This small resistance is normally measured with a DMM or a micro - ohmmeter.
这个小的电阻值通常用数字多用表或者微欧姆计来测量。
For most applications, the micro-ohmmeter or DMM is sufficient for contact resistance measurements.
对于大多数的应用来说，微欧姆计或数字多用表足以用来进行接触电阻的测量工作。
The article introduces the work principle, general failure and maintenance method on the HP-36B type DMM.
介绍HP - 36 B型数字万用表的工作原理，一般故障现象和维修方法。
It doesn't have the internal resistors (rs), as in the DMM, so all four leads must be connected to make a measurement.
与数字多用表不同，微欧姆计没有内部电阻器(RS)，所以四条引线都要连接才能进行测量。
The Deep Mixing Method (DMM) is one of the effective ways to reinforce the soft ground, which has been wildly used in China.
软土地基深层搅拌加固法是软土地基处理的有效方法之一，在深圳地区得到广泛的应用。
A typical lifetime test system includes a communication analyzer, power supplies, a handset controller, audio test instruments, and a DMM.
典型的寿命测试系统包括一台通信分析仪、电源、一个手机控制器、音频测试仪器和一台数字多用表（DMM）。
However, the traditional measuring instruments such as DSO, DMM, Logic Analyzer have only focus on a certain number of signal or electrical parameters.
然而，传统的测量仪器如示波器，万用表，逻辑分析仪等都只是针对某一些信号或者电参数的测量。
Experiments were carried out on a S1100A2 single cylinder diesel engine, with three kind of oxygenated additive-ethanol, DMM, and DMC added in to diesel oil.
在一台S1100A2型单缸柴油机上，通过在柴油中添加乙醇、甲缩醛（DMM）、碳酸二甲脂（DMC）等三种含氧添加剂，研究了在常用工况下混合燃料的含氧量对柴油机排放特性的影响。
Given these DMM characteristics, it's not possible to use a DMM to measure signals at levels close to theoretical measurement limits, as shown in Figure 1-3.
数字多用表的技术特性决定了其不可能测量接近理论极限的信号，如图1 - 3所示。
On usual DMM only can measure signal's amplitude of DC and AC from fifty to five hundred Hz, it can not measure signal's frequency or amplitude of high frequency.
数字万用表（DMM）只能测量直流和几十到几百赫兹的低频正弦信号幅度，不能测量高频信号和信号的频率。
A new approach to determining the thermomechanical parameters of forging processes is proposed based on the dissipative structure theory and the dynamic material model (DMM).
在耗散结构理论和DMM方法的基础上，提出一种确定锻造热力参数范围的方法，以获得组织和性能稳定一致的锻件。
A new approach to determining the thermomechanical parameters of forging processes is proposed based on the dissipative structure theory and the dynamic material model (DMM).
在耗散结构理论和DMM方法的基础上，提出一种确定锻造热力参数范围的方法，以获得组织和性能稳定一致的锻件。
应用推荐