This paper introduces rapidly controlling principle on electron beam current for electron beam welder (EBW).
介绍了电子束焊机用电子束流快速控制原理。
The high-current electron beam in the over-mode waveguide had driven the many kinds of microwave modes, it is very significant to study the high power microwave by measuring the microwave mode.
强流电子束在过模波导中可能激励多种微波模式，测量微波模式对研究高功率微波产生的机理很有意义。
The recombination activity of grain boundaries (GBs) in casting multicrystalline silicon (mc-Si) was investigated through an electron beam induced current (EBIC) technique.
本文利用电子束诱生电流（EBIC）对铸造多晶硅中晶界的复合特性进行了研究。
An online beam spot diagnostic system for high current, short pulse electron beam based on Cerenkov radiation is introduced.
介绍了一套基于切伦科夫辐射的用于强流短脉冲电子束束斑实时测量的装置。
The high speed microscope photography has been used to study on the back-ejecta of tantalum target in DRAGON ONE impacted by high intensity current pulse electron beam.
用高速显微摄影技术对强流脉冲电子束轰击钽金属靶的过程进行了研究，获得了“神龙一号”加速器上靶材回喷过程的实验图像。
The methods are simple and reliable. These calorimeters have been used for our intense current pulse electron beam accelerators. The results are satisfactory.
本方法简单、方便、可靠，在强流脉冲电子束加速器上进行了测量，得到满意的结果。
And the formulas of electron beam to wave interaction power, frequency shift, starting current and etc. are derived. Then some discussions and analyses are carried out in detail.
推出了电子注与波的互作用功率、频偏和起振电流等公式，并进行了详细的讨论和分析。
Thee-beam peak current is 7A measured behind a 6mm diameter e-beam window. The pulse duration (FWHM) is 6-8ns and the maximum electron energy is about 107keV.
在直径为6毫米的电子枪窗口后测得电子束峰值电流为7安，脉冲的半峰宽为6～8毫微秒，最大电子能量约为107千电子伏特。
The rapid surface alloying of AISI 316L stainless steel by high current pulsed electron beam(HCPEB) was investigated.
利用强流脉冲电子束对不锈钢表面进行了快速钛合金化。
Finally, inward-emitting coaxial diode was used as an example to validate the simulation of current-voltage correlation and characteristics of electron beam movement.
以向内发射同轴二极管为例从其电流电压关系及电子束运动特性方面验证了模拟的正确性。
This paper describes the development and testing of a multistage gas switch used in a high-current pulsed electron beam accelerator.
本文叙述了一个为1MV强流脉冲电子束加速器配置的主开关。多级气体开关的设计和实验结果。
Surface treatment of titanium alloy has been carried out by using pulsed electron beam with low energy and high current.
采用低能高束流脉冲电子束表面改性设备对钛合金进行表面处理。
The influence of high current pulsed electron beam (HCPEB) treatment on the corrosion resistance of magnesium alloys AZ91HP was investigated in this paper.
研究了强流脉冲电子束表面处理对镁合金AZ91HP腐蚀性能的影响。
The precept of DC-SC photoinjector is to combine a DC photocathode electron gun and the superconducting cavity together. This scheme is specially adequate to provide the high average beam current.
DC SC超导光阴极注入器将直流光阴极电子枪和超导加速腔结合在一起，其特点之一是适合于提供高平均流强电子束。
The emission of repetition rate and intense current electron beam has different character with single pulse emission, and it has different request to the cathode.
与单脉冲工作的二极管相比，重复频率运行的强流电子束二极管具有不同的特点，对阴极也有不同的要求。
The emission of repetition rate and intense current electron beam has different character with single pulse emission, and it has different request to the cathode.
与单脉冲工作的二极管相比，重复频率运行的强流电子束二极管具有不同的特点，对阴极也有不同的要求。
应用推荐