For immediate response to inputs, try decreasing the dimensional shift parameters to 10 or less and a total deviation parameter of 10 or less.
要立即响应输入，请尝试将空间移位参数减少到10或更少，并将总偏差参数减少到10或更少。
For example, to acquire a "walking" behavior, set the dimensional shift parameters to around 20 and set the deviation threshold to around 5000.
例如，要采集 “行走”行为的数据，需要将空间移位参数设为大约20，并将偏差阈值设为大约 5000。
If the dimensional shift in either direction is greater than our previously set threshold, increment the total deviation by the amount moved in both directions.
如果在任意方向上的空间移位大于我们先前设定的阈值，就按照两个方向上移动的量增加总偏差。
The selections of 150 for dimensional parameters and 4000 for the total deviation are designed to acquire the typical shaking motions of an average user.
空间参数选择150及总偏差选择4000都旨在检测一般用户的典型震动动作。
Of particular note is the deviation threshold parameter and the dimensional shift parameters.
需要特别注意的是偏差阈值参数和空间移位参数。
This repeated reinitialization of the base values will require the user to continuously exceed the dimensional shift values to increment the total deviation detected.
这样重复地重新初始化基数值要求用户持续超出空间移位值以增加检测到的总偏差。
To accurately quantify three-dimensional in vivo kinematics of fractured scaphoid in wrist flexion-extension and radial-ulnar deviation, and to provide the theoretic proofs to clinical application.
在体研究手舟骨骨折后屈-伸和桡-尺偏运动时的三维运动学变化，为临床诊治提供理论指导。
The experiment provided the deviation distribution map of the three-dimensional coordinate and proved it is a kind of practical, effective and fast calibrating technique.
实验给出了三维坐标的偏差分布图，证明这是一种实用有效快速的标定方法。
It is fit for modeling of high dimensional systems. It becomes a feasible approach to improve the modeling precision of high dimensional systems when instruments show measuring deviation.
该方法适合于高维系统建模，为改进仪表测量误差对高维系统建模精度带来的影响提供了一条可行的途径。
So this paper presents a quantitative deviation analysis of three-dimensional model method based on laser scanning.
因此，本文提出了一种基于激光扫描的三维模型定量化偏差分析方法。
Methods: the finite element model was created by using the standard edentulous jaws model; its stresses and deviation were analyzed with the three-dimensional finite element stress analysis method.
方法：以标准的无牙颌模型为原形建立无牙颌全口义齿的有限元模型，运用三维有限元应力分析。
Three-dimensional coordinate method can calculate the deviation only by measuring the 3d coordinates anywhere in the sections.
三维坐标法，只需测量隧道断面内任意位置的三维坐标即可计算其偏差。
Three-dimensional coordinate method can calculate the deviation only by measuring the 3d coordinates anywhere in the sections.
三维坐标法，只需测量隧道断面内任意位置的三维坐标即可计算其偏差。
应用推荐