Cam Type bending Machine, high speed, high efficiency, are mainly used for bending small diameter wire and thinner strip into various simple shape.
凸轮式成型机速度快，效率高，主要用于将直径较小的金属丝与厚度较薄的金属片加工成各种简单形状。
The servo system can accommodate small diameter wire or narrow strip material and can precisely control any combination of direction, speed, or distance required of the application.
这款伺服驱动器可以调节金属丝或窄金属条，也可以精确控制方向，速度或距离的任意组合。
It is pointed out that the wire rope enterprises of China have a long way to go compared with those of developed countries in aspect of large diameter wire ropes with important USES.
介绍国外钢丝绳企业现状，指出国内钢绳生产企业大直径重要用途钢丝绳与发达国家相应生产企业的多项差距。
Each wire measures between 30 and 100 microns in length and only 1 micron in diameter.
每根硅线的长度在30至100微米(micron)之间，直径仅为1微米。
Because after annealing line is very soft, corresponding to different wire diameter to use appropriate tension weight, if wire diameter small tension is big, will be the wire diameter and thin.
因为退火后的线已经很软了，对应不同的的线径要采用合适的张力重量，如果线径小张力大，就会把线径拉细了。
To compensate for annealed wire diameter necking problem.
为了补偿退火线径变细的问题。
In the field operation, can cause annealed wire diameter necked, surface scratch, red copper wire, copper wire color, copper wire oxidation and so on some phenomenon.
在现场操作中，会造成退火后线径变细、表面划伤、铜线发红、铜线变色、铜线氧化等一些现象。
The tensile strength of the mesh sheet is higher than that of the common mesh, and the diameter of the wire is not smaller than the diameter of the side wire.
加筋网片的拉伸强度高于普通网片，加筋丝直径一般不小于边丝直径。
The diameter of a thin wire was obtained by measuring the shadow in the Fresnel diffraction zone.
通过细丝后在其后菲涅耳衍射区留下阴影，测量阴影宽度可得细丝直径；
The tensile strength of the reinforced heavy six Angle net is higher than that of the common mesh, and the diameter of the wire is not smaller than the diameter of the side wire.
加筋重型六角网的拉伸强度高于普通网片，加筋丝直径一般不小于边丝直径。
You can use grips to specify compression spring diameter or wire diameter.
您可以使用掣点来指定压缩弹簧直径或线材直径。
This paper investigates the life of diamond wire and effects of process parameters on the reduction of the wire diameter, warp and surface roughness.
研究了金刚石线的寿命及各切割参数对线径减少量、翘曲度、表面粗糙度的影响。
The main factors influencing metal transfer are the component of flux, the shape of wire section, the diameter of wire, the thickness of the steel stripe, and the welding parameters.
影响熔滴过渡的主要因素是：药芯组成物、焊丝截面形状、焊丝直径和钢带厚度以及焊接工艺参数等。
Big diameter pipe can be composed of several round steel brush together, at both ends with wire tightly, within the lumen pull brush back and forth, until the metal color, reoccupy cotton brush clean.
大管径管子可由几个圆钢刷组装在一起，两端用铁丝扎紧，在管腔内来回拉刷，直至露出金属本色，再用棉纱拉刷干净。
The effects of arc voltage, welding current and heat input on the weld appearance in submerged-arc welding(SAW) of A105 steel with small diameter welding wire were experimentally researched.
主要研究A105钢小直径焊丝埋弧焊时，电弧电压、焊接电流和焊接热输入对焊缝成形的影响。
This welding technology is constituted by the combination of welding wire composition, the diameter of a wire, and current waveform.
本焊接技术由焊丝成分、焊丝直径和电流波形的组合构成。
When the breaking amount of wire in the 10 times of the wire rope diameter has surpassed 5%, you should change the wire rope.
当钢丝绳上的10倍直径长度范围内断丝根数大于总数的5%时，必须更换钢丝绳。
Welding current is transferred to the wire through the contact tip whose bore is slightly greater than the wire diameter.
焊接电流通过孔径稍大于焊丝直径的接触端传送到焊丝。
The results showed that increasing the feeding speed, the amount of Ca-Fe cored wire and the diameter of the tundish nozzle can prevent blockage.
结果表明，提高喂线速度、加大喂线量和增加水口内径可避免水口的堵塞。
Furthermore, the deposition rate increases per unit of welding current by decreasing wire diameter, and adjustment of the penetration depth is enabled by alternating current wave form and polarity.
减少焊丝直径，能提高熔敷效率，再加上使电流波形交流化，就可以调整熔深。
But for thoroughly solving the problem, the diameter of anchor hole should be enlarged further or non-binding stranded steel wire should be used.
但要从根本上解决进浆管堵塞还需增大一级锚孔孔径或改用无粘结钢绞线材料等。
This last error depends on the wire spacing and diameter.
后者引起的误差取决于导线的距离和直径。
The present study offers theoretical support for the preload and engineering application of wire race ball bearings with large diameter.
研究结果为大型钢丝滚道球轴承的预紧研究和工程应用提供了理论指导。
Based on the theory of Fraunhofer diffraction and Babinet principle, a method is proposed for dynamically measuring fine-wire diameter using laser diffraction.
基于夫琅禾费衍射理论和巴比涅互补原理，提出了利用激光衍射对细丝直径进行动态测量的方法。
Be based on measuring wire tiny diameter with laser diffraction, a method of hardware equidistance subdivision for dark string spans of diffraction fringe is presented.
在激光衍射法测量微细线径的基础上，提出用硬件插值细分的方法来确定衍射图样暗纹间距。
Using equal diameter steel wires to strand, ensuring not to skip steel wire during stranding, thickened value of core steel wire is different with different structure of strands.
用等直径钢丝组股时，为保证在捻股时不出现跳丝，中心钢丝的加大量应根据所捻制股结构的不同而不同；
A new non-contact method for dynamic measuring the diameter of wire rod is presented.
提出一种新的非接触式动态测量金属线材直径方法。
This test results show that the method of equidistance subdivision can highly improve the resolution of the image sensor and the measurement accuracy of the wire tiny diameter.
实验结果表明：采用插值细分的方法能够提高图像传感器的分辨力和细丝直径的测量精度。
This test results show that the method of equidistance subdivision can highly improve the resolution of the image sensor and the measurement accuracy of the wire tiny diameter.
实验结果表明：采用插值细分的方法能够提高图像传感器的分辨力和细丝直径的测量精度。
应用推荐