Higher fastness can be achieved if the drying temperature is raised for printing.
印花时如提高烘干温度可以实现更高的牢度。
Results it showed that drying quality is mainly influenced by drying temperature and drying time.
结果干燥温度和干燥时间是影响干燥品质的主要因素。
Effect of drying temperature, spinning temperature, cooling and shaping condition on spinning are discussed.
讨论了干燥温度、纺丝温度、冷却成形条件等对纺丝的影响。
The higher the drying temperature is, the faster they dehydrate and the drying time decreases significantly.
而干燥温度对干燥特性的影响比较显著，随着温度的升高，失水速率增大较快，干燥时间明显减少。
Drying temperature was one of the most important factors that affect the properties of edible wheat gluten films.
干燥温度是影响可食性小麦面筋蛋白膜性能的一个重要因素。
Drying temperature was one of the most important factors that would affect the properties of edible wheat gluten films.
干燥温度是影响谷朊粉可食性膜性能的一个重要因素。
The study results showed that peeling, washing and drying temperature had effects on starch purity and starch paste viscosity.
研究结果表明：削皮、水洗和干燥温度影响淀粉白度、纯度和淀粉糊化粘度。
The MVD was resulted in substantial saving of processing time, lower of drying temperature, and improved quality of lotus-seed.
将微波真空干燥应用于莲子干燥，能显著提高干燥速度，降低干燥温度，改善产品品质。
Intelligence: The drying temperature, material retention time and flow bed depth can be intelligently controlled by a computer.
智能化烘干温度、物料在机内停留时间和料层厚度均可由电脑智能化控制。
Notes: Parameters above for reference only. Drying capacity depends on material features, drying temperature and some other factors.
说明：以上参数仅供参考，干燥强度与物料特性、使用温度等因素有关。
The condensing temperature attached no remarkable influence on the content of indirubin but condensing volume and drying temperature did.
浓缩温度对靛玉红含量没有显著影响，但浓缩体积和干燥温度对靛玉红含量有显著影响。
Where the drying temperature is indicated by a single value rather than a range, drying is carried out at the prescribed temperature +/-2?
如果干燥温度为单值，而不是一个范围，则在指定温度+/-2?。
Where the drying temperature is indicated by a single value rather than a range, drying is carried out at the prescribed temperature +/- 2?
如果干燥温度给定的是一个值而不是一个范围，则在指定温度+/- 2?。
In the model, the influences of initial moisture, balance moisture, drying temperature, medium pressure, and medium humidity were considered.
该模型能够同时反映粮食初始水分、平衡水分、干燥温度、介质压力、介质湿度等对干燥过程的影响规律。
Different drying temperature had no effect on starch whiteness, however purity had a slight increase with the heightening of drying temperature.
不同干燥温度对淀粉白度无影响，但纯度随干燥温度的增加而稍稍增加。
By this experiment it is found that the first starting ability of battery was reduced progressively with the increasing of plates drying temperature.
通过试验，得出了随温度的提高，电池首次起动性能逐步降低。
The experiment on the influence of drying temperature of the dry charged positive plates after formation on the starting ability of battery was conducted.
本文主要对干荷正极板化成后的干燥温度对电池起动性能的影响进行了探讨性的试验。
Computer control can be precisely set the time and drying temperature dryer, computer controller with touch-button design, flexible and reliable operation.
电脑控制可精确设定烘干机时间和烘干温度，电脑控制器采用轻触式按键设计，操作灵活可靠。
Control system: lighting switch, spray paint, spray paint of temperature, drying temperature and time setting, emergency stop, limit the warm, failure alarm.
采用优质电子元件组装，主回路设有多重保护；照明开关、喷漆、升温喷漆、烤漆温度、时间设定、故障指示灯。
The results showed that the solvent content in the polyamide film decreased with rising of drying temperature and the initial solvent content, and decreases of film thickness.
结果表明，随着干燥温度的升高、溶剂初始含量的升高、液膜厚度的减少，溶剂含量下降加快。
A optimum processing method of fresh radix asparagi produced in Hunan province was optimized by different boiling time, drying temperature, drying method and processing method.
采用不同煮烫时间、干燥温度、干燥方法、处理方法加工湘产鲜天冬，并对产品质量进行综合评价。
The effect of surface active agent, supercritical drying temperature, pressure and holding time, calcination temperature and holding time on the properties of powders are studied.
研究了位阻剂、超临界流体干燥处理工艺和晶化温度对粉末性能的影响。
The influence of sludge type, sludge moisture content, drying method and thermal drying temperature on sludge adhering quantity during thermal drying was investigated through experiment.
通过试验考察了污泥种类、含水率、干燥方式及热干燥温度等因素对污泥热干燥过程中粘壁量的影响。
The optimum extracting and drying technology of the UHMWPE gel fiber including the optimum extracting time, extracting bath ratio, drying temperature and drying time were studied and determined.
探索并确定了冻胶纤维的最佳萃取和干燥工艺，包括最佳萃取时间、最佳萃取浴比、干燥温度和干燥时间等。
The higher the drying temperature and the smaller the particles of sludge, the shorter time be needed to dry to a certain moisture content and the higher drying rate in constant rate drying stage.
干燥温度越高、污泥颗粒越小，干燥至一定的含水率所需的干燥时间越短，恒速干燥阶段的干燥速率越高。
The influences of initial solvent content, drying temperature and polyamide film thickness on the solvent content in the film were investigated using a drying device in our laboratory in this paper.
采用实验室的液膜干燥装置，考察了液膜干燥过程中溶剂初始含量、干燥温度、液膜厚度对溶剂含量的影响。
For this reason, a vacuum dryer is especially suited to drying a heat-sensitive material that degrades above a given temperature and would otherwise require a lengthy drying cycle.
基于这个原因，真空干燥机是一个特别适合干燥热敏感材料，降低上述给定的温度，否则将需要一个漫长的干燥周期。
For this reason, a vacuum dryer is especially suited to drying a heat-sensitive material that degrades above a given temperature and would otherwise require a lengthy drying cycle.
基于这个原因，真空干燥机是一个特别适合干燥热敏感材料，降低上述给定的温度，否则将需要一个漫长的干燥周期。
应用推荐