The important technical and economical index of the three methods are discussed and calculated in this paper.
本文通过计算来分析各种调压方法的主要技术指标和经济指标。
The restraint of the tearing modes by the boundary controlled field is also discussed and calculated numerically.
同时也讨论和计算了边界控制场对撕裂模的抑制作用。
The resonant frequencies of the above shell under different boundary conditions are also discussed and calculated.
计算分析了不同边界条件下壳体的振动频率。
This paper introduces the structure and sorting principle of the new cap sorter with sloping hopper. The main parameters are discussed and calculated.
介绍了一种新型倾斜料斗式选盖器的结构及瓶盖定向原理，并对主要参数的确定进行了分析和计算。
Part 6 of this series discussed type mismatches in expressions and suggested that casting functions be used to guarantee that a calculated value will come through with the proper type.
本系列的第6部分讨论了表达式中的类型不匹配，并建议使用类型转换函数来保证计算结果得到正确的类型。
The calculated results, which include the stationary electron distribution and characteristic time for beams to reach the stationary distributions, are analyzed and discussed.
对计算所得的稳态电子分布函数以及达到稳态分布所需的特征时间进行了分析和讨论。
The ionization state distributions of different targets are also discussed and compared with the theoretical calculated results for a simple model.
讨论了各种靶激光等离子体的电子温度、密度及离化态分布的特点并与理论计算的结果进行了初步的比较。
This paper analysed and calculated the thermal effects on precision measurements, discussed methods for reducing and compensating thermal errors and then goes further into the model construction.
分析计算了精密测量中温度误差的影响，讨论了减少和补偿温度误差的方法，并就仪器温度误差的建模问题进行了探讨。
Three situations are analyzed, calculated and discussed according to the electric dipole's positions in the sphere.
并根据电偶极子在接地导体球壳内的位置分三种情况进行了分析、计算和讨论。
The radiated power of impurity ions varying with time and electron temperature for given the profiles of electron temperature and density is calculated, and the corresponding physics is discussed.
在给定电子温度和密度剖面下，给出了杂质离子辐射率随时间和电子温度变化的计算结果，并讨论了相关物理过程。
By the gaussian approximation and local mode-coupled theory, fused splice loss of step and parabolic index single mode elliptic core fibers have been analyzed, calculated and discussed.
采用高斯近似和局域模式耦合理论，对阶跃折射率分布和抛物线折射率分布椭圆芯单模光纤熔接接头损耗进行了分析、计算和讨论。
Based on this model, the flow structure in constant velocity section of downer was calculated, and discussed.
依据此模型对下行床恒速段流动结构进行了计算并进行了讨论。
The affects of material mechanical properties and thickness on forming ability are calculated and discussed.
计算并讨论了复合管组成材料的机械性能及厚比对胀形成形性的影响。
Post Newtonian gravity correction to the acceleration of gravity in general relativity, produced by the sun and some planets, is calculated and discussed, and is compared with Newtonian tidal force.
计算和讨论了太阳和某些行星产生的广义相对论的后牛顿重力改正，并与牛顿引潮力进行了比较。
The effects of heat conductivity and thickness of glue on laser damage threshold and heat recovery time are calculated and discussed.
计算和讨论了胶层的热传导率、厚度对激光破坏阈值及热恢复时间的影响。
As a practical example, the stress and strain of a laminated spring on the front axle of "Jie Fang" truck are calculated. Finally, the calculated results are analysed and discussed.
作为数值计算的实例，文末计算了解放牌汽车前桥迭板弹簧的应力与变形，并对计算结果作了分析和讨论。
The six-vertex model with open boundary conditions is discussed. The correlation functions for the model are calculated and expressed as some determinants.
讨论了具有开边界六顶角模型的关联函数，计算了涉及边界自发极化的边界关联函数，得到了它们的行列式表示。
The influence of degree of disorder D and contrast of high and low refractive indices to the photonic bandgap are also calculated and discussed.
论文还计算和讨论了无序度和高低折射率之差值对光子晶体带隙的影响。
Besides a comparison of the characteristic line, the normalized mean square root error, the normalized mean error, and the maximum deviation are calculated and discussed.
除了用单行数值比较法外，还计算了重组和数学模型之间的归一化均方根偏差、归一化平均偏差和最大偏差。
In this paper, the absorption of circularly polarized and the X-mode EM-wave by inhomogeneous magnetized plasmas is discussed, and the attenuations are calculated under different conditions.
本文讨论了不均匀磁化等离子体片对圆极化电磁波、异常模电磁波的吸收，计算了不同条件下衰减率。
Self-purification curves are presented, percentages and rate constants of the purification are calculated, and influence of temperature, flow rate, and turbidity on self-purification are discussed.
绘制了自净曲线，计算了自净百分率和自净速率常数，并讨论了温度、河水流速及浊度对自净作用的影响。
The influences of applied bias and interface barriers on carriers recombination and its efficiency are calculated and discussed.
计算并讨论了所加电压与界面势垒对器件的复合电流及其复合效率的影响。
In this paper, both basic structure of lubricant coating device and its working principle are discussed and the deformation of some workpieces is analysed and calculated.
对轿车铝合金轮毂模具涂敷装置的基本结构及工作原理进行了探讨，并对杆件的变形予以分析与计算。
A complex energy system with structural theory is to be discussed in detail, and the exergy cost of its unit product is calculated.
运用结构理论详细分析一个复杂的能量系统，计算结果得到组元产品的火用成本。
The effect of hydrogen on methane combustion and ignition temperature, burning rate and burnout time are discussed through analyzing the calculated results.
通过分析计算，讨论了氢气对甲烷燃烧过程及着火温度、燃烧速率、燃尽时间的影响。
The construction record controlled by digital prestress tension system and the comparison between calculated and tested values of prestressing loss in an actual project are discussed.
给出了实际工程应用中利用数字化张拉系统施工的控制过程记录，以及所测定的预应力损失值与理论计算值的对比。
The mechanism of flavonoids and Bovine Serum Albumin complete aluminium ion was discussed, and the constant of rutin complex with aluminium was calculated.
本文初步讨论了黄酮类化合物与牛血清白蛋白竞争铝离子的机制，并计算出了芦丁与铝离子的表观稳定常数。
Two kinds of methods for solving localization factor are given. As examples, localization factors of ordered and disordered periodic wave guides are respectively calculated and discussed.
采用两种求解局部化因子的计算方法，分别计算了谐和与失谐周期波导中的局部化因子，并对其进行了分析讨论。
In this paper the phase properties of real laser field are calculated and analysed. Theresults are discussed in the "quantum limit" and "classical limit" respectively.
本文首次计算了真实激光场的相位行为。我们得到了严格的结果并讨论了结果在量子极限和经典极限下的渐近性质。
By using the Zhukovsky conversion in the complex coordinate system, the electrostatic energy of a charged revolving ellipsoidal capacitor is calculated and discussed.
利用复数坐标系z上的儒可夫斯基变换，计算带电旋转椭球形电容器的静电能，并对结果进行了讨论。
应用推荐