Filling head adopts anti-leakage and lifting device.
灌装闷头采用防滴漏及升降灌装装置。
The filling head is installed with anti-leakage device, to ensure no leakage.
灌装头设有真空回吸防漏装置，确保灌装不滴漏。
Product valve and filling head moving parts are protected by steam barrier. The filling chamber is sterilized by steam.
产品阀门及灌装头运动部件采用蒸汽屏障保护，灌装室采用蒸汽杀菌。
Thoroughly clean all parts exposed to material, including piston barrel, piston head, O-ring, one-way valve, filling head, feeding tank, hopper, etc. Damaged seal shall be immediately replaced.
应彻底清洗所有和物料接触的部件，包括活塞缸、活塞头、O型圈、单向阀、灌装头、料桶、料斗等，发现破裂损伤的密封应及时进行更换。
"Like this," he said, pantomiming filling a bowl with water and dumping it over his head.
“就像这样，”他一边说，一边做了个用碗舀水浇到头上的动作。
They can start with filling the IPO head position, and then build a team around this position.
他们可以从IPO一把手的职位开始，围绕他建立团队。
Results Waste rate resulting from burnt head was reduced because of usage of three-hole pinhead in the work of filling liquid medicine.
结果使用三孔针头灌注药液，使最终产品中因“焦头”而被剔除的废品率大大降低。
It is found that the alloy has a better mobility in forging process. Lack of filling occurred in the head and the edges. The main flaw is also easy to produce in these parts.
研究发现，锻压过程中合金的流动性整体较好，在锻件头部和杆部边缘处充填性稍差，主要的缺陷也易在这些部位产生。
The head of filling and sealing clip all can be stopped with high-seat and adjust easy.
灌装头、封口夹钳均可高位停车，便于调试。
This article mainly introduces an alternative to the squeegee for Via-filling processes which is called enclose-head screen-printing or Mass Imaging.
主要介绍导通孔填充制程的另一种替代方法，即用封闭头网板印刷的细节，也称封闭式整体印刷方法。
An empiric calculated formula of mold filling as a function of vacuum rate, pattern density, pouring temperature and metal static head was established through multiple regression.
通过多元线性回归建立了充型速度随真空度、模样密度、浇注温度、金属静压头变化的经验计算公式，并研究了该公式在充型过程数值模拟中的应用。
This paper presents the experimental results of the flow characteristics and head loss coefficients of gooseneck section in lock filling and emptying systems.
本文提出了船闸输水系统鹅颈管段的水流特性及阻力系数的试验结果。
A numerical simulation is presented for 3-d filling progress of engine cylinder head casting.
应用数值模拟的方法研究了发动机缸盖铸造的三维充型过程。
A numerical simulation is presented for 3-d filling progress of engine cylinder head casting.
应用数值模拟的方法研究了发动机缸盖铸造的三维充型过程。
应用推荐