The inductances of exciter are calculated by 2d FEM method.
励磁机电感参数由二维有限元法算得。
The expansion of coiler during hot strip coiling was simulated with FEM method.
利用有限元方法对带钢卷取过程中的卷筒胀径进行了详细的数值模拟。
This paper is focused on the analysis of three nozzles with different entrance shrinking Angle with FEM method.
文中运用有限元法对三种不同入口收缩角的喷嘴进行了分析。
Explain the basic theory that will be used in analyzing the continuous extrusion deformation system FEM method.
针对进行连续挤压成形系统有限元分析所需的理论基础做了说明。
The FEM method was adopted to verify the rationality of the design program. The situation results confirmed with engineering practice.
应用有限元方法来验证设计方案的合理性，模拟结果与工程实践基本吻合。
The comparison between the experimental data and the simulation results indicates the availability and effectiveness of this FEM method.
通过与他人实验数据的对比，验证了磁场有限元分析方法的可行性。
The idea of inspecting wall with different orientation at the best time is proposed after simulating the effect of the the radiation on the building by means of 3D FEM method.
用三维有限元数值模拟方法分析了太阳辐射强度对不同朝向墙面饰面层空鼓检测效果的影响，与实际检测工程相比较，提出不同朝向采取不同的最佳检测时间的方法。
By the experiments for two-layer and three-layer homogeneous media, this method is verified to be highly precise and effective comparing with FEM method and the previous NMM method.
用此方法对均匀介质、两层介质、三层介质进行了实验，并将其结果与解析法、原nmm方法和有限元方法进行了对比，验证了此方法的有效性。
A new well test model for the triangular reservoir with different boundary conditions is developed in this paper. The typical curves for the new model are calculated by the FEM method.
提出了三角形油藏在不同边界条件下的试井理论模型，并用有限元方法对问题进行了求解，得到了不同情况下的试井理论曲线。
The seepage field and stability of concrete-faced rockfill dam in Banduo Hydropower Project, when vertical joint inactivation are occurred to the face plate, are calculated by FEM method.
以班多面板堆石坝为例，用有限元方法计算了当面板缝局部失效时各种工况下的渗流场，系统分析了大坝在面板垂直缝局部失效后的稳定渗流场的规律和特点。
Measures were given to the over-long floor and the staggered floor. A joint model of shear wall by FEM method was analyzed. The result shows that the capacity can satisfy with the design.
对剪力墙平面外设环梁的节点受力情况进行了有限元分析，结果表明这种节点处理措施有足够的安全性能。
The magnetic induction intensity of fluid gap was measured without MR fluid in the damper. The nicety of magnetic FEM method was verified by comparing the results of FEM method and experiment.
通过试验，测量了该阻尼器在未装入流体的情况下流体通道间隙处的磁感应强度大小，并与有限元分析结果进行比较，结果验证了磁场有限元分析的准确性。
Reliability calculation based on response surface FEM method utilizes the FEM numerical simulation to solve the reliability problems in which the analytical performance function can not be given.
响应面有限元的可靠度计算是采用有限元数值模拟来解决功能函数不能明确表示的结构可靠度计算问题的一类方法，对于大型复杂结构的可靠度分析有重要的意义。
This dissertation successfully used cluster computing for solving large-scale linear algebraic equations problems when the finite element method (FEM) is applied in electrical prospecting.
本文成功地将机群计算应用到解决在电法勘探中使用有限元方法（FEM）时产生的大规模线性方程组问题。
By introducing the FEM, the mixed method is extended to perform finite element reliability analysis.
通过引入有限元方法，混合分析法可适用于结构可靠度问题。
Meanwhile, the author gives the FEM calculation process and partial parameter values, and introduces the method to decide the frozen soil strength.
同时给出有限元计算过程及部分参数值，并介绍了冻土强度的确定方法。
Stress of al motorcycle wheel under the service condition was analyzed with finite element method (FEM).
用有限元法对服役状态的摩托车铝合金轮毂进行了应力分析。
The transient heat transfer process of piston set-cylinder liner system in gasoline engine was researched with direct coupling finite element method (FEM).
采用直接耦合的有限元分析方法对一汽油机的活塞组—气缸套系统的瞬态传热过程进行了研究。
The numerical result of water temperature of reservoir in Longtan engineering by use of finite element method (FEM) is reliable and accurate.
通过对龙滩工程水库水温的计算结果表明，用有限元法计算水库水温有较高的精度和可靠性。
The variation finite element method (FEM) using the pseudo-potential function was presented for the simulation of transonic rotational flows.
本文运用赝势函数变分有限元方法数值模拟了绕翼型的跨音速有旋流动。
The analytical result proofed by finite element method (FEM) indicates the same results by two methods.
通过有限元法验证解析结果，两种方法所得结果吻合较好。
Thermal-structural analysis was performed for ultrasonic wire bonding(UWB) by three dimensional finite element method(FEM).
用三维有限元方法对超声波线焊进行了瞬态的热-结构分析。
The solidification process of liquid metal in the CASTEX technique was studied by FEM (finite element method).
利用有限元法研究了连续铸挤工艺中液态金属的动态凝固过程。
Compared with the analytical and experimental results, it is confirmed that the permanent magnet eddy-current brake is an effective braking method and FEM is suitable for analyzing it.
实验结果和理论分析表明永磁涡流制动是一种高效可靠的制动方法。通过与解析法和实验结果的比较，证明用有限元法分析永磁涡流制动的可行性和准确性。
This paper analyzed the effect of corroded flaw interaction on remaining strength of line pipe with the finite element (FEM) analysis method.
采用有限元数值计算方法分析了腐蚀坑交互作用对管道剩余强度的影响。
An effective vector finite element method (FEM) for analysis of 3d radiation problem is proposed.
提出了一种用于3 -D电磁辐射特性分析的快速有限元方法。
Biomechanical analysis of artificial hip prosthesis was made by nonlinear finite element method (FEM).
并采用非线性有限元方法，进行人工髋关节的生物力学分析。
The rectangular groove guide (RGG) is analyzed by the finite element method (FEM).
本文用有限元法分析了矩形槽波导。
The rectangular groove guide (RGG) is analyzed by the finite element method (FEM).
本文用有限元法分析了矩形槽波导。
应用推荐