The subcircuits consist of the low noise amplifier, RF filter, mixer, driver amplifier, image filter, power amplifier, transmit-receive switch and if filter and so on.
子电路包括低噪声放大器、射频滤波器、混频器、驱动放大器、功率放大器、中频滤波器等。
They could also be served as a driver amplifier because of its good dynamic range and linearity and could be associated with another one to build up a wideband high power amplifier.
由于其具有良好的动态和线性特性，可以把此类宽带功放作为推动功率放大器使用，同后级功放一起构成宽带、高增益、高功率放大器。
Purpose: TV vertical output, audio output driver and general purpose amplifier applications.
用途：用于电视场输出，音频放大驱动级及一般放大。
The override action occurs when a slight pull toward the driver on the switch lever providers high beam headlights regardless of the amount of light on the sensor-amplifier.
轻轻朝着驾驶员的方向拉动开关控制杆这一动作，就可以使前照灯远光灯泡点亮，而不用顾及灯的数量。
Driver deadtime control is a popular scheme used to prevent the occurrence of the shoot-through issue in a Class-D APA (audio power amplifier).
在D类音频功率放大器中，驱动死区时间控制是一个很流行的术语。
Designand Experiment of a driver circuit of LD, RF forward amplifier circuit and servo forward amplifier circuit for the optical disk driver are discussed emphatically.
重点讨论光盘驱动器中ld驱动器电路、RF前置放大电路与伺服前置放大器电路的设计与实验。
A low power CMOS buffer amplifier for LCD driver is presented in this paper.
设计了一种用于LCD驱动的低功耗CMOS缓冲放大器。
Purpose: Power amplifier applications, driver stage amplifier applications.
用途：用于功率放大、驱动级放大。
Purpose: Audio frequency amplifier, driver stage amplifier applications.
用途：用于音频一般放大，驱动级放大。
And then describe the module of pre audio amplifier, triangle generator, comparator, death time control and output driver etc.
同时还详细描述了前置音频放大器，三角波产生电路、比较器，死区控制电路，输出驱动电路等子模块的设计内容。
After being encouraged by the spruce horn experience, I built a couple of monitor speakers, a guitar combo amplifier and a bass-guitar box with an ALTEC 416b driver.
在被云杉号角经验的鼓舞，我建立了一个监听音箱夫妇，吉他组合放大器和一个带有奥特416B驱动低音吉他盒。
It is consisted of temperature acquisition, temperature setting, temperature display, differential amplifier, PID control circuit, limited circuit and thermoelectric cooler (TEC) Driver.
它包括了温度采集、温度设置、温度显示、差分放大电路、PID控制电路、限幅电路、半导体制冷器(TEC)驱动电路。
This thesis does research on the key module of Q-switch driver—high efficiency Class-E power amplifier, including the design and implement of the prototype.
本文主要研究了声光Q开关驱动器的关键模块——高效率E类功率放大器，设计实现了工程样机。
A new high voltage restraint mode which is different from traditional driver is used in power amplifier.
在功放级采用了一种异于传统驱动器的新颍高压抑制方式。
Weighing in at under 2 oz, the new amplifier is able to provide a broad supply voltage range, which makes the driver capable of controlling the smaller 13mm BLDC motors to the larger 30mm motors.
不足二盎司的自重，新的放大器却能够提供了广泛的电源电压范围，从而能驱动和控制规模在13毫米到30毫米的无刷直流电动机。
To obtain the best results, theloading network is placed close to the driver instead of the amplifier.
要效果靓尽。这个网路会尽量放在单元附近，而不是放近功放。
Purpose: High voltage switching and amplifier, color TV horiz driver, chroma.
用途： 用于高压开关和放大，彩电行激励及色度信号输出。
More pressure was realized with a little hydraulic force by orthogonal force amplifier, so the complex tape handler, gear driver and high capacity motor etc.
该设计以比较小的液压力通过正交增力机构增力，实现了得到很大冲压力的目的。
More pressure was realized with a little hydraulic force by orthogonal force amplifier, so the complex tape handler, gear driver and high capacity motor etc.
该设计以比较小的液压力通过正交增力机构增力，实现了得到很大冲压力的目的。
应用推荐