The allowable line voltage fluctuating range of the designed voltage regulator is wider, while the output voltage fluctuating range is smaller.
本调压器容许的电网电压波动范围较宽，而输出电压波动范围较小。
The ce circuit is widely favored since it can be designed for good voltage and current gains.
CE电路得到广泛的使用，因为它能获得高电压增益和高电流增益。
Now the first mains-voltage LEDs designed as direct replacements for incandescent bulbs are arriving on the market.
如今首批设计的民用电网电压的能直接替代白炽灯泡的发光二极管已陆续上市.
Intrinsically safe - Designed solely for use in intrinsically safe areas with properly approved and sized current and voltage limiting barriers.
本质安全—仅设计使用本质安全领域适当批准和大小的电压和电流限制的障碍。
Designed for properly sized and approved areas with current and voltage limiting barriers.
设计适当大小和批准的区域与电流和电压限制的障碍。
The control precision of the voltage corrector is much lower than designed.
这个电压校正器的控制精度比设计的低得多。
The contact potential or thermoelectric offset voltage is the key specification of a switch card designed for low voltage switching.
接触电势或热电效应偏移电压是设计用于低压切换的开关卡的关键技术指标。
Experiments show that the designed DC DC convertor's output voltage precision is high, the antijamming ability is strong and the adjustable performance is fast and smooth.
实验结果表明，用这种方法所研制的电动汽车DC DC变换器输出电压精度高，抗干扰能力强，调节特性快速、平稳。
The conditions of voltage between contactors and current in main circuit under different using types are analyzed in detail, then designed the control sequences with working mode AC1-AC4.
详细分析了交流接触器在不同使用条件下的闭合与分断时触点两端电压与回路电流情况，并研究了AC1～AC4工作制下的控制时序。
A specially designed cable that carries high voltage from generator to gun.
专门设计的从发生器到喷枪输送高压的电缆。
A bandgap voltage reference circuit with good stability and high accuracy is designed in this pa - per.
设计了一种具有良好稳定性和高精度的带隙基准电压源电路。
MPS700 series dc voltage constant-current power supply, is designed by using linear series MOSFET control mode of the ac input dc output power.
MPS700系列直流稳压稳流电源，是采用MOSFE T线性串联调整方式设计的交流输入直流输出电源。
Based on ADC subsystem integrated in C8051F005 chip, a new kind of data acquisition system of three-phase voltage was designed, which acted as the microcomputer.
利用C8051F005单片机作为微处理器并基于其内部集成的ADC子系统，设计一种新型三相电压数据采集系统。
The principle of the mechanical mouse is analyzed, and the telecontrol simulated mouse is designed with low voltage and micro-power.
分析了机械鼠标的原理，设计出了远距离操控计算机的低电压微功耗遥控模拟鼠标。
Voltage controller was designed by adding a pole to the PI regulator.
采用PI调节器加极点的方式，设计出电压环调节器。
According to usage request of controlled objects in high frequency box, adopt AT89C52 for the core electric circuit, designed multiplex voltage output controller.
根据高频机箱中受控对象的使用要求，采用AT 89 C52为核心电路，设计了多路电压量输出控制器。
A high accuracy band-gap reference voltage without resistor is designed.
设计了一种高准确度无电阻的带隙基准电压源。
Using the characteristic of integrated operational amplifier, an electric bridge circuit sensor without nonlinear error in its output voltage is designed.
利用集成运算放大器的特点，设计了输出电压无非线性误差的电桥电路传感器。
Repetitive control is used to reduce voltage distortion under nonlinear loads and instantaneous feedback control is designed to quicken the dynamic response process under abrupt load variation.
系统利用重复控制抑制非线性负载下的电压畸变，利用瞬时值反馈控制加快负载突变时的动态响应过程。
A new analog voltage contact-less switch circuit is designed.
设计了一种新型模拟电压可切换无触点开关电路。
High voltage low power DC-DC converter is designed for converting low voltage DC current into high voltage one.
高电压小功率DC - DC电源变换装置，是一种利用低压直流电源产生高电压的电源装置。
Based on PWM integrated chip TL494, a voltage driver is designed for MR Fluid damper.
设计基于PWM集成芯片tl 494的磁流变减震器励磁线圈的驱动电路。
The single close-loop control method of HFL inverter based on voltage feedback was designed for better performance.
控制系统采用瞬时电压单闭环控制策略，以提高高频链逆变电源的动静态特性。
Although designed primarily as fixed voltage regulators, these devices can be used with external components to obtain adjustable voltage and currents.
虽然主要作为固定电压调节器，这些器件可用于对获得可调电压和电流的外部元件。
According to the voltage compensation method, several experiment circuits of potentiometer are designed to measure the voltage and the internal resistance of the dry battery.
根据电压补偿原理，设计了自组电位差计的几种实验电路，用于测量干电池的电动势和内阻。
And the power dissipation is 0.11W (including switching loss) when supply voltage is 12V. The designed chip was taped out.
此外，芯片在12V供电电压下的稳态工作功耗仅为0.11W（包括开关损耗）。
Layout for measuring the uniformity of threshold voltage has been designed, including structures for measuring many material and process parameters. This Layout is adaptable to many process.
本文设计了一套适合多种工艺的阈值电压均匀性研究测试版图，包括多种材料参数和工艺参数测试图形。
Layout for measuring the uniformity of threshold voltage has been designed, including structures for measuring many material and process parameters. This Layout is adaptable to many process.
本文设计了一套适合多种工艺的阈值电压均匀性研究测试版图，包括多种材料参数和工艺参数测试图形。
应用推荐