The dynamic distortion data of a engine compressor inlet flow are studied with inlet shield.
对某型发动机压气机进口档板动态畸变流场数据进行了研究。
INLET GUIDE VANES, a fixed set of blades in front of an engine compressor for directing airflow to the compressor.
进口导向叶片，发动机压气机前的一组固定叶片，用以引导气流进人压气机。
The 6th stage blade in aero-engine compressor is taken as an example, the temperature effect on the blade vibration frequency blade is investigated.
以某型航空发动机压气机第六级叶片为例，研究了温度对叶片振动频率的影响。
A method that is applied to track rotor position in aero - engine by using the hall sensor to achieve the tracking the position for a certain aero -engine compressor rotor parts is introduced.
本文介绍了一种应用于航空发动机上的转子位置跟踪方法，即采用霍尔传感器完成压气机转子部件的位置跟踪。
Based on this understanding and the practice from third generation engines, this paper suggests a procedure to run engine compressor stall margin acceptance test after production and overhaul.
基于这种认识，参照第三代发动机的使用实践，提出了批生产试车和翻修后发动机试车的失速边界的验收方法。
On Demon, the air is produced from a separately powered compressor, but in a production aircraft it could be drawn from the engine.
在“恶魔”无人机上，空气来自一个单独驱动的压缩机，但在正式生产的机型上，空气可以由发动机导出。
ACCESSORY gearbox, a part of the engine, mechanically driven by a compressor or an Angle gearbox, for driving components necessary for engine and aircraft.
附件齿轮箱，发动机的一部份，由压气机或伞齿轮箱带动，用来驱动一些发动机和飞机工作必须的部件。
Unlike a conventional jet engine that uses a rotating compressor to compress air into the engine for combustion , this one has no moving parts.
传统的喷气式引擎利用旋转压气机将空气压缩进入引擎来燃烧，而这架飞机却完全没有运动的部分。
On the basic of former engine, the angle variable partial program of the fan and compressor guide vane of engine mathematical model is been renewed.
在原发动机模型的基础上，补充编制了发动机数学模型的风扇和压气机导叶角度可调的部分程序；
It should be noted that the rate of gas engine heat pump is limited regulation, and can not be any regulation, which is the work of the engine and compressor characteristics.
需要指出的是，燃气机热泵的速度调节是有限制的，并不能任意调节，这与发动机和压缩机的工作特性有关。
Different machines are usually composed of several limited common structures, for example, the main structures of gas engine, compressor and punch etc are crank-slider structures.
不同的机器往往由有限的几种常用机构组成，如内燃机、压缩机和冲床等的主体机构都是曲柄滑块机构。
DIFFUSER, a part of an engine between the compressor and combustion chamber for reducing the airflow speed and increasing the air pressure.
扩散器，发动机内压气机和燃烧室间的一个部件，用来降低空气流速并增高空气压力。
DIFFUSER, a part of an engine between the compressor and combustion chamber for reducing the airflow speed and increasing the air pressure.
扩压器，发动机内压气机和燃烧室间的一个部件，用来降低空气流速并增高空气压力。
The aircraft engines are the primary source of compressed air in flight. The air is bled from the 7th or 10th stage of the engine High Pressure (HP) compressor.
飞行中，发动机是主要的气源。空气由发动机高压压气机第7级或第10级引出。
This would not demand a serious redesign because every car already has a makeshift air compressor in the form of the engine itself.
这种车的重新设计不需要大费周折，因为每一辆汽车本来都有一台可以代用的空压机，位于发动机本身内部。
The air compressor and the air pressure at the harm of oil and car used fake petrol engine oil to the same consequences, the harm of air compressor not small.
空压机使用了冒伪劣空压机油的危害与汽车使用了假冒伪劣的汽油机油一样的后果，对空压机的危害不小。
For improve thrust loading and decrease fuel consume of the engine, propulsive system of the future demand the compressor in possession of higher pressure ratio and more efficiency.
未来飞机推进系统要求压气机的压比和效率均大大高于目前的使用水平，以提高发动机推重比，减小燃油消耗。
ACCESSORY gearbox, a part of the engine, mechanically driven by a compressor or an Angle gearbox, for driving components necessary for engine and airplane operations.
附件齿轮箱，发动机的一部份，由压气机或伞齿轮箱带动，用来驱动一些使发动机和飞机工作的部件。
Check, maintain and clean the diesel-engine generator sets, compressor, oil and water supply equipment, etc. and keep them in work condition.
检查、维保和清洁柴油发电机组、压缩机、供水供油设备，保证其良好的工作状况。
This paper introduces the parameter estimation research for the turbine inlet temperature and compressor exit pressure by using the engine variables measured under the different flight conditions.
本文研究利用不同飞行状态下测量的发动机变量估计涡轮进口温度和压气机出口压力。
In this paper, virtual prototype technology of turbo-machinery, multistage axial flow compressor numerical simulation, and integrated design of turbo-machinery and engine have been introduced.
介绍了叶轮机虚拟样机技术、多级轴流压气机数值仿真和叶轮机与发动机一体化设计。
Single lip teflon seal, low friction, suitable for windmill, pump, compressor, gearbox, engine bearing and other applications.
适于风车、泵、压缩机、齿轮箱、引擎曲轴箱等各种应用。
A model of a gas engine driven air to water heat pump based on the measured data of the gas engine and compressor was established.
以某发动机和压缩机的实测数据为依据，对一燃气机驱动空气-水热泵机组建立了模型。
Many off-design condition phenomena of a turbojet engine are related with the variation of incidence angles at front and rear compressor stages.
涡轮喷气发动机非设计状态下的许多现象都与共同工作时压气机前后各级攻角的变化有关。
The main shaft between the air compressor and the gas turbine in a jet aircraft engine is hollow to permit an internal speed reduction shaft with the minimum requirement of space and weight.
在喷气式飞机发动机内位于空气压缩和燃气涡轮之间的主轴是空心的，允许有一个需要最小空间和重量的内部减速轴。
The main shaft between the air compressor and the gas turbine in a jet aircraft engine is hollow to permit an internal speed reduction shaft with the minimum requirement of space and weight.
在喷气式飞机发动机内位于空气压缩和燃气涡轮之间的主轴是空心的，允许有一个需要最小空间和重量的内部减速轴。
应用推荐