Figure 4-2 illustrates the basic circuit that USES an electrometer to determine dielectric absorption.
图4 - 2说明使用静电计确定介电吸收的基本电路。
Applications for Measuring Voltage from High Resistance Sources: Capacitor dielectric absorption and electrochemical measurements.
各种高阻源电压测量的应用：电容器的介电吸收和电化学测量等。
When measured voltage changes abruptly the dielectric absorption of capacitor will cause error for first a few measurements. The formula...
文中导出了误差的计算公式，并由此决定了误差变化的时间常数。
This paper analyses the dual-ramp A to D converter error due to dielectric absorption of the integrator capacitor with a rigorous mathematical method.
本文用严格的数学方法分析了积分电容的介质吸收效应引起的双积分模数转换的误差。
In cases where this practice is unavoidable, it may take minutes or even hours in some cases for the current caused by dielectric absorption to dissipate.
在实际工作无法避免这种情况时，可能需要经过几分钟、有时甚至几个小时，介电吸收引起的电流才会消散。
To ensure low leakage current and low dielectric absorption, the feed back capacitor should be made of a suitable dielectric material such as poly styrene, polypropylene, or Teflon.
为了保证低泄漏电流和低介电吸收，反馈电容器应当由合适的介电材料(如聚苯乙烯、聚丙烯或聚四氟乙烯)制成。
To minimize the effects of dielectric absorption on current measurements, avoid applying voltages greater than a few volts to insulators being used for sensitive current measurements.
为使电流测量时的电介质吸收影响减到最小，用来做对极小的电流测量的绝缘体，应避免施加大于数伏的电压。
Dielectric absorption is calculated from the residual voltage value, as described in the previous paragraph.
按照前一节介绍的方法，从剩余电压的数值就能计算出介电吸收。
Dielectric absorption is calculated from the residual voltage value, as described in the previous paragraph.
按照前一节介绍的方法，从剩余电压的数值就能计算出介电吸收。
应用推荐