Another important factor to consider is the geographic distribution of the user community which will also impact the average and peak load of the system.
另一个需要被考虑的重要因素是，用户社区的地理分布，这也影响着系统的平均负载和最大负载。
The easiest way to do this is to put the conversion factor in the .data section manually and load it directly in.
最简单的方法是将转换因子手动放入.data 段中，并将其直接加载到寄存器中。
The other factor here is that many users use a grid because the database cannot keep up with the load.
这里的另一个因素是，许多用户使用网格是因为数据库跟不上加载。
These tried and true forms of green generation have a high and stable “load factor”—the proportion of the notional capacity which is actually utilised.
经检验，这些绿色能源的“满载率”（实际产能占理论产能的比例）既高又稳定。
The carrier said its load factor, or percentage of seats filled, jumped 2.6 percentage points to 81.7 percent.
该公司表示其客座率上升了2.6个百分点，上升至81.7%。
And with a load factor of 82 per cent for the full year, that is 18 in every 100 seats still to fill.
他们全年的载客率为82%，那么每100个座位中仍有18个需要塞满。
The map's initial capacity is set to a maximum number of cached scripts and the load factor is 1.
map的初始容量被设为所缓存脚本的最大数量并且加载系数是1。
Apply150% rated load at rated power factor and measure the time required for the inverter protective devices to operate.
在额定功率因素上施加150%额定负荷，并测量逆变器保护装置启动所需时间。
The effect on the generator excitation magnetic field is different when the capacity and power factor of load are different, and the effect on the internal impedance voltage drop is different, too.
而不同容量的负载，以及负载的不同功率因数，对同步发电机励磁磁场的作用是不同的，对同步发电机的内部阻抗压降的作用也是不一样的。
Copies the contained elements, hash function, predicate, maximum load factor and allocator.
复制所含的元素、散列函数、谓词、最大负载因子和分配器。
The basic purpose of a shunt capacitor bank is to increase the local circuit voltage and or reprove the load power factor carried by the circuit.
并联电容器组的基本目的是要提高当地线路的电压，或提高引线路所带负荷的功率因数。
The LCC carried 5.8 million passengers in June, up 13% from the year-ago month. Load factor rose 1 point to 82%.
瑞安航空六月份载客量达到580万，同比增长13%，客座率提高了1%，达到82%。
However, with the lower load factor, engine speed is limited to the minimum speed run, part of the system for the heat is wasted, a lower utilization.
但随着负荷率的降低，发动机转速被限制在最小转速下运行，系统的一部分供热量被浪费，一次能利用率降低。
We can also see that because damping factor is a ratio that requires the load impedance to compute it must be stated against some known impedance to be meaningful.
我们还可以看到因为阻尼因子是一个比率值，而且需要负载阻抗已知才能够进行计算，所以阻尼因子必须和某一已知的阻抗同时具明才有意义。
We can also see that because damping factor is a ratio that requires the load impedance to compute, it must be stated against some known impedance to be meaningful.
我们还可以看到因为阻尼因子是一个比率值，而且需要负载阻抗已知才能够进行计算，所以阻尼因子必须和某一已知的阻抗同时具明才有意义。
The load factor for live load surcharge is the same for both vertical and horizontal load effects.
就竖向和水平荷载效应而言，活载超载的荷载系数相同。
The result indicates that the maximum of dynamical stress intensity factor arrives behind the load time and increases with the size of thick wall cylinder.
结果表明动态应力强度因子的最大值在加载时间上有滞后性现象，它的最大值随厚壁筒尺寸增加而增加。
Its efficiency was demonstrated by computing the limit load factor and the collapse state for some plane stress and plain strain problems.
通过计算平面应力和平面应变问题的极限荷载因子和相应的坍塌机构，验证了算法的有效性。
The main factor influencing the accuracy of load forecasting is the uncertainty of original data.
影响负荷预测准确性的最主要因素是原始数据的不确定性。
This device is superior to those energy-saving devices controlled by power factor of by load and speed.
本装置优越于按功率因数控制的或按负荷及速度控制的节能装置。
This paper explained in brief the relation of three-phase asynchronous motor among efficiency, power factor, load rate and power and every power saving measures.
本文简述了三相异步电动机运行中的效率、功率因数、负载率和功率的关系及各种节电措施。
The results show that the dynamic stability analysis can be replaced by quasi-static method with the static load multiplying an amplification factor in calculation.
结果表明：在实际计算中，可以将静载乘以某一“放大系数”作为计算荷载进行拟静力分析。
In addition to these, the influence of area ratio, negative overlap, compressive factor and load inertia on system behavior are also analysed.
此外还对面积比、负重叠量、压缩性因数、负载惯量等对系统的影响进行了分析。
In addition to these, the influence of area ratio, negative overlap, compressive factor and load inertia on system behaviors are also analysed.
此外还对面积比、负重叠量、压缩性因数、负载惯量等对系统的影响作了分析。
The result shows that the rate of pressure rise and the heat release are the main dynamic load factor that affects the combustion noise.
研究结果表明：气体动力载荷因素中，压力升高率和放热率是影响燃烧噪声的重要因素。
Automatic compensation load reactive power, enhancing the load power factor.
自动补偿负荷无功功率，提高负荷功率因数。
Especially for the load factor, interference margin analysis, this article gives the situation of different cell load uplink budget.
特别是对负荷因子、干扰余量进行了分析，给出了不同小区负荷情况的上行链路预算举例。
Especially for the load factor, interference margin analysis, this article gives the situation of different cell load uplink budget.
特别是对负荷因子、干扰余量进行了分析，给出了不同小区负荷情况的上行链路预算举例。
应用推荐