finite densities to investigate the QGP phase transition in the zero temperature and finite density.
本文采用相对论流体力学模型和有限密度下的状态方程，考察在另一种情形，即在零温有限密度下q GP相变的演化图像，并对结果进行了分析和讨论。
The confinement behavior at finite temperatures is also investigated and shown that color confinement at zero temperature can be melted away at high temperature.
最后利用有限温度场论，讨论了在高温度下夸克禁闭解除的可能性，并计算出了禁闭解除的可能的转变温度。
It turns out that both of the infrared divergence at the zero and finite temperature can be cancelled by the identical Feynman diagram of virtual processes.
结果表明零温场论中的红外发散和由温度效应引起的红外发散可以用描写虚过程的费曼图同时消除。
Nonlinear rheological models of thick and zero-thickness structural planes are presented. And incremental expressions of finite element for simulating creep of the structural planes are derived.
提出了有厚度和无厚度地质缺陷的非线性蠕变模型，推导了模拟上述地质缺陷蠕变的有限元增量表达式。
In this paper, the way of constructing the common shot-point synthetic seismogram and the zero-offset synthetic seismogram by finite element method was examined.
本文对用有限单元法制作共炮点合成地震记录和零炮检距合成地震记录的方法进行了研究。
This paper mainly describes the amplitude and phase errors caused by zero-order holder and the error caused by finite word length of D/A, and computer simulation test of D/A error is also introuced.
针对零阶保持器引起的幅度误差和相位误差，以及D/A转换器有限字长引起的误差进行了较为详细的分析，并进行了D/A误差仿真试验。
According to the initial state stress and the finite element model, the fabrication length of the cables, bars and beams at zero state can be determined.
根据结构的初始状态及其计算模型，即可确定零状态梁的加工位形以及索和杆的下料长度。
Using the finite element method, with a special algorithm by treating the contact areas as zero-aperture elements, numerical simulations of fluid flow in joints were conducted.
考虑节理面上的接触领域的非透水性，用有限元法对节理中的渗流进行数值模拟。
The stress intensity factors of finite superconductors are calculated in the process of zero-field cooling (ZFC) and field cooling (FC).
在磁化系数不变的情形下，超导体尺度越短，应力强度因子越大；
The stress intensity factors of finite superconductors are calculated in the process of zero-field cooling (ZFC) and field cooling (FC).
在磁化系数不变的情形下，超导体尺度越短，应力强度因子越大；
应用推荐