First, the surface temperature of the hinge must exceed the glass transition temperature of the material, which is the point at which the material begins to soften.
第一，折痕表面温度必须超过材料向玻璃过度的温度点，即材料开始变柔软的温度点。
Spend 25% Less Than you make - When your material needs meet or exceed your income, you're sabotaging your ability to really make it big.
花的比挣的少25%——当你的物质需求达到或超过你的收入时，你实际上是在破坏你真正实现成功的能力。
When your material needs meet or exceed your income, you're sabotaging your ability to really make it big.
当你的物质需求达到或超过你的收入时，你实际上是在破坏你真正实现成功的能力。
In the use of organic insulation when the moisture content of the insulation layer shall not exceed 5%, the use of inorganic insulation material moisture content should not exceed 20%.
在采用有机保温时保温层的含水率不得超过5%，采用无机保温材料时产品含水率不得超过20%。
The radioelement content of certain material is higher, when its intensity and radiation dosage exceed certain limit, can cause a harm to human body.
某些材料的放射性元素含量较高，其强度和辐射剂量超过一定限度时，就会对人体造成危害。
Under shock load conditions the peak load can exceed the ultimate bending strength of the core material and fracture occurs, usually at the most highly stressed cross section area.
在冲击负荷下，最大负荷超过了轧辊芯部材料所能承受的最大抗弯曲负荷，发生截面断裂。断裂一般产生于负荷应力为最大的截面。
All holes, slots, edges and corners should be free of loose burrs and slivers. The allowable height of a burr cannot exceed five percent (5%) of the material thickness.
所有孔，缝，边和角必须没有毛刺和锐边。允许的毛刺的高度不能超过材料厚度的5%。
Fast ion conductors (sometimes are named solid electrolyte) are a kind of solid material which ion conductivity can near or exceed liquid electrolyte.
快离子导体(有时又称固体电解质)是指离子电导率接近有时甚至超过盐溶液和电解质溶液的一类固态材料。
The value of stress under air pressure test shall not exceed 80% of the yield point of the material in test temperature;
气体压力试验时的应力值，不得超过试验温度下材料屈服点的80%。
The value of stress under hydraulic pressure test shall not exceed 90% of the yield point of the material in test temperature;
液体压力试验时的应力值，不得超过试验温度下材料屈服点的90%；
Slicing test should be done as AWWA C210-97(5.2.3). If only the material length sliced is not exceed 3.2mm, the test can be regarded as qualified.
应该按照AWWAC210-97（5.2.3）的要求进行刀削测试。只要刀削掉的材料最大长度不超过3.2毫米时，测试就合格。
The total storage time for the reconstituted material must not exceed 8 hours when exposed to normal indoor lighting.
重新配制材料暴露于正常室内光线时的总存放时间禁止超过8个小时。
In PET molding to the material should be back to full drying and not producing biodegradable, the amount should not exceed 20%.
在PET成型时加入的回料应是充分烘干和没有产生降解的，加入量应不超过20%。
The good characteristic of polyurethane material makes the polyurethane sieve plate evidently exceed the rubber sieve plate in the application and processing.
由于聚氨酯材料优良的特性使得聚氨酯筛板在应用与加工方面明显优于橡胶筛板。
High local loads at leading edges, cobbles or doubling of the strip end (tail end pinching), exceed the shear strength of the shell material and initiate the crack.
过大的局部超负荷超过轧辊外层的抗剪切强度时则会引发裂纹。
When the cost is material, amortization should be based upon the life of the franchise (if limited); the amortization period, however, may not exceed 4 years.
当成本巨大时，摊销应以专营权的期限（如果有期限的话）为准，但摊销期限不能超过4年。
BMW plans to exceed its initial target of 4 billion of material-cost reductions by 2012 as part of a wide-ranging cost-cutting target of 6 billion.
宝马计划超额完成最初定下的在2012年削减40亿欧元材料成本的目标，这是其削减60亿欧元成本目标的一部分。
BMW plans to exceed its initial target of 4 billion of material-cost reductions by 2012 as part of a wide-ranging cost-cutting target of 6 billion.
宝马计划超额完成最初定下的在2012年削减40亿欧元材料成本的目标，这是其削减60亿欧元成本目标的一部分。
应用推荐