Applying the method of mathematical regression analysis, one regression equation was found.
用一元回归分析的方法推导出了一个回归方程。
Based on the analysis of the equation and condition, the starting current velocity formula about the pill sediment is further proved.
通过该方程与水沙条件的分析，进一步验证了散粒体泥沙起动的流速公式。
Firstly, the comparison of numerical analysis results and the small signal analysis results is given based on the coupled mode equation.
首先从耦合模方程出发，比较了数值分析结果与小信号近似分析的结果。
Based on the analysis of characteristics of explosive field formed by FAE, characteristic equation is fitted with trial data. Then the range of casualty ranking of FAE is deduced (the power range).
利用FAE静爆试验爆炸场的实测数据拟合出爆炸场特征方程，进而预估出FAE对人员毁伤的伤亡等级范围(威力圈)。
An ideal gas equation is used for quantitative analysis of gas in industrial production, then by adjusting gas temperature and pressure, it is possible to control mixing ratio of materials.
工业上用理想气体方程对气体进行定量分析，通过调节气体的温度压力来控制物料的配比。
Applying the method of mathematical regression analysis, one regression equation is given out.
用一元回归分析的方法推导出了一个回归方程。
Second-degree polynomials equation of maize(Zea Mays L. ) grain yield with both planting density and nitrogen fertilization was established by means of regression analysis.
本文从不同种植密度和施氮量对玉米籽粒产量的影响，建立了二次多项式回归方程。
Based on the analysis of geometry parameters and contact stresses of the deep groove ball bearings, the control equation of groove curvature radius has been drawn out.
在对深沟球轴承几何参数及接触应力分析的基础上，给出了沟曲率半径系数的控制方程，并对轻、中、重系列轴承的外圈沟曲率半径系数的选取进行了探讨。
Applying the method of mathematical regression analysis, one regression equation was given out.
用多元回归分析的方法推导出了一个回归方程。
Appling the method of mathematical regression analysis, one multivariate regression equation are given out.
用数学回归的方法推导出了一个多元回归方程。
The local equilibrium distribution function of lattice model evolution equation is constructed by use of multi scale analysis.
它是运用多尺度分析方法，构造出格点模型的演化方程的局部平衡分布函数。
The calculating equation of amplitude for the double eccentric driving mechanism is established by analysis.
本文通过分析，建立出双偏心机构传动振动体时的振幅计算公式。
This paper makes use of the elliptical parameter equation, present a generation algorithm of ellipse with division Angle increments, and makes error analysis.
利用椭圆的参数方程，给出了以等分角度为增量的绘椭圆的一种算法，并分析了算法的误差。
Basic equation of photoelastic stress analysis by Chen (1962) is adopted; and a cubic spline function suitable for processing of photoelastic data is derived.
文中采用陈至达(1962年)的光测应力分析基本方程，并导出适合于光弹性数据处理的三次样条函数。
The paper researches designing method of the motion rule-divisible cam mechanism , makes a detailed analysis of the mathematical equation, and builds the mathematical model of the cam mechanism .
研究了运动规律分段式凸轮机构设计方法与流程，对凸轮机构运动的数学公式进行了详细的分析和推导，建立了凸轮机构。
The optional polynomial order is selected through the test of the partial fitting square sum on the basis of the variance analysis of the fitting equation.
对拟合方程进行方差分析并在此基础上利用偏拟合平方和的检验确定拟合多项式的最佳阶数。
By using mechanical analysis, the dynamic equation of the system was established, the Lyapunov direct method was applied to obtain stability conditions of system equilibrium points.
通过力学分析，建立了离心调速器系统的动力学方程，应用李雅普·诺夫直接方法得到该系统稳定平衡点的条件。
While there is the analysis of node tolerance with parameter equation on approaching along a straight line with equal step.
同时，对具有参数方程形式表示的非圆曲线进行了等间距直线逼近的节点误差分析。
The error of regression equation should be analyzed when using regression analysis method.
回归分析时，应对回归方程的误差进行分析。
Based on the theoretical analysis, the general buckling equation of semi-rigid frame column is deduced.
通过理论分析，推导了具有半刚性连接框架柱的一般屈曲方程。
Basing on analysis of TCP flow control stochastic differential equation model, this paper presents a new method to analysis queue fluctuation.
本文在分析TCP流量控制微分方程模型的基础上，提出一种新的队列波动分析方法。
This paper set up limit equation of reliability analysis for factor of safety method in the stability analysis method of slope.
本文针对土坡稳定分析方法中的安全系数法建立了可靠度分析的极限方程。
On the basis of non linear finite element method, fundamental equation and solution of pneumatic membrane structure finite element analysis are put forward.
以非线性有限元法为基础，提出充气薄膜结构有限元分析的基本方程及解法。
The paper researches designing method of the motion rule-divisible CAM mechanism, makes a detailed analysis of the mathematical equation, and builds the mathematical model of the CAM mechanism.
研究了运动规律分段式凸轮机构设计方法与流程，对凸轮机构运动的数学公式进行了详细的分析和推导，建立了凸轮机构的数学模型。
Appling the method of mathematical regression analysis, one regression equation are given out.
用数学回归的方法推导出了一个回归方程。
The dynamic characteristics of atmospheric transport equation of air pollutants are analyzed by the scale analysis in this paper.
文中用量纲分析方法分析了控制大气污染物输送方程的动力学特性。
Analyzed the stress-strain relation of pile and soil by the stress ratio, deduced the vertical deformation and harmony equation, introduced the analysis means of deformation and stabilization.
并以桩土应力比为纽带分析桩与桩间土体中应力应变的关系，确定桩体复合地基的竖向变形协调方程，介绍了复合地基的变形与稳定性分析方法。
Based on P-R equation of state and M-H81 equation of state with high accuracy, detailed calculation and analysis were made by utilizing residual function method.
利用精确度高的P - R状态方程和M -H81状态方程，采用余函数法对制冷剂的比定压热容进行了理论推算和比较分析。
Based on P-R equation of state and M-H81 equation of state with high accuracy, detailed calculation and analysis were made by utilizing residual function method.
利用精确度高的P - R状态方程和M -H81状态方程，采用余函数法对制冷剂的比定压热容进行了理论推算和比较分析。
应用推荐