Fast charge in respect, determined a fast charging technology named voltage-controlled energy-feedback pulse charge.
在快速充电方面，确定了一种电压控制的放电回馈型脉冲快速充电技术。
At the same time using Holzer sensors will be converted into pulse frequency motor speed feedback to the MCU, realize the speed closed-loop control, to achieve speed detection.
同时利用霍尔传感器将电机速度转换成脉冲频率反馈到单片机中，实现转速闭环控制，达到转速检测目的。
By means of pulse injection, the relation between lasing wavelength and chip temperature of distributed feedback laser (DFB-LD) has been obtained.
利用脉冲注入法测量了分布反馈激光器(DFB - LD)芯片温度与激射波长的关系。
A kind of the pulse control mode, the drive and motor closed loop, but not to the numerical control system, the feedback device, in a sense, can open loop control called the servo control.
一种采用脉冲控制方式，此种驱动器与电机闭环，但不反馈到数控系统，这种驱动器在某种程度上可称为开环控制的伺服控制。
Then based on the above analysis, we present the method of using output voltage pulse differential feedback to control chaos in the buck converter.
在此基础上提出了利用输出电压的脉冲微分反馈对这类电路系统中的混沌进行控制的方法。
The scheme accomplishes range tracking by adopting three range gate tracking to make middle gate always centered at echo pulse center through feedback circuit and deviation calculation circuit.
该方案采用三波门跟踪，通过偏差计算电路和反馈控制电路使中间波门中心始终对准目标回波脉冲中心，完成距离跟踪。
Based on given electric current and Pulse Width Modulation (PWM) controlling system, the feedback process under each braking condition is studied.
以电流给定，脉宽调制(PWM)调压调速系统为例，研究各种制动状态下的能量回馈过程。
In this paper an approach to control chaos in chemical system by using proportional pulse feedback is proposed.
提出一种利用比例脉冲反馈控制化学混沌的方法。
Nowadays, the optical pulse used in the OTDM system is often generated by the gain-switched distributed-feedback (GS-DFB) semiconductor laser, which has a large pulse width and negative chirp.
目前常采用GS-DFB半导体激光器作为OTDM系统的光脉冲源，这种脉冲源产生的光脉冲一般较宽。
A sequential algorithm for linear feedback system identification via block-pulse functions is developed. The linear system is described by a nonparametric model, impulse-response function.
本文给出了一个利用块-脉冲函数辨识线性反馈系统非参数模型——脉冲响应函数的序贯算法。
On the basis of the characteristics of pulse plasma arc welding, a feedback control system has been developed for controlling tne penetration of welds.
本文根据脉冲等离子弧焊接的特点，研制了一种反馈控制系统，用以控制焊缝的焊透质量。
Aiming at the complicated design of three-phase PWM (Pulse Width Modulation) rectifier by using nonlinear feedback method, a linear feedback approach based on inverse system method is presented.
针对三相脉宽调制(PWM)整流器控制采用非线性反馈方法使控制器设计复杂化的问题，提出一种基于逆系统方法的三相pwm整流器的反馈线性化控制方法。
The principle of the method of pulse feedback of systematic variable is explicated. On this basis, algorithm procedure of the new method is demonstrated, and its validity is theoretically proved.
阐述了系统变量脉冲反馈控制法的基本原理和新方法的算法过程，并从理论上对该方法的有效性进行了严格论证。
The structure of the electrostatic producer is expatiated, and the method with which the pulse-width modulation feedback force linearizes the electrostatic force producer is purposed.
本文阐述了静电力发生器的结构，提出并研究了用脉宽调制反馈力线性化静电力发生器的方法。
Using the feedback control technology for reference, a light path of close-loop feedback is done with the pulse laser as control signal.
借鉴反馈控制技术，由脉冲激光控制信号实现光路的闭环反馈。
An antenna was developed to radiate high power, sub nanosecond EM pulse, which consists of a high power wideband mode convertor, a wire frame TEM horn feedback set and a parabolic reflector.
研制了一种由高功率宽带模式转换结构、导电线框tem喇叭馈电结构及抛物反射面构成的天线，用其辐射高功率亚纳秒电磁脉冲。
On the pulse frequency encoding of the antennas, the thesis provided the feedback units using multi closed loop delay circuit.
在光学天线频率编码分析中，本文提出了利用多光纤环级联代替单光纤环作反馈单元实现频率编码的思想。
On the pulse frequency encoding of the antennas, the thesis provided the feedback units using multi closed loop delay circuit.
在光学天线频率编码分析中，本文提出了利用多光纤环级联代替单光纤环作反馈单元实现频率编码的思想。
应用推荐