The final forging process was determined as two passes roll forging and one step finish forging process.
通过模拟研究，确定该转向节的成形方案为：二道次辊锻制坯加一步终锻成形。
By analyzing a typical example, this article gives a method of determining the weight of cutting stock during finish forging gear blank.
通过一个典型实例的分析，给出了确定精锻齿坯下料重量的方法。
There is a shedder on the upper die of the new type of finish forging die so that pattern draft Angle of half axle of forging is small oversize for machining is little.
新型精压模的上模设有顶件装置锻件半轴的拔模斜度小锻件半轴的金属敷料少。
There is a shedder on the upper die of the new type of finish forging die, so that pattern draft Angle of half axle of forging is small, oversize for machining is little.
新型精压模的上模设有顶件装置，锻件半轴的拔模斜度小，锻件半轴的金属敷料少。
In this paper a simple FEM discrimination of basic filling ability of finish forging die is presentes. The principle of discrimination and experimental proof are also introduced.
提出了一种简单的终锻模充填能力的有限元判别法，介绍了判别的原理、实验验证。
Closed-die forging can produce components of greater complexity and accuracy, with a better surface finish than the more traditional methods not using closed dies.
闭式模锻能生产高度复杂和精确的零件，而且表面光洁度要比不用闭式锻模的更传统方法好。
The main failure mode of the finish hot- forging dies for Valves are the hot wear of col- lapse.
气门热精锻模具失效的主要形式是热磨损和压塌。
After original bearing ring rolling process, directly adding a finishing diameter process made the ring forging get finish.
在原有轴承套圈辗扩工序后直接增加一道整径工序，使套圈锻件得到精化。
Forging shall be free from defects like cracks, pitting, voids, excessive scales and any other flaws detriment to quality of finish part.
锻造不得有诸如裂缝、蚀损斑、气泡、过多的鳞片等任何对最终产品质量有害的缺陷存在。
The calculation of process parameters show that the forging could be fabricated once in the finish die forging with small flash.
工艺参数的计算表明，挤压毛坯可在终锻成形时一次正确成形锻件。
While forging the high-carbon chromium bearing steel by the finish forge press, there still remains the issues that the carbide network can not be crushed with the low qualification rate.
精锻机锻造高碳铬轴承钢时存在网状碳化物不易破碎、锻件合格率低的问题。
The extruding forming and finish die forging were simulated, and the simulation results show that the backward extruding blank is right and can form forgings;
对挤压制坯、开式终锻成形进行了有限元模拟。模拟结果显示，挤压毛坯能正确成形锻件；
The extruding forming and finish die forging were simulated, and the simulation results show that the backward extruding blank is right and can form forgings;
对挤压制坯、开式终锻成形进行了有限元模拟。模拟结果显示，挤压毛坯能正确成形锻件；
应用推荐