The electrochemistry properties of materials were evaluated by CVs and charge-discharge test.
结合循环伏安与充放电测试，对材料的电化学性能进行了评估。
Localized discharge test is currently the final and most effective acceptance test in the converter site.
局部放电试验是目前换流变现场最后，也是最有效的验收试验。
This paper tries to predict the insulation ageing of power capacitor according to the pole-to-case partial discharge test.
本文试图根据电容器极对壳绝缘的局部放电试验结果，对其绝缘老化进行判断。
Its measuring and checking included battery charge, battery capacity, battery internal resistance, circulating charge and discharge test.
电池充电试验、电池容量测量、电池内阻测量、循环充放电寿命试验。
According to the theory of robustness, this paper takes a robustness processing in air gap discharge test data when the up-down method is employed.
通过引入稳健性理论，对升降法空气间隙放电试验数据进行了稳健性处理。
The system can run reliably and effectively to prevent the power accident caused by the discharge, which is proved by the simulation and high-voltage discharge test.
模拟试验和高压放电试验证明了该系统能够可靠地运行，有效地防止由放电引起的电力事故的发生。
Partial discharge test have good detection effects the weak points and defects of dry insulation inductor, but the test often couldn't attain the satisfied purpose because of the interference.
局部放电试验对干式绝缘电气设备存在的弱点或缺陷具有很好的检测作用，但常常因为干扰的影响，使测试无法达到满意的效果。
Sump pits are very common in Canada and if you have one it's a good time to test its' operation and install the discharge hose outside (away from your house of course).
集水坑在加拿大非常常见。如果你家有集水坑，现在需要检查一下其运行情况，在外面装上泄水软管(当然要在你家外面喽！)
Users can set adjustable discharge power according to capability parameter and test request.
用户可根据性能参数、检测要求，设定调整放电功率。
The whole test stand is mainly made of pump stage part, intake part, discharge part and data acquisition part.
整个试验台架由泵级部分、吸入部分、排出部分和数据采集部分组成。
Therefore, the test of electrostatic discharge has already been an important item in the evaluation of the MOS device′s reliability.
因此，静电放电测试已经成为对器件可靠性评估的一个重要项目。
The connecting wire used for the PD test of HV cables was improved based on the corona discharge theory in air medium.
利用空气介质中电晕放电理论对高压电缆局部放电试验连接导线进行了改进。
This paper studies the filling characteristic of the ring shape runner system based on the Large Qrifice Discharge theory and takes the hydraulic simulation test.
本文根据大孔出流理论。对环形横浇道系统的充填特性进行了研究与水模拟试验。
Pulse corona discharge is one of the methods which producing plasma is in industrial test stage.
脉冲电晕放电是产生等离子体的方法之一，目前已达到工业性试验阶段。
Test result of dielectric strength, partial discharge and endurance property are analyzed and contrasted between solid dielectric is two film and tree film in model capacitor elements.
本文比对分析了极间介质为两层膜和三层膜的模型电容器元件的介电强度、局部放电性能以及耐久性能的试验结果。
The test results show that the repetition rate of partial discharge increases along with temperature and voltage.
实验结果表明，放电重复率随温度、电压的增加而增加。
The results of flood carrying capacity curve and discharge coefficient for camel hump weir and broad crested weir have been obtained by sectional hydraulic model test of Miaozitou sluice.
通过庙子头水电站两种堰型选择水闸断面模型试验研究，获得了宽顶堰与驼峰堰的泄流能力曲线和综合流量系数等试验成果。
Some data sheets contain electrostatic discharge or latch-up TEST results and the associated JEDEC TEST conditions.
有的数据手册还包括静电或闩锁测试结果以及对应的JEDEC测试条件。
The model test of partial discharge is carried out based on the analysis of defect in oil paper insulation of transformer.
根据对变压器油纸绝缘内部常见缺陷的分析，进行了局部放电模型试验。
Parameter test and load discharge can process at one time. It is controlled by CPU, and can automatically test three-phase voltage, current and power ETC.
参数检测和带载放电同时进行，单片机控制，可自动检测三相电压、电流、频率等参数。
It is an effective method for improving test precision that the water head loss tests of hydropower station inlet section are performed by increasing discharge or raising reservoir water level.
同时采用加大流量法和提高库水位进行进水口段的水力损失试验，对提高试验精度是一个行之有效的方法。
Plastics piping systems. Thermoplastics piping systems for soil and waste discharge. Test method for airtightness of joints.
塑料管道系统。土壤和废料排出用热塑管道系统。粘接处密封度试验方法。
In this paper, a study on the variable discharge unsteady flow pumping test data is made using a linear system method.
本文用线性系统方法研究了变流量非稳定流抽水试验资料。
The test way adopted is that the measured place is separated from the sourse of impulse voltage, in order to avoid the strong disturbance by discharge.
采取测量位置与冲击电压源分隔的测试方法，避开放电时的强烈干扰。
It is comparatively difficult to carry out partial discharge detection as an after laying test for XLPE cable lines.
对敷设后的交联聚乙烯电缆进行局部放电检测比较困难。
Integrated fire control equipment meets the requirements of GB16806-1997. The test items include Electrical transient bursts, Electrostatic discharge, and Radiated electromagnetic fields.
消防联动控制设备应符合GB16806- 1997标准的要求。检测项目有：静电放电；辐射电磁场；电快速瞬变脉冲群。
Control and indicating equipment (c. i. e) meets the requirements of GB4717-1993. The test items include Electrical transient bursts , Electrostatic discharge , and Radiated electromagnetic fields.
火灾报警控制器应符合GB4717-1993 标准的要求。检测项目有：静电放电；辐射电磁场；电快速瞬变脉冲群。
And water is used in cold test. Through changing operating conditions, throat area and back pressure, the change rule of discharge coefficient and pressure recovery factor were found.
通过大量冷态试验，在大范围变化工况、变化喉部面积及变化背压条件下，利用水对低温流量控制系统进行研究，得到了流量系数、压力恢复系数的变化规律。
The differences of the discharge processes verify the artificial pollution test results.
放电过程的差异验证了人工污秽试验的结果。
It has discharge models of constant-current. After setting parameter, it can achieve capacity test to battery and load capacity test to DC power.
恒流放电模式，参数设定后自动完成蓄电池组的容量测试或直流电源的带载能力检测。
应用推荐