• It is a key factor for large cross section box culvert to form good slurry sleeves.

    形成良好泥浆断面涵顺利顶进施工关键

    youdao

  • RCS (radar Cross Section) is a key factor in designing stealth weapons, so the research of radar targets scattering characteristics has become the foundation of stealth technologies.

    雷达散射截面(RCS)隐身装备外形设计一项重要指标研究雷达目标电磁散射特性成为目标隐身设计和目标识别的基础

    youdao

  • The position of the least square center for a cross section in the absolute coordinate system is an important factor that affects cylindrical form errors.

    截面最小二乘圆心绝对坐标系位置影响圆柱度形状误差大小的重要因素

    youdao

  • The factor that affect the well lane stability has primarily: Round the rock kind, well lane position, tunnel stalk line direction, cross section size, break rock method etc.

    影响井巷稳定性因素主要围岩性质、井巷位置巷道轴线方向断面尺寸方法

    youdao

  • Influence of each factor on blade inlet flow of a large vertical axial-flow pump is analyzed, formation mechanism of flow field in the cross section is studied.

    分析因素大型立式轴流泵叶片进口影响研究断面形成机理

    youdao

  • It is revealed that the roughness factor, slope of the canal bed, cross section of the canal and sediment sizes are the important factors which influence the sediment transport capacity of the canal.

    渠道率、比降断面形状、来组成引水流量影响引黄渠道能力主要因素

    youdao

  • Graph plotting part consists of histogram, cross section drawing, clustering spectral pattern, 2-dimensinoal factor scattergram.

    图形绘制包括:直方图因子平面散点聚类谱系图、剖面图

    youdao

  • The spoiling is a key factor influencing the advance speed for the shaft excavation, especially for the excavation of large cross section and deep shaft.

    对于竖井开挖尤其是断面竖井开挖 ,出环节 ,往往决定掘进速度快慢关键因素

    youdao

  • The swell factor tends to decrease if the cross section of die crown is large, the die round R is small, the runner is large, the dumping temperature is high and the extrusion speed is low;

    口型的冠部截面、口型圆角R、流胶口大,排胶温度挤出速度,则膨胀因数小;

    youdao

  • The swell factor tends to decrease if the cross section of die crown is large, the die round R is small, the runner is large, the dumping temperature is high and the extrusion speed is low;

    口型的冠部截面、口型圆角R、流胶口大,排胶温度挤出速度,则膨胀因数小;

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定